Page 1
ITW Permatex
Devcon Brand
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924 (ChemTel)
International Emergency: +01-813-248-0585
Material Safety Data Sheet
1.PRODUCT IDENTIFICATION
Product Name: DEVCON H2 HOLD EPOXY (HARDENER)
Product Type: Epoxy hardener
This product appears in the following stock number(s):
22445
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH; TLV-TWA OSHA PEL
AMINOETHYLPIPERAZINE
140-31-8
TETA, REACTION PRODUCTS
WITH PROPYLENE OXIDE
26950-63-0
DIONYLPHENOL
84962-08-3
TRIETHANOLAMINE
102-71-6
PIPERAZINE
110-85-0
TRIETHYLENETETRAMINE
112-24-3
5-15 Not listed Not listed
5-15 Not listed Not listed
5-15 Not listed Not listed
<5 5 mg/m
3
Not listed
<5 Not listed Not listed
<5 Not listed Not listed
3. HAZARDS IDENTIFICATION
Toxicity:
Primary Routes of Entry:
Signs and Symptoms of Exposure:
Component Weight% NTP ACGIH Carcinogens IARC Carcinogen
TRIETHANOLAMINE
102-71-6
Aggravated Medical Condition:
Corrosive. Product can be absorbed through the skin and may cause nausea, headache and general
discomfort. May cause skin sensitization.
Eye and skin contact, ingestion, inhalation. Absorption through skin.
Contact causes severe skin irritation and possible burns. Repeated skin contact may cause allergic skin
reactions. Eye irritation may be severe and result in injury. Inhalation of mist or vapor can cause damage to
the upper respiratory tract and to the tissue depending on severity of exposure. Effects can range from
mild irritation of mucous membranes to severe pneumonitis and destruction of lung tissue. Ingestion can
cause very serious damage to the mucous membranes or other tissues with which contact is made.
<5 male rat-equivocal
evidence; female rat-
no evidence; male
mice-inadequate;
female mice-
inadequate
Preexisting eye, skin and respiratory disorders may be aggravated by overexposure to this product.
Group 3; Monograph 77, 2000
4. FIRST AID MEASURES
Ingestion:
Inhalation:
Skin Contact:
Eye Contact:
Do not induce vomiting. Slowly dilute with 1-2 glasses of water or milk and seek medical attention. Never
give anything by mouth to an unconscious person
Move to fresh air in case of accidental inhalation of vapours. Oxygen or artificial respiration if needed.
Seek immediate medical attention.
Take off all contaminated clothing immediately. Rinse immediately with plenty of water for at least 15
minutes. Obtain medical attention.
Flush eyes with clean water for at least 20 minutes while gently holding eyelids open, lifting upper and
lower lids.
5. FIRE FIGHTING MEASURES
Flash Point °F(C°):
>190°F (>88°C)
Page 2
5. FIRE FIGHTING MEASURES
Recommended Extinguishing Media:
Special Fire-Fighting Procedures:
Hazardous Products of Combustion:
Unusual Fire/Explosion Hazards:
Carbon dioxide, Dry chemical, Foam
Firefighters shoud wear self-contained breathing apparatus and protective clothing to prevent all skin and
eye contact
Oxides of carbon, Oxides of nitrogen, Amines, Ammonia
Irritating or toxic gases or fumes may be generated by thermal decomposition or combustion.
Lower Explosive Limit:
Upper Explosive Limit:
n/d
n/d
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Maintain good ventilation. Take up with an inert absorbent. Store in a closed waste container until disposal.
Wear appropriate protective and respiratory equipment.
7. HANDLING AND STORAGE
Storage:
Handling:
Store in a cool, dry area. Keep away from acids and oxidizers.
Avoid contact with skin and eyes. Do not inhale vapors. Wash hands before eating and smoking. Discard
contaminated leather gloves and shoes.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:
Skin:
Ventilation:
Respiratory Protection:
Safety glasses
Neoprene or nitrile gloves recommended
General; local exhaust ventilation as necessary to control any air contaminants to within their exposure
limits (or to the lowest feasible levels when limits have not been established) during the use of this product
An approved organic vapor respirator should be worn when exposures are expected to exceed the
applicable limits
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Odor:
Boiling Point:
pH:
Solubility in Water:
Specific Gravity:
VOC(Wt.%):
Vapor Pressure:
Vapor Density (Air=1):
Evaporation Rate:
Amber liquid
Ammonia
~212ºF/~100ºC
Alkaline
Slight
n/d
0
~18 mm Hg
>1
<1 (butyl acetate = 1)
10. STABILITY AND REACTIVITY
Chemical Stability:
Hazardous Polymerization:
Incompatabilities:
Conditions to Avoid:
Hazardous Products of Combustion:
Stable at normal conditions
Will not occur
Strong oxidizers, Acids, Chlorinated organic compounds, Reactive metals (e.g. Na, Ca, zinc), Materials
reactive with hydroxyl compounds, Sodium/calcium hypochlorite, Peroxides
Excessive heat.
Oxides of carbon, Oxides of nitrogen, Amines, Ammonia
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:
US EPA Waste Number:
Disposal should be made in accordance with federal, state and local regulations
NH - Not a RCRA Hazardous Waste Material
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
U.S. Department of Transportation - DOT - 49 CFR (Ground)
DOT Shipping Name:
Not regulated
Page 3
14. TRANSPORTATION INFORMATION
Hazard Class:
UN/ID Number:
IATA (Air)
Proper Shipping Name:
Class or Division:
UN/ID Number:
IMDG (Vessel)
Proper Shipping Name:
Hazard Class:
UN Number:
None
None
Not regulated
None
None
Not regulated
None
None
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313 Toxic Chemical.
None
California Proposition 65:
TSCA Inventory Status:
No California Prop 65 chemicals are known to be present at or above the No Significant Risk Level.
All components of this product are listed (or exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
Estimated NFPA Rating:
Estimated HMIS Classification:
(NFPA is a registered trademark of the National Fire Protection Association)
(HMIS is a registered trademark of the National Paint and Coatings Association)
Prepared By:
Company:
Telephone No.:
ITW Permatex 10 Columbus Blvd. Hartford, CT USA 06106
1-87-Permatex (877) 376-2839
HEALTH 2, FLAMMABILITY 2 , REACTIVITY 1
HEALTH 2, FLAMMABILITY 2, PHYSICAL HAZARD 0
Revision Date:
September 18, 2012Denise Boyd, Manager-Environmental, Health & Safety
Revision Number:
1
Page 4
ITW Permatex
Devcon Brand
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924 (ChemTel)
International Emergency: +01-813-248-0585
Material Safety Data Sheet
1.PRODUCT IDENTIFICATION
Product Name: DEVCON FLOW MIX COLD WELD EPOXY (RESIN)
Product Type: Epoxy resin
This product appears in the following stock number(s):
24445
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH; TLV-TWA OSHA PEL
EPOXY RESIN
(EPICHLOROHYDRIN, BISPHENOL
A)
25085-99-8
BISPHENOL A/EPICHLOROHYDRIN
BASED EPOXY RESIN
25068-38-6
>90 Not listed Not listed
<5 Not listed Not listed
3. HAZARDS IDENTIFICATION
Toxicity:
Primary Routes of Entry:
Signs and Symptoms of Exposure:
Component Weight% NTP ACGIH Carcinogens IARC Carcinogen
EPOXY RESIN (EPICHLOROHYDRIN, BISPHENOL A)
25085-99-8
Aggravated Medical Condition:
May cause eye, skin and respiratory irritation. May cause skin sensitization.
Eye and skin contact, ingestion, inhalation
Eyes: Exposure to liquid or vapor causes mild eye irritation. Symptoms may include burning, tearing,
redness, stinging, blurred vision and corneal injury. Skin redness. Ingestion may cause nausea and
vomiting. Repeated skin contact may cause allergic skin reactions.
>90 Bisphenol A; Group 3, Vol.
71, pg 1285; 1999
Preexisting eye, skin and respiratory disorders may be aggravated by overexposure to this product.
4. FIRST AID MEASURES
Ingestion:
Inhalation:
Skin Contact:
Eye Contact:
Do not induce vomiting. Slowly dilute with 1-2 glasses of water or milk and seek medical attention. Never
give anything by mouth to an unconscious person
Move to fresh air in case of accidental inhalation of vapours. If symptoms persist, call a physician.
Remove contaminated clothing and launder before reuse. Wash off with soap and water. If skin irritation
persists, call a physician.
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical
attention if irritation persists
5. FIRE FIGHTING MEASURES
Flash Point °F(C°):
Recommended Extinguishing Media:
Special Fire-Fighting Procedures:
Hazardous Products of Combustion:
Unusual Fire/Explosion Hazards:
>500°F (>260°C)
Dry chemical, Carbon dioxide, Foam
Firefighters shoud wear self-contained breathing apparatus and protective clothing to prevent all skin and
eye contact
Oxides of carbon, Phenolics
Closed containers may rupture or explode when exposed to extreme heat. Irritating or toxic gases or fumes
may be generated by thermal decomposition or combustion.
Lower Explosive Limit:
Upper Explosive Limit:
n/d
n/d
Page 5
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:
Maintain good ventilation. Take up with an inert absorbent. Store in a closed waste container until disposal.
Prevent from entering waterways or sewers.
7. HANDLING AND STORAGE
Storage:
Handling:
Store in a dry area below 90 degrees F. Keep container closed when not in use.
Avoid contact with skin and eyes. Avoid contact with clothing. Use in a well ventilated area. Wash hands
before eating and smoking.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:
Skin:
Ventilation:
Respiratory Protection:
Safety glasses
Neoprene or nitrile gloves recommended.
General; local exhaust ventilation as necessary to control any air contaminants to within their exposure
limits (or to the lowest feasible levels when limits have not been established) during the use of this product.
An approved organic vapor respirator should be worn when exposures are expected to exceed the
applicable limits
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:
Odor:
Boiling Point:
pH:
Solubility in Water:
Specific Gravity:
VOC(Wt.%):
Vapor Pressure:
Vapor Density (Air=1):
Evaporation Rate:
Black viscous liquid
Mild
>500°F (>260°C)
Not applicable
Negligible
1.16
0
<0.5 mm Hg
Not Determined
Not Determined
10. STABILITY AND REACTIVITY
Chemical Stability:
Hazardous Polymerization:
Incompatabilities:
Conditions to Avoid:
Hazardous Products of Combustion:
Stable at normal conditions
Will not occur
Strong oxidizers, Strong bases, Acids, Amines
Excessive heat
Oxides of carbon, Phenolics
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:
US EPA Waste Number:
Disposal should be made in accordance with federal, state and local regulations
NH - Not a RCRA Hazardous Waste Material
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
U.S. Department of Transportation - DOT - 49 CFR (Ground)
DOT Shipping Name:
Hazard Class:
UN/ID Number:
IATA (Air)
Proper Shipping Name:
Class or Division:
UN/ID Number:
IMDG (Vessel)
Proper Shipping Name:
Hazard Class:
UN Number:
Not regulated
None
None
Not regulated
None
None
Not regulated
None
None
Page 6
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313 Toxic Chemical.
None
California Proposition 65:
TSCA Inventory Status:
No California Prop 65 chemicals are known to be present at or above the No Significant Risk Level.
All components of this product are listed (or exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
Estimated NFPA Rating:
Estimated HMIS Classification:
(NFPA is a registered trademark of the National Fire Protection Association)
(HMIS is a registered trademark of the National Paint and Coatings Association)
Prepared By:
Company:
Telephone No.:
ITW Permatex 10 Columbus Blvd. Hartford, CT USA 06106
1-87-Permatex (877) 376-2839
HEALTH 2, FLAMMABILITY 1 , REACTIVITY 0
HEALTH 2, FLAMMABILITY 1, PHYSICAL HAZARD 0
Revision Date:
September 27, 2012Denise Boyd, Manager-Environmental, Health & Safety
Revision Number:
1
Loading...