Dfi NP1-DVI DATASHEET

NP1-DVI
SDVO to DVI Daughterboard
NP1-DVI is a daughterboard that can be installed onto the SDVO connector of the NP101-
D16C motherboard. It comes equipped with a DVI-D interface for connecting an external DVI-D port. This allows connecting an external digital display device.
Specifications
Chipset
Chrontel CH7307C DVI transmitter chip
Display Features
One DVI port supports single independent
display
Able to drive a DFP display at a pixel
rate of up to 165MHz standard
Accepts one channel of RGB data over
three pairs of serial data por ts
Supports DDC1 and DDC2B+ for Plug
and Play monitors; and AppleSense monitor detection
Flat Panel LCD or Digital CRT Display
Supports DVI and DFP interfaces
Able to drive a DFP display at a pixel
rate of up to 165MHz supporting UXGA (1600x1200) display resolution
Video Output Interface
One 24-pin DVI-D port
SDVO Interface
Supports SDVO port
DVI Transmitter Features
Digital Visual Interface (DVI) transmitter up
to 165M pixels/second
DVI low jitter PLL
DVI hot plug detection
High speed SDVO (1G-2Gbps) AC-
coupled serial differential RGB inputs
Programmable power management
Fully programmable through serial port
Configuration through Intel Opcodes
Complete Windows and DOS driver
support
Boundary scan suppor t
Temperature
o
0
C to 60oC
Humidity
10% to 90%
Dimensions
4.5cm x 3.8cm (1.77” x 1.49”)
DVI-D Cable
Connect this to the DVI-D connector.
TMDS CLOCK+
TMDS CLOCK-
N. C.
TMDS DATA 0-
TMDS DATA 0+
TMDS DATA 1-
TMDS DATA 1+
N. C.
TMDS DATA 2-
TMDS DATA 2+
21
2019
DVI-D
21
Chrontel
CH7307C
2019
DVI-D
GROUND GROUND 5V GROUND HOT PLUG DETECT LOCK GROUND DDC CLOCK DDC DATA GROUND
1920
12
SDVO
5V
PLT_RST-
SDVO_DATA
SDVO_CLK
N. C. N. C. N. C. N. C.
SDVO_INIT-
SDVO_INIT+
The SDVO connector is located on the solder side of the daughterboard. Connect this to the SDVO connector that is on the NP101­D16C motherboard.
1920
GROUND GROUND SDVOB_CLK­SDVOB_CLK+ SDVOB_BLUE­SDVOB_BLUE+ SDVOB_GREEN­SDVOB_GREEN+ SDVOB_RED­SDVOB_RED+
12
SDVO
934-xxxxxx-000G
Axxx01xxx
Loading...