Proudly distributed by
De’Longhi Australia Pty Limited
P.O. BOX 4540
CASULA MALL NSW 2170
Customer Service Ph: 1800 126 659
Fax: 1800 706932
www.delonghi.com.au
e-mail: delonghi@delonghi.com.au
De’Longhi New Zealand Limited
99 Khyber Pass Road
Grafton 1023
Auckland, New Zealand
P.O. Box 58-056 Botany
MANUKAU 2163
Customer Service Ph: 0508 200 300
Fax: 0508 200 301
www.delonghi.co.nz
e-mail: delonghi@delonghi.co.nz
De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
2101015IDL /06.16
KBA Series
KETTLE
Instructions for use
B
A
H
C
G
D
E
F
1
4
5
2
2
3
IMPORTANT WARNINGS
Safety warnings
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- Avoid spillage on the connector.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
- The appliance is exclusively for the use
of boiling water. Any other use is to be
considered inappropriate and therefore
dangerous. The manufacturer cannot
be held responsible for eventual
damage caused by inappropriate,
improper or irresponsible use and/
or for repairs made to the product by
unauthorised personnel.
- The appliance is designed and
produced for domestic use only. It is
not suitable for use in: sta kitchens
in shops, oces and other workplaces,
farm houses, hotels, motels or other
holiday accommodation, guest houses.
- This appliance can be used by children
aged 8 upwards and by persons with
reduced physical, sensory or mental
capabilities or who lack of experience
and knowledge if they are supervised
or have been given instructions
concerning use of the appliance in a
safe way and understand the hazards
involved.
Children must not play with the
appliance. Cleaning and user
maintenance must not be carried out
by children unless they are older than
8 and supervised. Keep the appliance
and its cord out of the reach of children
under 8 years of age.
- The power cable must not be replaced
by the user as this requires the use of
special tools.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualied
persons in order to avoid a hazard.
- Use the kettle only with the power
base supplied (and vice versa).
- D o not operate the kettle on an inclined
surface.
- Do not operate the kettle unless the
element is fully immersed.
- To prevent damage to the appliance do
not use alkaline cleaning agents when
cleaning, use a soft cloth and a mild
detergent.
- Do not use the appliance at altitudes
exceeding 2000m.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- Do not remove the lid while the kettle
is boiling.
- If the kettle is overlled, boiling water
may be ejected.
- The heating element surface is subject
to residual heat after use.
Please note:
This symbol indicates recommendations and important
information for the user.
- Never move the kettle while it is in use.
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- To protect against electrical hazards do not immerse the
mains lead, plug power base or kettle in water or any
other liquid. Do not use in the bathroom or near any
source of water. Do not use outdoors.
- Remove the plug from the mains socket when not in
use and before cleaning. Allow the kettle to cool before
cleaning.
3
- Do not use the kettle if you have wet hands.
- Do not store anything into the kettle.
The use of accessory attachments not recommended by
the appliance manufacturer may result in re, electric
shock or personal injury.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
- Take care when pouring - do not over-tilt the kettle as
water may enter into the switch mechanism.
- Close supervision is necessary when any appliance is
used near children.
- Do not operate this kettle if the mains lead or plug
is damaged, if the kettle malfunctions, or has been
damaged in any manner.
It must be returned to an authorised service agent for
repair or replacement in order to avoid hazard.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- Do not touch hot surfaces i.e. body or lid. Use handles or
knobs.
- Water can remain hot for a long time after boiling and
can present a scald hazard.
Keep the kettle and the mains lead away from the edge
of the work surface and out of the reach of children.
- Do not allow the mains lead to hang over the edge of
the table or work surface.
- Avoid contact with steam coming out of the spout when
pouring, and out of the lid or spout when relling.
- Never put the kettle, its base or cord near or on cooker,
hot plates or gas burners.
Please note:
This symbol indicates recommendations and important
information for the user.
- Remove the kettle from its power base before lling.
- Do not use the kettle for any purpose other than heating
water.
- De’Longhi will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
- Never use the kettle without its lid and lter (kettle may
not switch o).
- Position the kettle properly on the power base before
switching on.
This appliance conforms to EC Regulation 1935/2004
on materials and articles intended to come into contact
with food.
DESCRIPTION
A Removable lter
B Removable lid
C Kettle body
D Power-on indicator light
E 360° base with cord storage
F Plug
G ON/OFF switch
H Water level indicator
USE
Before use
- Remove all packaging from the kettle and power base.
Do not let children play with them to avoid suocation
hazard.
- Remove any labels from the outer stainless steel
surfaces.
- Remove the lter (g. 1) and wash with water (g. 2).
Refer to “Removing the scale lter”.
- Fill the kettle and boil.
- The boiled water should be discarded and the kettle
rinsed out with cold water.
- Repeat the boil and rinse steps for at least three times to
remove any manufacturing dust, etc.
- After the kettle has been rinsed out, re-t the lter (g.
3).
In use
With the specially designed power base and central
connector, you can now set the kettle on the base at any
angle, from any position.
- Release cord from storage base and adjust length by
winding around the base to give the correct cord length
to reach the plug socket to be used (g. 4).
- Do not leave loose cord hanging over the edge of work
surfaces.
Filling
- Remove the kettle from the base unit before lling.
- Open lid and ll kettle to desired level.
Do not ll with less than 0.3 litres of water to
prevent the kettle running dry while operating; misuse
of this kind will shorten the life of the element. Do not
ll with more than 1.7 litres of water (up to the
MAX level). If the kettle is overlled, there is a risk
that boiling water may be ejected causing burns.
4
Switching on
- Plug the power base into the mains socket.
- Place kettle on power base.
- Press the ON/OFF switch down (g. 5) to switch the
kettle on.
- The pilot light will switch on.
- The kettle will automatically switch o once the water
is boiled (the ON/OFF switch will click upwards and the
lights will switch o ).
- To turn the kettle o before the water boils, you may
move the ON/OFF switch up to the OFF position, or
simply lift the kettle from its base it will switch o and
the switch will return to the OFF position automatically.
Pouring
- Remove the kettle from the power base and carefully
pour out the water. Do not tilt the kettle suddenly or
pour water out at too sharp an angle.
- When you lift the kettle from the base, you may see
moisture on the top surface of the base. Condensation
on the base is perfectly normal, and should not be a
cause for alarm.
Please note: Empty the kettle after each use.
SAFETY DEVICES
1) Automatic ON/OFF switch:
Your kettle is tted with an ON/OFF switch which
automatically switches o once the water has boiled.
If the kettle has just boiled, wait a minute or so before
re-boiling the kettle. Do not attempt to hold the ON/
OFF switch in the on position or adjust the switch
mechanism.
2) Safety cut-out:
If the kettle is switched ON with too little or no water,
it is protected against damage by a safety cut-out
which will switch o the power. If this cut-out operates,
disconnect the kettle from the mains supply and leave
to cool down before relling with cold water (otherwise
the element could be damaged).
3) If kettle is lifted from base while operating (ON), it will
automatically switch o.
MAINTENANCE
Cleaning the kettle
- Allow the kettle to cool down fully and disconnect the
appliance from the mains before cleaning.
- Do not immerse the kettle or base in water.
- Use a soft dampened cloth to wipe the outside of the
kettle and dry with a soft, dry cloth.
- DO NOT use metal polish, ammable liquids or harsh
scouring agents.
- Ensure that all connectors and sockets are kept dry.
Scale
When the water is heated, the minerals in the water solidify,
making the water appear cloudy. As soon as you notice a
lm forming on the water, or, when cleaning the lter, if you
notice a lm on the walls or the element, descale the kettle
and its lter.
Scale lter
Your kettle is tted with a scale lter to prevent loose particles
of scale being poured into your beverage. This lter is both
removable and washable. You should remove and clean the
water lter when you notice any deposits being left on the
lter or if the pouring eciency is impaired.
Removing the scale lter
- Allow the kettle to cool down fully and disconnect the
appliance from the mains electrical supply. Make sure
that your hands are clean and free from soap, cream or
anything which might taint the water.
- Empty the kettle and remove the lter as shown in g.
1. Rinse under a tap whilst brushing with a soft brush
(g. 2) and replace the lter (g. 3). Filter may pose
suocation risk, do not let it unattended after
cleaning.
To clean the kettle and the scale lter
It is vital to clean and descale regularly in order to maintain
good working order. Excessive scale build-up may aect the
performance of the product and shall be avoided.
- When limescale starts forming on the heating element,
buy a suitable descaler for kettles and descale according
to the instructions given on the descaler pack.
- After descaling, boil repeatedly with fresh water and
rinse thoroughly to completely eliminate all residues of
descaler which could damage the appliance. Repeat the
boil and rinse steps for at least three times.
- If the lter requires descaling, remove and immerse in
the same descaling solution.
- Make sure electric parts are completely dry before using
the kettle.
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “
5
Loading...