Parallel Bed: Standard
Designed by Jeffrey Bernett,
Nicholas Dodziuk and Piotr Woronkowicz
• INSTRUCTIONS MUST BE FOLLOWED
CAREFULLY TO ENSURE PROPER ASSEMBLY.
• CLEAN CLOTH GLOVES MUST BE
WORN WHEN INSTALLING SLIPCOVERS.
• ASSEMBLY REQUIRES TWO PEOPLE.
Customer Service:
1.800.944.2233 inside the U.S.
1.203.614.0750 outside the U.S.
1 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Parallel Bed: Standard
Parts List 1/2
FOOTBOARDHEADBOARD
SIDE RAIL (x2)
CENTER RAIL
BED SLAT (x2)
HEADBOARD SLIPCOVER (NOT ILLUSTRATED)
FRAME SLIPCOVER (NOT ILLUSTRATED)
2 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Parallel Bed: Standard
Parts List 2/2
CORNER LEG BRACKET (x2)
SHORT BOLT – 1" (x18)
MEDIUM BOLT – 1.5" (x4)
EXTRA BOLTS ARE INCLUDED.
CENTER LEG
HEADBOARD LEG (x2)
WASHER (x4)
0.5" SOCKET WRENCH
SLAT CLIP (x2)
ELECTRIC DRILL WITH
0.5" SOCKET IS RECOMMENDED.
3 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Parallel Bed: Standard
1.
Attach footboard to side rails using corner legs brackets and small L brackets.
Loosely thread all bolts, then tighten down.
x10 SHORT BOLTS
2.
Connect center rail to footboard.
x2 MEDIUM BOLTS
x2 WASHERS
4 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
5 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Attach legs to headboard.3.
Parallel Bed: Standard
Loosely attach both side rails to headboard, then tighten bolts.4.
x4 SHORT BOLTS
x4 SHORT BOLTS
Parallel Bed: Standard
Screw center leg into center rail, then bolt center rail onto headboard.5.
x2 MEDIUM BOLTS
x2 WASHERS
Align seams of headboard slipcover with headboard, then pull down
6.
and secure with velcro along bottom edge.
CLEAN CLOTH GLOVES MUST
BE WORN DURING THIS STEP.
6 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Parallel Bed: Standard
Make sure slipcover is pulled tightly
all the way to headboard and covers
all parts of side rails.
7.
Use snap to align bottom-right corner of frame slipcover, then secure
with velcro starting at footboard and working up side rails to headboard.
CLEAN CLOTH GLOVES MUST
BE WORN DURING THIS STEP.
Roll out slat assemblies onto frame. Lift center and push
8.
down to ensure snug fit. Install slat clips near headboard
and footboard to secure slat system.
7 | WWW. DW R . C O M | 1. 80 0. 9 4 4 . 22 33 | DESIGN WITHIN REACH STUDIOS
Loading...