Desa Tech VDPL450 Owner's Manual
®
INSTALLATION INSTRUCTIONS
FOR BI-FOLD GLASS DOOR
MODELS VDGL450 AND VDPL450
USE GLASS DOORS CERTIFIED
FOR THIS APPLIANCE OR FIREPLACE ONLY.
DOOR INSTALLATION
Pivot and spring clips have been installed
and pretested at the factory, but some readjustments may be needed due to movement
during shipping or handling.
Try installing the doors using steps 1 through
3. If you find the doors do not close properly
or do not appear level or straight, proceed
with section on door adjustment.
1. With bi-fold door completely folded,
insert the bottom pivot pin into the pivot
plate located near the bottom corner of
the front face opening and swing door
to the vertical position making sure top
pins slide into door track. Door is installed when top door pin snaps into
spring clip (see Figure 1).
2. Repeat step 1 for remaining door.
DOOR ADJUSTMENT
Remove doors and slightly loosen lower
pivot clips and upper spring clips. Replace
doors and fully close them use 1/8" shims
(any material) to level doors. Once the proper
setting is achieved, carefully open doors
enough so that you can access pivot and
spring clips with a phillips screwdriver.
Tighten screws (see Figure 2).
Please read Care and Operating Guidelines
section at the end of this instruction sheet
before operating your appliance or fireplace.
Side Front
Face
Spring Clip
CARE AND OPERATING
GUIDELINES
• Glass doors should be operated in the
fully open or fully closed positions only
(see Figure 3).
• When operating doors, do not slam shut
or abuse them.
• Always keep area below bottom edge of
doors clear from obstacles or debris.
• Do not operate this appliance if glass
doors are broken or damaged.
• Do not use abrasive liquids or cleaners
for cleaning of glass and door trims. An y
household glass cleaner should suffice.
Do not clean doors when hot, allow the
appliance to cool before cleaning.
Fold Door
and Slide
Top Pins
into Track
Insert Bottom
Pivot Pin into
Pivot Plate and
Swing Door to
the Vertical
Position
Figure 1 - Bi-Fold Door Installation
Spring Clip
Insert Pin into
Spring Clip
Pivot Plate
Partially Opened Door
Figure 2 - Door Adjustment
INTERNATIONAL
2701 Industrial Drive, P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
Figure 3 - Bi-Fold Doors Fully Opened
105810 01
NOT A UPC
105810-01
55819
REV. A
04/99
Loading...