Dexin MWP365 Users Manual

2.4GHz Mini Wireless
Optical Mouse with
Nano Receiver

Instruction Manual

MADE IN CHINA
GE is a trademark of General Electric Company and is under

license by Jasco Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.

This Jasco product comes with a 2-year limited warranty.
Visit www.byjasco.com for warranty details. Questions?
Contact us at 1-800-654-8483 between 7:00AM—8:00PM CST.

37823
37824
37826
37827
37828
37829
37830
37831

v1 2/17

Package Contents

• 2.4GHz Wireless Mini Optical Mouse
with Nano Receiver

• 1 AA battery included

• Instruction Manual

System Requirements

• Windows

• Mac 10.6 or higher

®

7 or higher

BATTERIES MAY LEAK HARMFUL LIQUIDS
OR IGNITABLE MATERIALS OR EXPLODE
CAUSING INJURY AND PRODUCT DAMAGE.

• DO NOT MIX OLD AND NEW OR OTHER
BATTERY TYPES.

• REPLACE ALL BATTERIES AT THE
SAME TIME.

• REPLACE FULLY DISCHARGED BATTERIES
IMMEDIATELY.

• Available USB Port

Installing the Battery

1. Turn off the power switch located
on the underside of the mouse.

2. Remove the top of the mouse by
carefully prying up the top rear edge.

4. Insert the battery as shown, following
the polarity markings on the battery
compartment.

5. Replace the top of the mouse.

6. Turn on power switch.

Using the Nano Receiver

Lift carefully

to remove

top

The nano receiver must be plugged into your
computer before you can use your wireless
mouse. It is stored inside the mouse, next to
the battery compartment.

1. Remove the top of the mouse by
carefully prying up the rear edge.

2. Remove the nano receiver from its
storage slot and replace the top of
the mouse.

nano

receiver

3. Plug the nano receiver into the available
USB port on your computer.

4. Confirm mouse power switch is set to ON.
Move the mouse to confirm it is controlling
the cursor on your screen.

CAUTION

ON/OFF

switch

BATTERY

Troubleshooting

After periods of inactivity, the mouse goes into sleep mode to conserve
battery life. To wake the mouse, simply move it in any direction and it
should respond on the screen.

If the mouse is still not working...

• Confirm the power switch on the underside of the mouse is ON.

• Unplug the nano receiver from the USB Port, wait 30 seconds, then
plug the receiver back in.

• Replace the battery with a fresh 1 AA alkaline battery, making sure to
follow the polarity markings on the battery compartment.

• If you are still having problems, restart your computer and
check the mouse again.

If the mouse is still not responsive after trying these steps, please
contact our Technical Support Group at 1-800-654-8483, Monday-Friday
7:00am-8:00pm CST, or visit our website www.byjasco.com.

Two Year Limited Warranty

Jasco Products Company warrants this product to be free from manufac­turing defects for a period of two years from the original date of consumer
purchase. This warranty is limited to the repair or replacement of this
product only and does not extend to consequential or incidental damage
to other products that may be used with this unit. This warranty is in lieu
of all other warranties express or implied. Some states do not allow limita­tions on how long an implied warranty lasts or permit the exclusion or
limitation of incidental or consequential damages, so the above limitations
may not apply to you. This warranty gives you specific rights, and you may
also have other rights which vary from state to state. If unit should prove
defective within the warranty period, return prepaid with dated proof of
purchase to:

Jasco Products Company, 10 E. Memorial Rd.
Oklahoma City, OK 73114