Infra-Red
Tank Top Heater
Owner’s Manual
Models
HD24B and TT24B
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;lklsuiejlb oe
;e ;;pdl;lklsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
WARNING
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl
;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
Heater Size: 8,000 – 24,000 Btu/Hr
Safety Information
Make certain you read and understand all warnings. Do not allow anyone who has not
read this manual to operate this heater. Keep this manual for reference. It is your guide
to safe and proper operation of this heater.
1. Read and understand this manual before assembling or using this heater. Improper
use of this heater can cause serious injury.
2. For outdoor use only. Do not use inside house, camper, tent, vehicle, or any type of
unvented or enclosed area.
3. Never operate heater while sleeping or unattended. Keep children and animals
away from heater.
4. This heater produces carbon monoxide, which is listed by the state of California as
a reproductive toxin under Proposition 65.
5. Minimum heater clearances from combustibles:
6. Use only in well-vented areas.
7. Use only propane gas set up for vapor withdrawal.
8. Before connecting heater to propane tank, make sure heater regulator knob is in
9. Before each use, check heater for leaks. Never use an open flame to check for a
10. Locate propane tank on a stable and level surface. The heater burners must be at
11. Do not use heater in basement or below ground level. Propane is heavier than air. If
12. Do not move or handle a hot or operating heater. Do not attach or remove a
13. Always remove heater from propane tank after each use. Always store propane
14. Keep all connections and fittings clean. Make sure propane tank valve outlet is
15. Do not attempt to light one burner off of the other. Use one match per burner.
16. Do not overlap or point burners at each other.
17. Do not raise burner heads and cover air inlet holes in mixing tube with burner
18. Wing nuts and burner heads become very hot during operation. Do not attempt to
19. Check heater for damage before each use. Do not use a damaged heater. Do not
Top and Front: 5 Ft. Sides and Rear: 3 Ft.
the “OFF” position. Always connect and light heater in areas free of open flames.
leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a
leak. Correct all leaks at once.
least two feet above the floor. Always attach heater to propane tank in an upright
position. Never operate heater on its side or attach to propane tank in a horizontal
position. This could lead to dangerous flare-ups or fire.
a leak occurs, propane gas will sink to the lowest possible level. If you smell gas or
suspect a leak, shut off the propane tank valve at once and ventilate the area. Do
not strike match or create any flame or electric spark. Find and correct leak before
attempting to light any appliance. If you cannot correct leak, do not tamper with
heater. Return heater to nearest authorized service center or to address on back
page of this manual, freight prepaid.
propane tank from a hot or operating heater. Severe burns may result.
tank outdoors. Never store propane tank in an enclosed area. Never store propane
tank near high heat, open flame, or where temperatures exceed 1000F.
clean. Check the “O” ring on the heater inlet fuel connector for damage before each
use. Replace if worn or damaged.
head bracket.
adjust burner position while heater is operating. Allow 15 minutes to cool.
alter heater. Keep heater in its original state. Do not use heater if altered.
Assembly
1. Place each burner head onto the burner bracket as shown in Figure 1. CAUTION:
The burner heads should be positioned as far down on the burner bracket as
possible. Make sure the air inlet holes in the mixing tube on the burner head
are not covered by the burner bracket
Continued
2. Insert two bolts through square holes and then through round holes in burner bracket.
3. Place two flat washers onto bolts. Thread wing nuts onto bolts.
4. Carefully thread mounting bolt into tank collar bracket on the lower portion of the post.
Connecting Heater To Propane Tank
Read and understand all safety information before connecting heater to propane tank.
1. Place heater onto tank with tank collar bracket over tank collar (see Figure 2).
Mounting bolt should be positioned to the outside of tank collar.
2. Firmly secure to tank by hand-tighten mounting bolt. Do not over-tightening
mounting bolt.
3. Make sure heater regulator knob is in the “OFF” position.
4. Wrench tighten the fuel connector nut into the propane tank valve with both gas
hose fittings in a horizontal position (see Figure 3). Turn fuel connector nut
counterclockwise to tighten. Threads are left-handed.
5. Connect both hoses to inlet connectors (see Figure 3). Tighten firmly using wrench.
Make sure both hoses are connected before opening the tank valve.
6. Open propane tank valve slowly.
7. Check all fittings for leaks. Apply a mixture of liquid soap and water to all joints.
Bubbles forming show a leak. Correct all leaks at once. WARNING: Never use an
open flame to check for a leak.
8. Always remove propane tank from heater after each use. Do not store heater while
attached to propane tank.
Burner
Wing Nut
and Washer
Mixing
Tube
Figure 1 - Attaching
Heater to Bracket
Mounting
Bolt
Tank Collar
Figure 2 - Assembling Heater
Bracket
Air Inlet
Hole
Inlet Connectors
Propane
Tank Valve
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;lklsuiejlb oe
;e ;;pdl;lklsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
WARNING
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl
;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l
Tank Collar
Bracket
Heater
Regulator
Knob
Figure 3 - Connecting
Heater to Propane Tank
Fuel
Connector
Nut
To Light Heater
Read and understand all safety information before operating heater.
1. Adjust burners to desired position by loosening wing nuts on back of burner head
bracket. WARNING: Wing nuts and burner heads become very hot during
operation. Do not attempt to adjust burner position while heater is operating.
Allow 15 minutes to cool. WARNING: Do not raise burner heads and cover air
inlet holes in mixing tube with burner bracket. Firmly tighten wing nuts to
secure burners. Do not overlap or direct burners at each other.
2. WARNING: Make sure there is no open flame in the area. Fully open the
propane tank valve.
3. Turn heater regulator knob counterclockwise to the “HI” position (see Figure 4).
4. WARNING: Stand to the side of unit while lighting. Do not stand or have any
part of your body over or in front of heater while lighting. Do not attempt to
light one burner off of the other. Use one match per burner. Locate ignition hole
in underside of burner (see Figure 5). Hold a lit match under ignition hole. CAUTION: Do not insert match into air inlet holes in mixing tube. Push in the safety
shutoff valve plunger (see Figure 5). WARNING: Do not push in safety shutoff
valve plunger before inserting lit match. Burner should light. Mesh screen on
burner glows red when lit. After burner is lit, continue holding in safety shutoff valve
plunger (about 10 to 30 seconds) until heater stays lit.
5. If the burner does not light within 30 seconds, turn regulator knob to the “OFF”
position. Wait at least two minutes for the gas to dissipate before relighting.
6. If heater will not light after repeated tries, do not attempt to repair heater. Return
heater to nearest authorized service center or to address on back panel of this
manual, freight prepaid.
Burner Front
Heater
Regulator
Knob
Safety Shutoff
Valve Plunger
Figure 4 Figure 5
Ignition Holes
Air Inlet
Hole
Back View
7. After burner lights, turn the heater regulator knob to the desired heat setting (LOW,
MED, or HI).
8. Light both burners when maximum heat is needed. Use one burner to conserve
fuel. Repeat above steps to light second burner.
To Turn Off Heater
1. Tightly close propane tank valve by turning clockwise.
2. Turn the heater regulator knob to the “OFF” position. Wait at least 15 minutes for
the heater to cool before handling heater.
3. Always remove the heater from the propane tank after each use. Do not store
heater while attached to propane tank. Always store propane tank outdoors. Never
store propane tank in an enclosed area.
Technical Service and Replacement Parts
For assistance in servicing your heater and parts under warranty, contact the Technical
Service Department at 1-800-323-5190 or visit our web site at www.desatech.com.
Parts Under Warranty: Contact authorized dealers of this product. If they can’t supply
original replacement parts, either contact your nearest authorized service center or call
DESA International’s Technical Service Department at 1-800-323-5190.
Parts Not Under Warranty: Contact authorized dealers of this product. If they can not
supply these accessories or parts, either contact your nearest Parts Central or DESA
International for referral information. Parts Centrals are listed in the Authorized Service
Center booklet supplied with heater. Call DESA International’s Parts Department at 1-800972-7879 for referral information.
Replacement Parts
Item Description Part Number Model
1 Burner Guard 100911-01 All
2 Thermocouple 100886-01 All
3 Regulator with Fuel Gas Connector LPA2025 All
4 Hose Assembly (not shown) 101807-01 All
5 Owner’s Manual (not shown) 100926-01 All
6 Operation Tag (not shown) 101860-04 HD24B
101860-06 TT24B
7 Burner Replacement Kit* (not shown) LPA5050 All
Burner Guard
Thermocouple
Regulator
* Replaces burner screens that are worn, split or broken.
Heater Information
Btu Input One Burner Two Burners
HI 12,000 Btu/Hr 24,000 Btu/Hr
MED 10,000 Btu/Hr 20,000 Btu/Hr
LOW 8,000 Btu/Hr 16,000 Btu/Hr
Length of Operation
20 lb. Propane Tank 36 hours 18 hours
Warranty Information
Propane Infra-Red Tank Top Heater
DESA International warrants this product and any parts thereof, to be free from defects in
material and workmanship for one year from the date of first purchase, provided that the
product has been properly installed, operated, and maintained in accordance with all applicable instructions. To make a claim under this warranty, the bill of sale or proof of purchase
must be presented.
This warranty is extended only to the original retail purchaser. This warranty covers only the
cost of parts required to restore this heater to proper operating condition. Warranty parts
must be obtained through authorized dealers of this product and/or DESA International who
will provide original factory replacement parts. Failure to use original factory replacement
parts voids this warranty. The heater must be used in accordance with all local codes and
instructions furnished with the unit.
This warranty does not apply to parts that are not in original condition because of normal
wear and tear, or parts that fail or become damaged as a result of misuse, accidents, lack of
proper maintenance, alteration, tampering, contaminated fuels, or defects caused by improper installation. Travel, transportation and incidental costs associated with warranty repair are not reimbursable under this warranty and are the responsibility of the owner.
TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURISDICTION THAT GOVERNS THE SALE OF THE PRODUCT : THIS EXPRESS WARRANTY EXCLUDES ANY AND
ALL OTHER EXPRESSED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE TO ONE YEAR FROM THE DATE OF FIRST PURCHASE: AND
DESA INTERNATIONAL’S LIABILITY IS HEREBY LIMITED TO THE PURCHASE PRICE
OF THE PRODUCT AND DESA INTERNA TIONAL SHALL NOT BE LIABLE FOR ANY OTHER
DAMAGES WHATSOEVER INCLUDING INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES.
Some states do not allow a limitation on how long an implied warranty lasts or an exclusion or
limitation of incidental or consequential damages, so the above limitation on implied warranties, or exclusion or limitation on damages may not apply to you.
This warranty provides the original retail p urchaser with specific legal rights. For specific
information regarding those rights, please consult the applicable state laws.
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
Limited Warranty
100926 01
NOT A UPC
100926-01
Rev. H
11/99