Denver MET-100 User Manual
METAL DETECTOR
DENVER MET-100
Instruction Manual
“CAUTION: Before starting to use the metal detector please familiarize yourself with your
country’s local laws and regulations on where you’re allowed to use the metal detector
and for which findings you’re allowed to keep and for which findings you must turn in to
the authorities. Also take most care not to use the metal detector in any area which might
contain dangerous items such as explosives from a war or powercables or gaslines or
any other dangerous items.”
2
The Metal Detector is a versatile and easy-to-use metal detector. It has higher
View Metal
Control Box
Battery Cover
Red Button
Upper Leg
Lock Nut
Coil search
Knob Bolt
(Coil)
Earphone Jack
Arm Support
Handle
Knob Bolt
(Box)
Lower Leg
sensitivity and has the ability to differentiate the ferrous metals and nonferrous
metals. It is suitable for beginners.
Please read the manual carefully before using the unit.
CONTENTS
Specification
Assembly
Batteries
Panel and Controller
Quick-Start
Field Operation
Caution
Trouble Shooting Guide
Specification:
Operation Modes: One kind
●
No-motion Mode: As long as there is metal object around the search coil, the
detector will have a response.
Adjusting DISCRIMINATION
●
Adjusting TUNE
●
Adjusting VOLUME
●
Low Battery Indication
●
6.5 inch Water Proof Search Coil
●
1/8 inch Earphone Jack (earphone not supplied)
●
Batteries Six AA Batteries (not supplied)
●
Assembly
Assembly is easy and requires no special tools.
1.
Align the rounded plastic part raised on the handle, with the rounded lower groove
at the control box bottom (Figure.1). Push the two parts tightly.
3
Figure.1
2.
Align the threaded bolts at the handle bottom, with the knobs under the control
box, lock it with the bolts (Figure.2).
Figure.2
3.
Turn the stem’s lock nut clockwise until it loosens, lengthen or shorten the stem so
when you stand upright with your detector in your hand, the search coil is level
with and about 1/2 inch above the ground with your arm relaxed at your side.
(Figure.3).
Figure.3
4.
Loosen the knobs at the search coil’s end, then adjust the search coil to the desired
angle, let the search coil be parallel with the ground. Be careful not to mistake the
location of the search coil (Figure.4).
WRONG CORRECT
4
Figure.4
Batteries
Please use six AA alkaline batteries.
1.
Press the “key” on the battery compartment in the direction of the arrow, pull out
the battery compartment cover (Figure.5). Note: the UP words is engraved on the
battery compartment, don’t mistake the direction.
Figure.5
2.
Insert six pcs AA batteries into the compartment as indicated by the polarity
symbols marked inside the compartment (Figure.6).
Figure.6
3.
Close the battery compartment cover, please take care that the UP-side is up.
4.
Six alkaline batteries may be used for more than 40 hours. If you do not plan to
use the detector for a long time, remove the batteries.
5. Do not mix old and new batteries.
Panel and Controller
5
Loading...