DENSO TEN FT0057A User Manual

FT0057A
User manual
(1/4)
Model name
Model No
Index
1-Rating
Car Audio
FT0057A
Page
2P
3~4P
1-Rating
(2/4)
RATED VOLTAGE
LOAD IMPEDANCE
BACK UP CURRENT
RATED CURRENT
AM TUNING RANGE
FM TUNING RANGE
CD TYPE
13.2V(10.5~16.0V)-GROUND
1.0mA OR LESS
3A OR LESS (VCC=14.4V 0.5W OUTPUT)
531~1629kHz
87.5~108.0MHz
12cm IN DASH ONE DISC (8cm ADAPTER USE)
Button function spec
(3/4)
PWR・VOL
FM/AM
MENU
TEXT
PHONE
SEEK TRACK
DOWN
(∨)
SEEK TRACK UP
(∧)
FunctionButton NameButton No.
PWR Switch
Volume Control
Switching over to AM/FM
Switch to Disc/BT audio modeDISC
Switch the Setup menu
Switch to USB/iPod mode/AUXUSB
CD/USB/iPod/BT Audio TEXT Display
Dial Menu Operation Receiving a Call Disconnecting a Call
(Radio) SEEK DOWN (CD,USB) Track DOWN
(CD,USB) Fast DOWN
(Radio) SEEK UP (Other) Track UP
(Other) Fast UP
TUNE・
CONTROL
ENTER LIST
(4/4)
FunctionButton NameButton No.
ENTER
(Radio) TUNE (Other) Track change (Audio control, BROWSE) Scroll
Preset 1~6⑪~⑯
SCAN
・FCC ID: BABFT0057A ・CAUTION: Radio Frequency Radiation Exposure This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated with at least 20cm and more between the radiator and person's body (excluding extremities: hands, wrists, feet and ankles).
(Radio) Call Preset CH (Radio) Insert Preset CH
Disc eject
TRACK SCAN
・Co-location: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
・This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
・FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Loading...