DHI MOLBOX1 MPC1 RACK MOUNT KIT User Manual

Calibration Solutions for Pressure and Flow™
molbox1™/MPC1™ Rack Mount Kit
P/N 401154
INSTRUCTION SHEET
PARTS INCLUDED IN molbox1/MPC1 RACK MOUNT KIT
1 ea. 122336 molbox1/MPC1 Front Panel 4 ea. 100972-Z M4 Hex Nut
2 ea. 122337 molbox1 Rack Mount Bracket 8 ea. 100989-Z M4 X 12 PHP Screw
12 ea. 100971-Z M4 Lock Washer 1 ea. 560008 molbox1/MPC1 Rack Mount Kit
Instruction Sheet
The brackets are attached to the side panels of molbox1/MPC1 using eight (8) lock washers and eight (8) M4 X 12 PHP screws. The front panel is then attached to the brackets using four (4) lock washers and four (4) nuts.
The rack mount panel can be oriented so that the opening is on the left or right side.
Depending on the mounting position of the system, it may be necessary to remove the stationary feet on molbox1
or MPC1. The bottom panel will need to be removed to get access to the screws securing the feet. This can be accomplished by removing the four (4) screws that secure the panel. The screws that secure the bottom are located under the adjustable feet. These flaps need to be pried up to get access to the screws. The screws attaching the feet can now be removed.
Document 560008 990901
DH Instruments, Inc.
4765 East Beautiful Lane Phoenix AZ 85044-5318 USA
molbox1 and MPC1 are trademarks
of DH Instruments, Inc.
Fax 602.431.9559
dhi@dhinstruments.com
www.dhinstruments.com
Document 560008 990901
DH Instruments, Inc.
4765 East Beautiful Lane Phoenix AZ 85044-5318 USA
molbox1 and MPC1 are trademarks
of DH Instruments, Inc.
Fax 602.431.9559
dhi@dhinstruments.com
www.dhinstruments.com
Loading...