Denver LDD-2461DVBT Instruction Manual
24” LED TV WITH DVD & MPEG2 DVBT
Model NO.: LDD-2461DVBT
Instruction Manual
Contents
Contents
Caution
Safety Information
Introduction
1. Front View
2. Rear View
3. Remote Control
Basic Operation
OSD Menu
1. PICTURE menu
2. SOUND menu
3. FUNCTION menu
4. TV menu
5. DTV menu
Media operation
2
3
4-7
4
5
6-7
8
9-19
9
10
11-12
13-14
15-17
18-19
DVD Operation
DVD Basic Operation
Disc Care
DVD System Setup
Simple Troubleshooting
20-23
20-21
21
22-23
24
1
Caution
Caution
The lightening ash with arrowhead symbol, within an equilateral triangle
is intended to alert the user to the presence of un-insulated "dangerous
voltage" within the products enclosure that may be of sufcient magnitude
to constitute a risk of electric shock to the persons.
The exclamation point within an equilateral triangle is intend to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Correct disposal of this Product
(Waste Electrical & Electronic Equipment (WEEE)
Your product is designed and manufactured with high quality materials and
components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their endof-life should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste collection/
recycling centre.
In the European Union there are separate collection systems for used
electrical and electronic products. Please help us to conserve the
environment we live in!
This unit complies with European safety and electrical interference
directives.
2
Safety Information
Safety Information
To ensure reliable and safe operation of this equipment, please read carefully all the
instructions in this user guide, especially the safety information below.
Electrical safety
• The TV set should only be connected to a mains supply which matches that stated on
the label on the mains adaptor
• To prevent overload, don't share the same mains supply socket with too many other
items of equipment.
-Do not place any connecting wires where they may be stepped on or tripped over.
-Do not place heavy items on the leads, which may damage them.
-Hold the Mains plug, not the wires, when removing from a socket.
-During a thunderstorm or while leaving the TV for long periods, disconnect the aerial (if
outdoor) and mains adaptor from the supply.
-Do not allow water or moisture to enter the TV or mains adaptor. Do NOT use in wet
or moist areas such as Bathrooms, steamy kitchens or near swimming pools.
• Pull the plug out immediately, and seek professional help if:
-the mains plug or cable is damaged
-liquid is spilt onto the set, or if it is accidentally exposed to water or moisture
-anything accidentally penetrates the ventilation slots
-the set does not work normally.
-Do NOT remove the safety covers. There are no user serviceable parts inside.
You may invalidate the warranty. Qualied personnel only are permitted to service this
apparatus.
-To avoid battery leakage, remove exhausted batteries from the remote control
handset, or when not using for along period.
-Do NOT break open or throw exhausted batteries on a re.
Physical safety
• Do NOT block ventilation slots in the back cover. You may place the TV in a cabinet, but
ensure at least 5cm (2") clearance all around the unit.
• Do NOT tap or shake the TV screen, you may damage the internal circuitry. Take good
care of the remote control, do not drop it or allow it to come into contact with liquids.
• To clean the TV use a soft dry cloth. Do NOT use solvents or petrol based uids. For
stubborn stains, you may use a damp soft cloth with diluted detergent.
3
Introduction
1. Front View
Introduction
Please insert a 12cm disc
according to the silk
1. (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Red) Standby mode
Indicator on(Null) Power on mode
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
0
to the left or right side and 200 above or below the remote control
window.
2. The functions of the buttons:
MENU : Press to display the OSD menu, press again to exit the menu.
CH+/- : Press to scan through channels.
VOL+/- : Press to adjust the volume.
INPUT:
Press to display the input source menu.
PLAY: Play / Pause the disc playing.
EJECT: Eject the disc.
POWER : Turn on/standby the TV set.
4
2. Rear View
Introduction
USB SCART
POWER: Connect to the mains adaptor.
USB: For software upgrade only.
HDMI: Connect it to the HDMI of DVD or other equipment.
VGA: For PC display.Connect it to the D-Sub 15 pins analog output connector of the PC.
PC-IN: Connect it to the audio output terminal of PC.
SCART: Connect them to the SCART video output terminal of DVD.(used in component source)
Headphone: Connect it to your headphone or other audio equipment.
Coax: Digital coaxial output.
Common Interface: CI slot.
RF: Connect antenna or cable 75 Ohm coaxial to receive TV signal.
R/L in: Connect them to the audio output terminal of DVD.(shared with YPbPr)
VIDEO: Connect it to video output terminal of DVD.
YPbPr: Connect them to the YPbPr video output terminal of DVD.(used in
component source)
Wall Mounting
The TV is provided with mounting holes for a VESA approved wall mounting bracket(NOT
SUPPLIED). Remove the Posi screws holding the base to the base bracket and lift the
base away (do not remove the base mounting bracket). Mount the VESA bracket using
4 x M4 x 10 Iso metric threaded screws (not supplied). Do not use screws longer than 10 mm,
damage will occur to the internal parts. Fit the wall bracket securely following the manufacturers
instructions.
5
Introduction
3. Remote Control
The remote control is using Infra-Red(IR). Point it towards the front of the LCD TV. The remote
control may not work correctly if it is operated out of range or out of angle.
POWER(red button): Turn the TV on/standby.
Buttons for TELETEXT operating
You could use the buttons only in TELETEXT .
TV/TXT: Turn off/on the Teletext display.
CANCEL: Cancel the Teletext display.
REVEAL: Reveal any hidden text.
HOLD: Hold or carry on the current subpage.
SIZE: Press to see top half of page double size, Press again
to see the bottom half of page double size. Press again for
normal size.
TV/AV
SUBPAGE: Press to subpage, again to cancel.
INDEX: Go to index.
Colour buttons: Short cuts-follow the coloured links in the
text.
Buttons for Basic operating
MENU: Press to display the OSD menu.
TV/AV: Display the input source menu.
CH+/-: Channel/Program +/-.
VOL+/-: Volume +/-.
DVD: Switch to DVD source.
DVD-SETUP: Press to display the DVD menu in DVD mode.
REC: Press to start record the program in DTV mode.
DVB: Switch to DVB source.
EXIT: Press to exit the OSD menu.
THUMBSTICK(
< / > / ∧ / ∨
OK): Allows you to navigate
the on-screen menus and adjust the system settings to your
preference.
Buttons for Basic function
NUMBER BUTTONS: Choose channel directly. Press number
buttons and press OK button to play the channel.
Number buttons for DVD.
Pressing “-/--”button to display “SELECT 10+”, and press
a number button to play the program.
: Return to the previous channel viewed.
PICTURE: Select the picture mode.
SOUND: Select the sound mode.
NICAM/A2: Selects Nicam or Mono sound.
MUTE: Mutes the Audio.
SLEEP: StandbyTimer
6
TV/AV
Introduction
Buttons for DVD functions
: Eject the disc.
: Play/pause DVD program.
: Stop DVD program.
: DVD fast reverse.
: DVD fast forward.
: DVD previous chapter.
: DVD next chapter.
LANGUAGE: Select DVD disc language.
ZOOM: Adjust picture size in DVD mode.
SUBTITLE: Select DVD disc subtitle.
MENU (PBC): DVD play list/Disc menu
ANGLE: Select DVD picture angle.
TITLE: DVD title.
GOTO: Play your favorite title/chapter/track.
PROGRAM: Edit the program and play.
SLOW: Play DVD programs at slow speed.
REPEAT: Repeat playing the title or chapter.
A-B: Select and play the preferable paragraph of DVD program
by pressing this key twice at the beginning and end of it.
Buttons for DTV operating
TV/RADIO: Disc menu change between DTV and Radio.
FAV: Display the favorite program list.
FAV+/-: Favorite program up/down.
PIC FORMAT: Press to change the display mode of the screen: 4:3,
16:9.etc
SUBTITLE: To switch the dialogue at the bottom of the screen.
TEXT: To view the teletext broadcasting program.
DISPLAY: Display current mode information.
Press to display the disc’s information in DVD mode.
LANGUAGE: To select audio language.
EPG: To show the Electronic Program Guide during no-menu state
only.
Installing Batteries
1. Open the battery compartment cover on the back of the
remote control.
2. Insert two 1.5V AA size batteries observing the polarity
markings inside the battery compartment. Don’t mix
different types or used batteries with new ones.
3. Close the cover.
Batteries shall not be exposed to excessive
- The remote control should be operated within 30 feet(7m)
and 30
0
to the left and right of the
IR receive at the front of the LCD TV.
- Used batteries should be disposed properly.
7
Loading...