Delta Electronics ASD-PU-01B User Manual

4 Communication Cable (Connecting a Keypad to a ASDA-B)

Delta Part Number: ASDBCADK0001

Parameter Write Mode (Parameter settings written out to the Drive)

ASD-PU-01B

Instruction Sheet

Digital Keypad / Display

1 General Notes

This instruction sheet will be helpful in the installation and operation of Delta ASD-PU-01B. Before using the product, please read this instruction sheet to ensure correct use. You should thoroughly understand all safety precautions before proceeding with the installation and operation, and place this instruction sheet in a safe location for future reference.

If you do not understand please contact your local Delta sales representative. Please observe the following precautions:

Do not use the product in a potentially explosive environment.

Install the product in a clean and dry location free from corrosive and inflammable gases or

liquids. Please ensure all wirings are correct. Otherwise, damage, malfunction or inability may

result. Do not shake, strike, hammer or throw the product. Failure to observe this precaution or

perform improper operation may seriously damage the product or cause personal injury. Do not damage the cables or/and disassemble the product as doing this will cause electric

shock and result in serious injury or damage to the product.

2 Safety Precautions

ASD-PU-01B is the specified digital keypad / display used with Delta ASDA-B series servo drives. It is provided with 4 groups built-in memories for saving and writing drive parameters. Also, there are several special function keys: MODE, SHIFT, SET and FUNC (including fast editing, reset, parameter read & write, JOG, servo motor dynamic & static auto-tuning functions) on the keypad and can offer more flexible and convenient operation.

When connecting ASD-PU-01B and ASDBCADK0001 communication cable, if the screws are necessary, φ3*1.06*8 screws are recommended for use.

Ensure to observe the following precautions when performing unpacking check, installation, wiring and operation.

Unpacking Check and Installation

¾ Please ensure that both the digital keypad and servo drive are correctly matched. Failure to

Wiring

¾ Please pay close attention on the connectors and wire terminations. Ensure all wirings are correct

Operation

observe this precaution may cause damage, malfunction or inability. Do not install the product in a location that is outside the stated specification for the digital keypad and servo drive. Failure to observe this caution may cause fire, seriously damage the digital keypad and servo drive or cause personal injury.

and secure. Otherwise, damage, malfunction or inability may result.

Mini-Din 8-Pin

1000mm 15

5 ASD-PU-01B Display Flowchart

Monitor Mode, Parameter Mode and Parameter Setting Mode



Display Flowchart

Fast Editing Reset JOG

Title

BoxHeader

Cover

Housing

Ter mina l

Part No. Manufacturer

3071420300 DELTA

3140311100

2541-K-14PD

2541-T-G

DELTA

JAWS

Parameter Save Mode (Save parameter settings to the Keypad)

Servo Motor Dynamic Auto-tuning Servo Motor Static Auto-tuning

¾ Do not shake, strike, hammer or throw the product. Failure to observe this precaution or perform

improper operation may seriously damage the product or cause personal injury

Maintenance and Inspection

¾ Do not damage the cables. Never disassemble the product. Doing this will cause electric shock and

result in serious injury or damage to the product.

3 ASD-PU-01B Features

¾ If the user press key to exit mode, when entering

mode next time, the code of the last operation mode that the

user used last time will show on the LED display.