Denver CAD-375 Instruction Manual
INSTRUCTION MANUAL
CAR STEREO CD/CDR/CDRW/MP3/WMA PLAYER
WITH PLL FM STEREO RADIO
RDS
DETACHABLE FRONT PANEL
CAD-375
PTY
TA AF
BD/LD
AS/PS
MODE
MUTE
1 PAU 2 RPT 3 INT
4 RDM
5 -10 6 +10
EN-2
PTY
TA AF
BD/LD
AS/PS
MODE
MUTE
1 PAU 2 RPT 3 INT
4 RDM
5 -10 6 +10
1 18 16 177 1115109
191214 2 3 20 21 22 23 24 25136 8 5
4
(1-6)
PTY
TA AF
BD/LD
AS/PS
MODE
MUTE
1 PAU 2 RPT 3 INT
4 RDM
5 -10 6 +10
LOCATION OF PARTS AND CONTROLS
1. POWER ON/OFF ( )
2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER/
TA SEEK/PI SOUND/RETUNE/MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP
3. VOL UP/VOL DOWN FOR BASS/TREBLE/BALANCE/FADER/
TA SEEK/PI SOUND/RETUNE/MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP
4. PRESET STATIONS (1,2,3,4,5,6)
5. ‘AF’ function (ALTERNATIVE FREQUENCIES)
6. ‘TA’ function (TRAFFIC ANNOUNCEMENT)
7. ‘PTY’ function (PROGRAM TYPE)
8. DISPLAY (DISP)
9. MODE BUTTON (MODE)
10. BAND / LOUDNESS (BD/LD)
11. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN )
12. AUTO SEEK SEARCH TUNING (AS/PS)
13. ‘SCAN’ AUTOMATIC TUNING CONTROL (SCAN)
14. MUTE BUTTON (MUTE)
15. PANEL RELEASE BUTTON ( )
16. LCD DISPLAY
17. CD EJECT BUTTON ( )
18. CD SLOT
19. PAUSE BUTTON
20. REPEAT BUTTON
21. INTRO BUTTON (Preview all Tracks)
22. RANDOM BUTTON
23, 24. 10 TRACK SEARCH DOWN/UP
25. FRONT AUX IN
26. RESET BUTTON
PTY
TA AF
1 PAU 2 RPT 3 INT
4 RDM
5 -10 6 +10
191214 2 3 20 21 22 23 24 25136 8 5
4
(1-6)
26
RESET
PTY
TA AF
1 PAU 2 RPT 3 INT
4 RDM
5 -10 6 +10
EN-3
53mm
182mm
3
2
182mm
53mm
1
2
1
3
4
Bend these
claws, if necessay
release screw and
bracket
INSTALLATION
PRECAUTIONS
• Choose the mounting location carefully so that the unit will not interfere with the normal driving functions
of the driver.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or
hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Be sure to remove the front panel before installing the unit.
NOTE: Inclination angle for car radio installation must not exceed 30˚
otherwise the front panel will not open.
Note: Keep the release key in the safe place as you may need it in future to remove the unit from the car.
ISO CONNECTOR
RCA Jack Line Out: RCA Jack Line In:
Red (right) White (left) Red (right) White (left)
CONNECTOR A
4. MEMORY +12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
Note: (connector A no. 7) must be connected by car ignition key in
order to avoid that car battery becomes weak when the car will be not
used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the
replacement, there may be an internal malfunction. In this case, consult your nearest repairing center.
Warning
Use the specied amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
B
1 3 5 7
2 4 6 8
5 7
4 8
A
Loading...