Denver SCO-80130 User Manual

User manual

SCO-80130

facebook.com/denverelectronics

Before operating this vehicle, read all the instructions for safe assembly and operations. User’s manual can guide you
through the functions and usage of Electric scooter. Before using this Electric scooter, familiarize yourself with how to
operate, so that you can keep the Electric scooter in the best condition possible.

This appliance can be used by children aged from 14 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

Version 1.0

1

Table of Contents

1 Product and Accessories

Important!

This electric scooter must be charged and stored in a safe way.

For safety reason and protect battery life, never charge the electric scooter in temperatures below 5 °C
or above 45 °C. Equally, always disconnect the electric scooter with the power cable once fully charged.
Always use the supplied power adapter to charge the electric scooter.

1. Product and Accessories

Back reflector

Rear LED light

White reflector

Display screen

Bell

Electric brake

Mechanical brake

Front LED light

Folding clasp

White reflector stickers

Front shock absorption

8.0” wheel

Left handle

Right handle

2 Unfolding and folding the scooter

Unfolding the scooter

1) Position the electric scooter on its wheels like below.

2) Push the security lock up, then pull the red unlock clasp as indicated in the arrow below.

3) Raise the handle slowly.

4) The electric scooter is unfolded as soon as you hear the rod clicks into place.

Folding the scooter

1) Push the security lock up, then pull the red unlock clasp as indicated in the arrow below.

2) Press the front tube of the electric scooter downward.

3) The rod clicks audibly into place.

3 Handle bar assembly

1) Parts inside the packaging: two handlebars

2) Change display angle: Loosen the screw on the handle bar, and rotate the axle to make

the handlebar meter screen upwards while the and display screen turn inwards in a
horizontal level. Remember to tighten screws again.

3) Before operating the electric scooter, turn the handlebar grips, and carefully check all the
components to make sure that the steering is correctly installed as described above, and that all
connecting parts are secure and fully functional.

Figure 1 Figure 2

4 Charging the scooter

Connect the supplied power adapter to the charging port of the electric scooter.

Charging port