Delta Electronics LMWCF210 User Manual

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IMPORTANT NOTE:
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
Wireless CF Card
User Manual
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help.
Federal Communications Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.
Wire les s CF Car d
TABLE OF CONTENT
INTRODUCTION .............................................................................1
CONNECT THE CF CARD TO YOUR PDA.................................2
ARDWARE INSTALLATION
H
DRIVER INSTALLATION............................................................... 3
NSTALL DRIVER UNDER WINDOWS
I
CONFIGURATION UTILITY .........................................................6
LINK INFO ..................................................................................6
CONFIGURATION......................................................................6
ENCRYPTION .............................................................................7
ABOUT ........................................................................................8
...............................................................2
CE ...........................................3
Wire les s CF Car d
Introduction
The Wireless CF card helps you create a wireless network for sharing your broadband cable or DLS internet access among multiple PCs or PDAs in and around your home of office. It is designed for PDA running Win CE 3.0. Its auto-sensing capability allows packet transfer in 11Mbps for maximum throughput, or speed reduction to the lower 1Mbps speed for distance or working in a noisy environment.
Features
11 Mbps High-Speed Transfer Rate Interoperable with IEEE 802.11b(DSSS) 2.4GHz-compliant
Equipment
Plug-and Play Operation Provides Easy Setup Utilizes Intersil Prism2.5 chip sets Advanced Power Management Features Conserve Valuable
Notebook PC Battery Life
Direct Sequence Spread Spectrum Compatible to Prevent Lost
Connections
Rugged Metal Design with Integrated Antenna Wired Equivalent Privacy (WEP) 64/128-bit data encryption Driver Supports Win CE 3.0
iii
1
Loading...
+ 4 hidden pages