Denver cat-120 Instruction Manual

INSTRUCTION MANUAL

Car Stereo

DVD/SVCD/VCD/CD/MP3/MP4 Player

with PLL FM Stereo Radio

Radio Data System

2.8 Inch TFT-LCD

SD/MMC Card Input

Slide Down/Detachable Front Panel

CAT-120

E1

BEFORE YOU BEGIN

PRECAUTIONS:

CAUTION:
USE OF CONTROLS OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE
HAZARD.

• Keep this manual handy as a reference for operating procedures and precautions.

• Always keep the volume low enough so you can hear sounds outside of the car.

• Protect this product from moisture.

• If the battery is disconnected or discharged, the preset memory will be erased and must be
reprogrammed.

FEATURES:
DVD video playback

It is possible to play back DVD video, DVD+-R, DVD+-RW and DVD+-DL.
Video CDs featuring PBC compatibility

It is possible to play back Video CDs featuring PBC (playback control).

CD playback

Music CD/CD-R/CD-RW playback is possible.

MP3 file playback

It is possible to play back MP3 files recorded on CD-ROM/CD-R/CD-RW.

MP4 file playback

It is possible to play back MP4 files.

PAL/NTSC compatibility

This unit is PAL/NTSC system compatible. When connecting other components to this unit, be
sure components are compatible with the same video system or else images will not be correctly
reproduced.

Multi-audio

You can switch between multiple audio systems recorded on a DVD as desired.

Multi-subtitle

You can switch between multiple subtitle languages recorded on a DVD as desired.

Multi-angle

You can switch between multiple viewing angles of a scene recorded on a DVD as desired.

When an operation is prohibited

When you are watching a DVD and attempt to perform an operation, it may not be performed by
the programming on the disc. When this happens, this unit indicates on the screen.

E2

2

182mm

53mm

3

4

TAP

1

2

3

INSTALLATION

PRECAUTIONS

• Choose the mounting location carefully so that the unit will not interfere with the normal
driving functions of the driver.

• Avoid installing the unit where it would be subject to high temperatures, such as from direct
sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive
vibration.

• Use only the supplied mounting hardware for a safe and secure installation.

• Be sure to remove the front panel before installing the unit.

NOTE : Inclinationangleforcarradioinstallationmustnotexceed30˚otherwisethefront

panel will not open.

NOTE: Keep the release key in the safe place as you may need it in future to remove the unit

from the car.

Detaching and attaching the front panel

The front panel of this unit can be detached in order to prevent the unit from being sto­len.

FOLDING DOWN AND DETACHING/ATTACHING THE FRONT PANEL

Before detaching the front panel, be sure to press the button(1)OFFrst.
Then press the button and detach the panel by pulling it towards you as illustrated.

Notes:

• Do not press the front panel hard against the unit when attaching it. It can be easily
attached by pressing it lightly against the unit.

• When you carry the front panel with you, put it in the supplied front panel case.

• Do not press hard or give excessive pressure to the display window of the front panel
when attaching it to the unit.

Bend these
claws, if necessay

Release screw and
bracket

1

E3

10

7

1

2

3

4

4

4

5

5

6

6

8

9

1. UNIT

2. RELEASE CASE

3. DASH BOARD

4. HEX NUT

5. LOCK WASHER

6. PLAIN WASHER

7. CAR BODY

8. REAR SUPPORT STRAP

9. TAPPING SCREW

10. M5 X 15 HEX BOLT

Dashboard

WIRE CONNECTION

IN / OUT CONNECTOR

DVD Audio Out (GRAY) Rear : White (L) Red (R)

Connect this wire to rear seat A/V monitor system to enjoy
DVD movie

Audio Out (Front): White (L) Red (R)
Audio Out (Rear): White (L) Red (R)
Audio Line In : White (L) Red (R)

CONTROL WIRE

Parking (Gray) : Connect this wire to car hand brake system
Tel mute (Black) : Connect to mobile phone unit

When receiving calls, audio sound will be muted.
Rear camera (Red) : Connect to back rear camera

During back gear condition, this wire should be connected to high voltage.

DRIVING WITHOUT VIDEO DISPLAY

Follow the installation below so when the car is in motion, no video will come out from the LCD screen.
Only sound can be heard from speaker.

Note:

- Only sound can be heard when car is in motion.

- Refer and follow your country’s law regarding driving with video.

Caution:

- Do not attempt to install it by yourself if the instruction is not clear to you. Consult you dealer concerning
the installation procedures.

TO SUPPORT THE UNIT

Video Out (Yellow) : Yellow (Plug)

Connect to external A/V system to display

Video In (Black) : Yellow (Plug)

Connect to external Video equipment

Rear camera In (Black) : Blue (Plug)

Connect to rear camera output

Steps:

1. Connect the gray wire to the hand brake system.

2. Check your hand brake switch and make sure it
is connected to car bod y c hassis and pro pe rly
grounded.

E4

To rear camera video out

To reverse gear control switch

DRIVING WITH VIDEO DISPLAY

By following the installation below, video will always be shown on LCD screen no matter the car is in
motion or not.

INSTALLING REAR CAMERA FOR PARKING/REVERSE MOTION

You can install an separate camera at the car rear end so when doing parking or reverse motion, the unit
will automatically switch the video to the rear camera to guide the driver.

CONNECTOR A

4. MEMORY +12V

5. AUTO ANTENNA OUTPUT

7. +12V (TO IGNITION KEY)

8. GROUND
NOTE: (connector A no. 7) must be connected by car
ignition key in order to avoid that car battery becomes weak
when the car will be not used for long period.

CONNECTOR B

1. REAR RIGHT SPEAKER (+)

2. REAR RIGHT SPEAKER (-)

3. FRONT RIGHT SPEAKER (+)

4. FRONT RIGHT SPEAKER (-)

5. FRONT LEFT SPEAKER (+)

6. FRONT LEFT SPEAKER (-)

7. REAR LEFT SPEAKER (+)

8. REAR LEFT SPEAKER (-)

Maintenance
FUSE REPLACEMENT

If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the
replacement, there may be an internal malfunction. In this case, consult your nearest repairing center.

Warning

Usethespeciedamperagefuseforeachlead.Useofahigheramperagefusemaycauseseriousdamage.

B

1 3 5 7

2 4 6 8

5 7

4 8

A

Steps: Connect the GRAY wire to the WHITE wire.

Steps:

1. Connect the Rear Camera IN plug to the rear camera’s

video out plug.

2. Connect the RED wire to “REVERSE” gear control switch.

3. Check your gear control switch and make sure it is

connected to +12V.