Page 1
Set-Up Procedure
for
Low-Profile Wheelchair Scale
Beam Type
Model 495/4951
1. Remove all packing materials.
2. Set scale base on a flat, level surface. Slide ramp pins into T-slots on base;
drop pins into the grooves.
3. Remove 4 (1/4-20) screws from the column bracket (A1). Set aside
(to be used on steps 4 and 5).
4. Set column and beam assembly (B) on column bracket
(A1). Be sure the back of the beam is facing the scale
deck (A). Secure column and beam assembly with
4 (1/4-20)screws. Do not tighten the screws.
5. To attach handrail (C), remove 2 (3/8-16) screws from the top
of weighbridge side. Set the handrail on the weighbridge
side, align holes, reinstall 2 (3/8-16) screws and tighten.
Back of beam
B
A2
A
C
1/4-20 Screws (4)
B1
A1
A3
Page 2
6. If available, place the scale on a table or workbench, otherwise place the scale on floor.
In either case, DO NOT tilt or place scale on it’s side. Next, push bottom of the hanger (B1)
back towards the scale weighbridge (A), lift long lever and the nose iron (A2) up, slide the
hanger (B1) under the nose iron pivot (A3). After the hanger is attached, tighten the 4 (1/4-20)
screws. The scale assembly is now complete.
Hanger
A2
A3
B1
Lift Long Lever
7. Move upper and lower poise of the beam to “0” zero position.
8. Beam should balance so that the tip end of the beam is centered in a trig loop. If the beam is
not centered, adjust the zero balance screw to the right or left until the beam is in a balanced
position.
9. If the beam does not come to a balanced position, check all mechanical connections in the
scale base assembly and the column and beam assembly. Repeat step 7. The scale should
now be ready for operation.
Trig Loop
Zero Balance Screw
Back of Beam
Set Upper and Lower Poise
to “0” Position
D
E
T
E
A Division of Cardinal Scale Manufacturing Co.
P.O. Box 151, Webb City, MO 64870 USA
Ph: 417-673-4631 or 1-800-641-2008 Fax: 417-673-5001
e-mail: detecto@cardet.com
Visit our Web site at www.detecto.com
C
T
O
®
0066-M188-01 Rev E
09/05
Printed in USA
Loading...