Desco TB-7011 User Manual

TB-7011 2/04 Page 1 of 2

Material Safety Data Sheet

Material Safety Data Sheet maybe used to comply with
EC, according to 91/155EC and ANSI Standard Z400.1-1998
Date: January 23, 2004

1
0

0

0

Flammability

(Red)

Reactivity

(Yellow)

Health

(Blue)

Special Hazard

NFPA Designation 704

Degree of Hazard
4 = Extreme 1 = Slight
3 = High 0 = Insignificant
2 = Moderate

Statfree ® Conductive Smooth Ruber- Type G2
Section I. Identification of the Product and of the Enterprise

Identity: Statfree ® Conductive Smooth Ruber - Type G2 Emergency: Phone: [phone]

Fax:[phone]

Manufacturer: Desco Industries Inc.

90 Hudson Road
Canton, MA 02021
U.S.A.

Section II. Product Information

Chemical Name: Synthetic elastomer compound, sheeted and vulcanized, to a form an article, a Rubber Mat.
CAS Registry No.: None
Chemical Family: None
Chemical Formula: None

Section III. Health Data

First Aid Measures: The product is an article and has a no significant toxic hazard. Hazardous fumes can be produced by

combustion or high temperature decomposition.

If Exposed to Fumes From Combustion:
Skin Contact: Flush skin thoroughly with cool water for at least five minutes.
Eye Contact: Immediately flush eyes with a directed stream of water for at least 15 minutes, while forcibly holding

eyelids apart to ensure complete irrigation of all eye and lid tissue. GET MEDICAL ATTENTION.

Inhalation: Remove to fresh air. If breathing is difficult, administer oxygen. If respiration stops, give mouth-to-

mouth resuscitation. GET MEDICAL ATTENTION.

NOTE TO PHYSICIAN: This material is an article and has no significant toxic hazard. Hazardous fumes (CO,CO2) are

produced by combustion and may be produced by decomposition at elevated temperature above 450°F
.
Ef

fects of Overexposure:

Acute: This material is an article and has no significant hazard. This article decomposes at high temperatures,

and can produce irritating and toxic fumes.
Chronic: No significant hazard.
Route: Fumes from high temperature decomposition are toxic when inhaled and irritating to skin and mucous

membranes.
Toxicity: This material is an article and has no significant toxic hazard.

Section IV. Fire and Explosion Hazard Data

Flash Point: About 500°F
Method: ASTM-D-1929
Flammable Limits: (In Air % by Vol.) Lower N/A* Upper N/A*
Auto Ignition Temperature: About 700°F
Extinguishing Media: Carbon Dioxide, Dry Chemical, Water.
Special Fire Fighting Procedure & Personal Protection: In case of fire, use water or other extinguishing medium appropriate for

surrounding fires. Use self-contained breathing apparatus and full protective

equipment. All fires liberate toxic gases.
Unusual Fire and Explosion Hazards: None
*Not Applicable

Section V. Ventilation

Local exhaust in vicinity of hot processing.

Respirator: (Type) None
Gloves: (Type) None
Eye Protection: (Type) None
Other Protective Equipment: None

© 2004 DESCO INDUSTRIES INC.

Employee Owned

DESCO INDUSTRIES INC. • 3651 Walnut Avenue, Chino, CA 91710 • [phone] • Fax [phone] • Web Site: http://www.descoindustries.com

DESCO INDUSTRIES INC. Technical Bulletin TB-7011

TB-7011 Page 2 of 2

© 2004 DESCO INDUSTRIES INC.

Employee Owned

DESCO INDUSTRIES INC. • 3651 Walnut Avenue, Chino, CA 91710 • [phone] • Fax [phone] • Web Site: http://www.descoindustries.com

Section VI. Physical Data

Boiling Point (760 mm Hg): N/A
Specific Gravity (H20 = 1): 1.05 - 1.50
Vapor Pressure (mm Hg 20°C): N/A
Vapor Density (Air = 1): N/A
pH: N/A
Solubility in Water (% by Wt.): Negligible
Percent Volatile: Nonvolatile
Evaporation Rate (Butyl Acetate = 1): Less than 1
Other:
Appearance and Color: Smooth rubber finish, Black.

Section VII. Hazardous Ingredients

Ingredients Presenting a Significant Hazard: This Material is an “article” under the definitions of the OSHA Hazard

Communication Standard (29 CFR 1910.1200). As such, it does not release, or
otherwise produce by exposure, a hazardous chemical under normal conditions
of use.

Threshold Limit Value, %: N/A
(See Section XII)

Section VIII. Hazardous Reactivity

Incompatibility: Nonreactive.
Hazardous Decomposition Products: CO, CO2- This article can be forced to burn by continuous application of intense

heat. The primary combustion products will be CO and CO2. Other gases will
include small amounts of aromatic and aliphatic hydrocarbons, and oxides of
nitrogen and sulfur. The major hazard is the asphyxiant carbon monoxide.

Conditions to Avoid: Keep away from heat for prolonged periods.

Section IX. Handling and Storage

Handling and Storage Precautions: Use applicable fire and safety code precautions for warehousing.

Section X. Environmental Protection

Procedure in Case of Spill or Release: N/A
Waste Disposal Method: Submit for disposal in accordance with local, Stat and Federal regulations.

Section XI. Regulatory Status

Not Classified as a hazardous waste under CRA.

Section XII. Additional Information

Always wear rubber gloves when cleaning exhaust equipment or other surfaces. If using cleaning solvents, follow their MSDS
recommendations for use.

OTHER INFORMATION

Disclaimer
The information given in this publication has been worked up to the best of the knowledge of Desco Industries Inc, as well as taking into consideration the
applicable laws and regulations. We cannot anticipate all conditions under which this information and our products or the products of the manufacturers in
combination with our products may be used. We accept no responsibility for the results obtained by the application information or the safety and suitability of
our product or product combination with other products. Users are advised to make their own tests to determine the safety and suitability of each such product
or product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers end users assume
responsibility and liability for loss or damage arising from the handling and use of our products, whether used alone or in combination with other products.

N/A = Not Applicable; NE = None Established