Delonghi TRRS0920T User Manual

Proudly distributed by
De’Longhi Australia Pty Limited
P.O. BOX 4540
CASULA MALL NSW 2170
Customer Service Ph: 1800 126 659
Fax: 1800 706932
e-mail: delonghi@delonghi.com.au
De’Longhi New Zealand Limited
99 Khyber Pass Road
Grafton 1023
Auckland, New Zealand
P.O. Box 58-056 Botany
MANUKAU 2163
Customer Service Ph: 0508 200 300
Fax: 0508 200 301
www.delonghi.co.nz
e-mail: delonghi@delonghi.co.nz
De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
5718510771/09.15_00
TRRS Series
OIL FILLED RADIATORS
Instructions for use
1
2
3
4
2
5
6
A
1
B
C
D
E
1
2
3
7 8
3
IMPORTANT WARNINGS Safety warnings
Danger!
Failure to observe the warning may result in life threatening injury by electric shock.
- This appliance can be used by children aged from 8 years and above and per­sons with reduced physical, sensory or mental capabilities or lack of experi­ence and knowledge if they have been given supervision or instruction con­cerning use of the appliance in a safe way and understand the hazards in­volved. Children shall not play with the appliance. Cleaning and user mainte­nance shall not be made by children without supervision.
- Children of less than 3 years should be kept away unless continuously super­vised.
- Children aged from 3 years and less than 8 years shall only switch on/o the appliance provided that it has been placed or installed in its intended nor­mal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. CAUTION
— Some parts of this product can become very hot and cause burns. Particular attention has to be giv­en where children and vulnerable people are present.
- Do not use the appliance near show­ers, bathtubs, sinks, swimming pools, etc.
- If the power cable has been damaged, it must be replaced by the manufac­turer or the technical service centre or by a qualied person so as to avoid all risks.
- ATTENTION: in order to avoid any dan­ger caused by an accidental resetting of the safety system, this appliance must not be powered through an ex­ternal timer.
Important!
Failure to observe the warning could result in injury or dam­age to the appliance.
- The appliance must not be located im­mediately below a xed socket-outlet.
- The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the heater.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING: In order to avoid overheating, never under any circumstances cover the appli­ances during operation, as this would lead to dangerous overheating.
Please note:
This symbol indicates recommendations and important infor­mation for the user.
- The appliance must not be placed immediately under a xed power socket.
- The power cord should be fully removed from the cord storage unit when in use.
- The appliance is tted with a tilt-switch which turns the appliance o if it should fall over.
To restart the appliance, simply place it upright again.
- Always use the radiator in the vertical position.
- It is normal for the appliance to make "creaking" noises when rst turned on.
- In order to eliminate the radiator’s “new” smell, set it to
maximum power for at least a few hours when used for the rst time. During this operation, the room in which the radiator is located must be ventilated.
4
- This appliance is lled with a precise quantity of oil and repairs requiring it to be opened must be carried out by the manufacturer or an authorised technical assistance centre only. In the event of oil leaks, please contact Customer Experience, see enclosed guarantee.
- As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children.
- A safety device will turn the radiator o. To reset, contact
the technical assistance service.
The appliance complies with the following EC directive:
- EEC Directive on electromagnetic compatibility (EMC) and subsequent amendments;
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take a few minutes to read these instructions. This will avoid all risks and damage to the appliance.
DESCRIPTION
(see figure on pag. 3).
A Thermostat B Switches C Timer (only in certain models) D Cord holder E Wheel
USE
Electrical connection
- Before plugging the radiator into the mains, check that the voltage of your mains electricity supply corresponds to the value V indicated on the appliance and that the socket and power line are appropriately dimensioned.
- CONNECT THE RADIATOR TO EFFICIENTLY EARTHED SOCK­ETS ONLY.
- This appliance complies with directive on electromag­netic compatibility.
and use wing nuts to x the feet to the bottom of the radi­ator between the last two elements, then t the castors to the spindles on the feet and push rmly until they click into position (g. 5-6). Pull each castor to check that it is tted correctly. In certain models, the castors are already mounted on the feet.
Important!
When in use, the radiator should always be kept vertical (wheels at the bottom, controls at the top). Any other posi­tion could be dangerous!
INSTRUCTIONS FOR USE Switching on
Turn the thermostat dial clockwise to maximum (6). Turn on both switches. The lights on the switches remain on until the room temperature reaches the set temperature, then, they will switch o. When the room reaches the required temperature, turn the dial anticlockwise slowly until you hear a click and the lights will switch o. The appliance will come on and go o automatically to main­tain the required temperature.
- button in position «MIN» = minimum power (indicator light on);
- button in position «MED» = intermediate power (indi­cator light on);
- both buttons in position «MIN» «MED» = maximum power (indicator lights on)
Using the thermostat
The thermostat operates on the basis of room temperature and not radiator temperature. Turn the thermostat dial anticlockwise towards the lower numbers to reduce the temperature; turn it clockwise to­wards the higher numbers to raise the temperature. To turn the appliance o completely, turn the thermostat to mini­mum and unplug from the mains.
Models “Easy wheel” sytem
Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint nish. Fully unfold the castors by turning them outwards (Fig.1). Turn the radiator back to its upright position.
Models without “Easy wheel” sytem
Remove the feet and the castors from the polystyrene pack­ing. Insert the threaded u-bolt as shown in gures 2, 3 and 4
Frost protection function
With the thermostat in position and the switches pressed, the appliance maintains the room at a temperature of about 5˚C, preventing freezing with minimum energy consump­tion.
HOW TO USE THE TIMER (only in certain models)
To program heating, proceed as follows (g.7):
- Look at the time on your clock or watch. If it is 10 p.m.,
5
turn the numbered timer disk clockwise until the num­ber 22 (10 p.m.) on the disk coincides with the pointer s (3) on the timer. Set the periods of time when you want the appliance to work by pushing the teeth (1) inward.
Each tooth (1) corresponds to a period of 15 minutes.
This will leave visible sectors which correspond to the periods of operation (2). When set, the radiator will operate automatically each day during the times pro­grammed (important: the radiator must always be plugged into the socket).
- To change the programming, move the teeth back into the initial position and set the new periods of operation.
- To turn the appliance o completely, as well as press the switches to the 0 position, you must also unplug it from the power outlet to avoid continued operation of the timer.
Timer override (only on some models)
If you wish to override the timer settings, push the timer switch to position I (g.8) manual (timer override). To return to timed operation push the switch back to the middle posi­tion (g.8).
NOTE: if the timer switch is at the 0 position (g. 8), the heater is o and will not operate).
MAINTENANCE
Before carrying out any operation on the radiator, unplug from the electric mains and wait for it to cool. The oil-lled electric radiator requires no particular mainte­nance. It is sucient to remove the dust with a soft, dry cloth. Never use abrasive powders or solvents. If necessary remove concentrations of dirt using a vacuum cleaner.
TECHNICAL CHARACTERISTICS
IMPORTANT: DO NOT ROTATE CLOCK DIAL COUN­TER-CLOCKWISE.
The timer is like an electric clock, and will only work when plugged into a power supply. When unplugged, the timer stops and must be later re-set.
Power supply See rating label Absorbed power
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work Be sure it is plugged in and that the elec-
trical outlet is working.
Plug into the power outlet.
Check for any obstruction.
The temperature may be set too low.
6
Remove the obstruction and let the appliance cool down. If the appliance doesn't work please contact Customer Experience.
Set the temperature to a higher position.
Loading...