Page 1
© 2011 DELTA ENTERPRISE CORP.
Consumer Care:
www.deltachildrensproducts.com
Delta Children’s Products
114 West 26th Street
New York, NY 10001
Tele.212-645-9033
THIS PRODUCT IS NOT INTENDED FOR INSTITUTIONAL OR COMMERCIAL USE.
If you have any questions or missing parts, contact us. DO NOT return product parts to the store
from where it was purchased before contacting Delta Children’s Products Customer Service.
.
Make sure that all preassemble parts are tight. The appearance of your product may be different
from that pictured in this booklet.
To register your product for important safety alerts and updates to your product
please visit www.deltachildrensproducts.com
ADULT ASSEMBLY REQUIRED
DUE TO THE PRESENCE OF SMALL PARTS
DURING ASSEMBLY, KEEP OUT OF REACH OF
CHILDREN UNTIL ASSEMBLY IS COMPLETE.
READ ALL INSTRUCTIONS BEFORE
ASSEMBLY AND USE.
KEEP INSTRUCTIONS FOR FUTURE USE.
COLOR
FTY
REV
STYLE No: 73075
A
21762, APRIL 12, 2011, R1
Conforms to
ASTM F2388
Safety Standards
Page 2
2
NOTES ON ASSEMBLY:
-During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on
the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape
specified in the instructions.
-To assemble this unit you may be required to place the unit on it’s side and face. It is strongly
recommended that assembly is done on a soft, non-abrasive surface to avoid damaging the finish.
NOTES ON CARE AND MAINTENANCE:
- Do not scratch or chip the finish.
- Inspect the product periodically, contact delta children's products for replacement parts or questions.
- Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a
damp, cold basement. These extremes can cause a loss of structural integrity.
-To preserve the luster of the high quality finish on your product, it is recommended to place a doily or
felt pad under any items you place on the finish.
-Clean with a damp cloth, then a dry cloth to preserve the original luster and beauty of this fine finish.
-Do not use abrasive chemicals.
-Do not spray cleaners directly onto furniture.
-Lift slightly when moving on carpeting to prevent leg breakage.
-Use of a vaporizer near furniture will cause wood to swell and finish to peel.
NOTES ON USE:
Keep children and others safe by following these simple rules:
- Do not allow any child to play on furniture
- Do not allow climbing on any piece of furniture.
- Do not allow hanging from any piece of furniture.
- Always monitor your child’s activity when in the nursery.
WARNING: CHANGING TABLE
Fall hazard - to prevent death or serious injury, always keep child within arm’s reach.
Read all instructions before use of the changing table.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.
Inspect the changing table periodically. Do not use the changing table if it is damaged or broken.
Contact Delta Children’s Products with any questions.
Tighten all loose screws and bolts before each use.
The maximum recommended weight of the child is 30lbs for the changing table.
Use only the pad provided by Delta Children’s Products.
Page 3
PARTS: MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT.
A. LEFT SIDE x 1
3
H. TOP SHELF x 1
L. FOAM PAD x 1
C. CAP RAIL x 2
K. RESTRAINT HARNESS x 1
PART # 21760
PART # 21751
PART # 21758
PART # 21753
B. RIGHT SIDE x 1
PART # 21752
D. UPPER BACK RAIL x 1
PART # 21754
E. TOP FRONT RAIL x 1
PART # 21755
F. MIDDLE FRONT RAIL x 1
PART # 21756
G. BOTTOM RAIL x 4
PART # 21757
(WITH TWO HOLES FOR SHELF BRACE)
J. BOTTOM SHELF x 2
PART # 21759
PART # 21763
Page 4
PARTS:
4
HARDWARE KIT IS PART # 21761 FOR COLOR 615. SEE FRONT COVER.
U. SHELF BRACE x 2
T. 15mm SCREW x 4
S. NUT x 2
R. NYLON WASHER x 4
M. M6 x45 mm BOLT x 20
P. Φ4x30 mm METAL PIN x 6
M4 ALLEN WRENCH
SUPPLIED
N. M6 x20 mm BOLT x 2
Phillips Screwdriver
Pliers or Adjustable
Wrench Required
for Assembly
(not supplied)
No drills necessary. Do not
use power screwdriver.
Page 5
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 1
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
5
ATTACH (1) UPPER BACK RAIL (PART D), (1) TOP FRONT RAIL (PART E), (1) MIDDLE FRONT
RAIL (PART F) AND (4) BOTTOM RAILS (PART G) TO THE LEFT SIDE (PART A) WITH (8) M6x45mm
BOLTS (PART M) USING THE M4 ALLEN WRENCH AS SHOWN.
BE SURE THE GROOVES FACE TO THE INSIDE.
E
G
M4 ALLEN WRENCH
SUPPLIED
A
M. M6 x45 mm BOLT x 8
A. LEFT SIDE x 1
D. UPPER BACK
RAIL x 1
E. TOP FRONT RAIL x 1
F. MIDDLE FRONT RAIL x 1
G. BOTTOM RAIL x 4
(WITH TWO HOLES FOR
SHELF BRACE)
M
D
F
M
M
M
M
M
M
M
G
E
D
TOP
TOP
Page 6
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 2
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
6
LAY THE LEFT SIDE ON THE FLOOR, RAILS UP. SLIDE THE TOP SHELF (PART H) IN THE GROOVES
ON THE UPPER BACK RAIL AND MIDDLE FRONT RAIL, INTO THE GROOVE ON THE LEFT SIDE,
SLIDE (2) BOTTOM SHELVES (PART J) IN THE GROOVES ON THE BOTTOM RAILS, INTO THE
GROOVES ON THE LEFT SIDE AS SHOWN.
FROM STEP 1
H
H. TOP SHELF x 1
J. BOTTOM SHELF x 2
J
J
Page 7
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 3
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
7
FROM STEP 2
ATTACH THE RIGHT SIDE (PART B) TO THE ASSEMBLY FROM STEP 2 WITH (8) M6x45 mm
BOLTS (PART M) USING THE M4 ALLEN WRENCH AS SHOWN.
M4 ALLEN WRENCH
SUPPLIED
B
M. M6 x45 mm BOLT x 8
B. RIGHT SIDE x 1
M
M
M
M
M
M
M
M
Page 8
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 4
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
8
FROM STEP 3
ATTACH (2) SHELF BRACES (PART L) TO THE RAILS USING (4) 15mm SCREWS (PART T). TIGHTEN
WITH THE PHILLIPS SCREWDRIVER.
U. SHELF BRACE x 2
T. 15mm SCREW x 4
T
U
PHILLIPS SCREWDRIVER
(NOT SUPPLIED)
U
T
T
T
T
Page 9
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 5
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
9
FROM STEP 4
ATTACH (2) CAP RAILS (PART C) TO THE ASSEMBLY FROM STEP 4 WITH (6) Φ4x30 mm METAL
PIN (PART P) AND (4) M6x45 mm BOLTS (PART M) USING THE M4 ALLEN WRENCH AS SHOWN.
M4 ALLEN WRENCH
SUPPLIED
C
M. M6 x45 mm BOLT x 4
C. CAP RAIL x 2
P. Φ4x30 mm METAL PIN x 6
C
P
P
P
P
P
P
M
M
M
M
Page 10
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 6
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
10
FROM STEP 5
ALIGN THE HOLE IN THE END OF THE STRAP OF THE RESTRAINT HARNESS (PART K) WITH THE HOLE
IN THE TOP SHELF. INSERT (1) M6x20 mm BOLTS (PART N) THROUGH A NYLON WASHER
(PART R), THE RESTRAINT STRAP AND THE HOLE IN THE SHELF. ADD (1) NYLON WASHER
(PART R) WITH A NUT (PART S). HOLD THE NUT WITH A PLIERS OR ADJUSTABLE WRENCH.
REPEAT WITH THE OTHER SIDE OF THE STRAP AS SHOWN.
K. RESTRAINT HARNESS x 1
PLIERS OR ADJUSTABLE
WRENCH (NOT SUPPLIED)
S. NUT x 2
R. NYLON WASHER x 4
N. M6 x20 mm BOLT x 2
M4 ALLEN WRENCH
SUPPLIED
N
K
R
S
R
Page 11
SECTION 1: CHANGING TABLE ASSEMBLY
STEP 7
PARTS AND TOOLS REQUIRED TO COMPLETE STEP
11
FROM STEP 6
PLACE THE FOAM PAD (PART L) ONTO THE TOP SHELF (PART H) ON TOP OF THE ATTACHED
STRAP FROM STEP 6, BE SURE THE BUCKLE ON THE STRAP IS OVER THE PAD AS SHOWN.
L
L. FOAM PAD x 1
Page 12
SECTION 1: CHANGING TABLE ASSEMBLY
FINAL
TO FASTEN STRAP - PUTH BUCKLE SIDE TOGETHERBESURE BUCKLE IS FULLY FASTENED TO
SECURE CHILD SAFFELY
TO RELEASE PRESS BOTH TABS AND PULL APART
12
RESTRAINT HARNESS SYSTEM USE:
. PLACE THE INFANT ON THE CHANGING TABLE FOAM PAD.
. POSITION THE RESTRAINT HARNESS OVER THE MIDDLE OF THE INFANT’S
TORSO AND INSERT THE BUCKLED ENDS INTO EACH OTHER UNTIL THE LOCK
SHUT WITH A CLICK.
. GENTLY PULL THE LOOSE END OF THE STRAP TO LIGHTLY SNUG THE
RESTRAINT HARNESS AROUND THE INFANT.
MAINTENANCE
. CHECK FASTENERS PERIODICALLY FOR TIGHTNESS. DO NOT OVER TIGHTEN.
THIS MAY CAUSE DISTORTION OR BREAKAGE.
WARNING : FALL HAZARD
ALWAY KEEP CHILD WITHIN ARMS REACH.
Page 13
Warranty: This Delta Product is warranted to be free from defects for a period
of 90 days from the date of purchase under normal use. This warranty extends
only to the original retail purchaser and is valid only when supplied with proof of
purchase, or if received as a gift, when the registration is on file with Delta.
Please do not return this item to the store before contacting
us about missing parts or with any questions.
To register your product for important safety alerts and updates to
your product please visit www.deltachildrensproducts.com
To report a problem, please log on to
www.deltachildrensproducts.com and click the Consumer Care
Tab, or contact us by phone at (212) 645-9033.
In the event that you need to contact our customer service
department please have the Style Number and Lot Number available.
Use the space below to make note of those numbers. They can be
found on the label on top shelf.
Style No.:______________________
Lot No. : _______________________
Pack Date:_____________________
Date of Purchase: _____________
(you should also keep your receipt)
Consumer Care:
www.deltachildrensproducts.com
Delta Children’s Products
114 West 26th Street
New York, NY 10001
Tele.212-645-9033
Loading...