Delta Electronics LMWP210 User Manual

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

Wireless PC Card

User Manual

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help.

Federal Communications Commission (FCC) Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.

Wireless PC Card

TABLE OF CONTENT

INTRODUCTION .............................................................................1

CONNECT THE NETWORK PC CARD TO YOUR

NOTEBOOK PC................................................................................ 2

ARDWARE INSTALLATION

DRIVER INSTALLATION............................................................... 2

NSTALL DRIVER UNDER WINDOWS

CONFIGURATION UTILITY .......................................................30

NSTALL THE CONFIGURATION UTILITY

I C

ONFIGURE THE CONFIGURATION UTILITY

...............................................................2

XP ...........................................2

98 ............................................5

ME ..........................................9

2000 ...................................... 11

NT ......................................... 15

..........................................30

....................................33

Wireless PC Card

Introduction

The Wireless PC card helps you create a wireless network for sharing your broadband cable or DLS internet access among multiple PCs in and around your home of office. It is designed for notebook computers running Microsoft Windows 98, 2000, NT, Millennium and XP. It is 16-bit PCMCIA and 32-bit CardBus compatible and works in any available PCMCIA or CardBus slot. Its auto-sensing capability allows packet transfer in 11Mbps for maximum throughput, or speed reduction to the lower 1Mbps speed for distance or working in a noisy environment.

Features

 11 Mbps High-Speed Transfer Rate  Interoperable with IEEE 802.11b(DSSS) 2.4GHz-compliant

Equipment

 Plug-and Play Operation Provides Easy Setup  Utilizes Intersil HFA3841/HFA3842 chip sets  Advanced Power Management Features Conserve Valuable

Notebook PC Battery Life

 Direct Sequence Spread Spectrum Compatible to Prevent Lost

Connections

 Rugged Metal Design with Integrated Antenna  Wired Equivalent Privacy (WEP) 40-bit data encryption

Driver Supports Windows 98, Millennium, NT v.4, 2000 and XP

iii

Wireless PC Card

Connect the Network PC Card to Your Notebook PC

Hardware Installation

 Locate an available Type II PCMCIA slot on your notebook

computer.

 With the PCMCIA adapter’s 68-pin connector facing the

PCMCIA slot and the “Network PC Card” label facing up, slide the PCMCIA adapter completely into the PCMCIA slot.

 Insert the driver CD into your CD drive.  The Hardware Installation is complete.

Driver Installation

Install Driver Under Windows XP

1. Connect the Wireless PC card into your Notebook PC. Windows XP will automatically recognize a new Intersil PRISM_2_5_

PCMCIA_ADAPTER. Select Install the software automatically [Recommended] and click the Next button to

proceed.

Wireless PC Card

2. Windows will notify you that it has not passed Windows Logo testing to verify its compatibility with Whistler. Click the Continue Anyway button to continue.

3. Windows has now completed installing the network. Click the Finish button to continue.

Wireless PC Card

4. Click right on My computer and select properties. Select Device Manager and click on the Network adapters. You will

find the Intersil PRISM2.5 PCMCIA Adapter if it is installed successfully. The PC card adapter driver installation is finished.

Wireless PC Card

Install Driver Under Windows 98

1. Connect the Wireless PC card into your Notebook PC. Windows 98 will automatically recognize a new Intersil-PRISM 2_5 PCMCIA ADAPTER. Click the Next button to proceed.

2. Make sure Search for the best driver for your device is selected and click the Next button.

Wireless PC Card

3. Make sure the Specify a location is selected and click the Browse button. At this point, Windows will ask you to browse

for the folder. Simply select the folder in which the driver is located and click the OK button.

4. Windows is now ready to install the driver. Click the Next button to continue.

Wireless PC Card

5. Windows has now completed installing the network. Click the Finish button to continue.

6. After installing the drivers, the System Setting Change screen will show you that installation is complete. Click the Ye s button to finish.

Wireless PC Card

7. Click right on My computer and select properties. Select Device Manager and click on the Network adapters. You will

find the Intersil PRISM2.5 PCMCIA Adapter if it is installed successfully. The PC card adapter driver installation is finished.

Wireless PC Card

Install Driver Under Windows ME

1. Windows automatically recognizes a new PC Card added. Select Automatic search for a better driver [Recommended] and click the Next button to proceed.

2. Windows will notify that installing has been completed. Click the Finish button to continue.

+ 14 hidden pages