Delta Electronics orporated DFBD CR220 Users manual

Bluetooth USB Dongle

Quick Installation Guide

TUFCC Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.

approved by the party responsible could void the user’s authority to operate the device.U

UProduct Introduction

The Bluetooth USB Dongle allows a computer with a USB port to communicate with other
Bluetooth-enabled devices. When used with the Bluetooth application software, it can
perform wireless network applications such as information exchange, file transfer, network
access, dial-up networking, headset, audio gateway, printer application, and so on.

UPackage Contents

- Installation CD ROM

- Bluetooth USB dongle

- Quick Installation Guide

UNotice: Any changes or modification not expressly

USystem Requirements

- IBM compatible PC with Pentium, Celeron™ processor or equivalent CPU or higher.

- RAM 64M or above

- Screen: 800*600 or above

- Display: adapter True Color 16bits or above.

- Microsoft® Windows® 98SE/ME/2000/XP

UInstallation Steps

Step 1: Uninstall previous version of BlueSoleil, IVT BSS or MiniBluelet. If a previous

version of BlueSoleil, IVT BSS or MiniBluelet has been installed, it is
recommended to uninstall it first and restart the computer before installation. You
can use uninstall tools uninstall.exe” in the installation package.

Step 2: Insert the Installation software CD into the CD-ROM of your machine.

PAGE 3415

Step 3: Launch the Setup.exe program in the installation CD ROM. In normal cases, you can

follow the instructions to finish the software installation.

Step 4: Restart the Computer. After the BlueSoleil software package is installed, you will

need to restart the computer. This is to make sure that the installed Bluetooth
Device takes effect.

Step 5: After you reboot your desktop or laptop, you can find that the BlueSoleil shortcut

icon.

is displayed on your Windows desktop.

UNote:

1.

For Windows 98 and Windows ME, the Dial-up Adapter and Windows’s component direct
cable connection and NETBEUI protocol needs to be installed to run the Dial-up Networking
profile and LAN access profile.

2. You need configure Bluetooth Network Adapter IP to run PAN profile.

3. More details on how to use IVT BlueSoleil, please refer to Online Help, User Manual and
any other support document.

4. If some system exceptions occur during the installation, please use uninstall.exe in the

installation package to remove the remains of BlueSoleil before installing again.

PAGE 3425