Desa Tech GFP28BK Owner's Manual

GFP28BK Brick Liner Kit

Installation Instructions

GFP28BK Brick Liner Kit

Installation Instructions

IMPORTANT: Read entire instruction sheet before installing brick liner.
This brick liner accessory is approved for use in the following models: GFP28MNG, GFP28MLP, GFP28TNG, and

GFP28TLP. Do not use brick liner accessory in any other fireplace models.

The Brick Liner Kit contains the following: Tools required:

• 1 - Rear Firebrick Panel • 3 - Retainer Brackets • Phillips Screwdriver

• 2 - Side Firebrick Panels • 3 - #10 Screws • 5/16" Hex Socket Wrench or Nut Driver
If any of these parts are missing or damaged, contact dealer where you purchased this kit. If they cannot supply original

replacement parts, contact Perfection-Schwank, Inc. Parts Department, 1-800-776-8459 (outside GA) or 706-554-2101.

IMPORTANT:

Always handle firebrick panels with two hands.

WARNING

WARNING ICON G 001

Turn off, unplug, and let fireplace cool before
installing brick liner. Only a qualified service
person should service and repair fireplace.

NOTICE

You must remove log base assembly before
installing brick liner.

1. To remove screen, lift screen up off the screws in front
of fireplace (see Figure 1).

CAUTION

WARNING ICON G 001

Do not pick up log base assembly by burners.
This may damage burners. Only pick up base
by the grate.

Note:

Some installations may require the gas supply line to
be disconnected before removing log assembly. If so, call a
qualified service person to disconnect gas supply from
fireplace.

WARNING

WARNING ICON G 001

A qualified service person must connect and
disconnect fireplace to gas supply. Follow all
local codes.

Screws for
Mounting
Screen

Figure 1 - Removing Fireplace Screen

2. Remove logs. Remove two screws that attach log base
assembly to fireplace. Carefully lift log base assembly
and remove from fireplace (see Figure 2).

Burners

Two Screws

Log Base
Assembly

Figure 2 - Removing Log Base Assembly from Fireplace

2