SPOT 1.0 w/ AQUASTOP
Installation instructions
2.16" - 3.07"
.....
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Pag. 1 - rev.00
WARNING!!!
Please read the following instructions carefully.
IMPORTANT:
• Although LED runs on a very low voltage, always cut off the power sup-
ply before installing the LED light or subjecting it to maintenance.
• Unauthorised alterations or tampering of the product will invalidate all
the conditions of guarantee.
This fixture must be installed by a qualified electrician.
•
Designplan is not responsible if its fixtures are not installed in
•
according to local safety standards.
Data contained in this document may be changed at any moment with-
•
out prior notice.
ELECTRICAL CONNECTIONS:
• LED lights run at constant current.
• LED lights must be connected in series respecting polarities.
As for the choice of the power supplies, please consider the current
•
through which they are fed and the max power consumption of
LEDs you have to install.
The total number of LEDs to be fed must be counted for each single
•
spot (e.g. 2 spots with 3 LEDs 1W each= 6 LEDs 1W in all= 6W).
•
The system must be fed only if all the spots are connected . The
connection of the single spots with the power supply in voltage may
damage the spot.
• The power supplies must be installed in aerated rooms, far from heat
sources. A situation of overworking or a lack of air circulation will not
permit a natural dissipation.
•
The electronic power supply is current-stable, therefore it partially compensates the voltage-drop problems related to the cable length; we
suggest not to exceed 120ft (30 metres).
• Use only Selv type electronic power supply or similar.
• Never use switches on secondary circuit.
1.063"
2.28"
.98"
Ø1.18" X 1.61"
NOTES:
Wire connections must be realized with wire nuts or
•
similar.
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
+DES IGN
SPOT 1.0 w/ AQUASTOP
Installation instructions
°
0
2
2
Series connection
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Pag. 2 - rev.00
1
2
PSU
Selv
LED LIGHTS MUST BE CONNECTED
THE SYSTEM MUST BE ENERGIZED ONLY AFTER ALL THE
POWER CONSUMPTION
SUPPLY VOLTAGE
CONNECTION Series connections Power supply not included.
N° AND TYPE OF
LED USED
AVERAGE LED LIFE 75% after 50.000 hours
LED COLOURS
AVAILABLE
CRI
TYPICAL LUMINOUS FLUX
OPERATING
TEMPERATURE
FINISHING INOX Steel AISI 316L
FIXING
APPLIANCE CLASS
WEIGHT
IN SERIES RESPECTING POLARITIES.
WARNING!!!
FIXTURES ARE CONNECTED.
1x1W; 1x2W;
350 - 500 mA
1 power LED
White: 5000K; 3000K; blue; red; green;
80
85 lm/W
-10°C ÷ +45°C
WP0100 accessory.
CLASS 2
.4 kg
3
RESPECT POLARITY
+ = RED
- = BLUE
SCOTCH self amalgamating
4
Do not cut
Ac q uas top
Ac q u a s top
Ac q u a s top
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
+DES IGN
SPOT 1.0 w/ AQUASTOP
Installation instructions
1.53"
1A 2A
1.42"
10.11"
TERRENO
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
Pag. 3 - rev.00
Non idoneo per installazioni a immersione.
Not for permanent submersion installations.
WARNINGS
INSTRUCTIONS FOR CORRECT WASTE DISPOSAL
Ac co rding t o a rt. 1 3 o f th e L eg is lat ive Dec re e d ate d 25 J uly 200 5 n. 15 1
c onc e rning CE dire c tion s on the us e an d d ispo s al o f e le ctro nic an d e le ctro nic al m ate ria ls .
The symbol of the crossed rubbish skip you find on the device or its packaging indicates
that once the product had been used, it must be collected separately from other waste
material.
As a consequence, users are supposed to bring the useless device to the differentiated
waste disposal centres of electronic and electrotechnical materials. Alternatively, you can
hand it back to the reseller when you buy a new equivalent device.
The correct differentiated waste collection in order to recycle the disused device, to treat it
and get rid of it contributes to avoid possible bad consequences on the environment and
health while it favours the re-employment of the materials the device is made of.
The illegal waste disposal of the device from its holders causes the application of the administrative sanctions foreseen by the regulations in force.
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
+DES IGN
Loading...