DEL
MAR
Emtech La Costa Co.
www.delmarwatches.com
Tide Watch User Manual
calibre: ISA 8272
Battery Life
Notication
SETTING THE TIDE FUNCTION - central hand
1 ) Press button B for 3 seconds , release when `beep` ,
now you enter the tide setting mode
2 ) Press B again to set the state of the local tide.
* Continuous pressing on B enables rapid setting to be
performed.
* After 3 seconds without pressing on B, a beep indicates
push button B
exit from setting mode.
The tide cycle takes place over one revolution of the dial in
12 hours 25 minutes and 14 seconds. High tide corresponds
to the "12 o'clock" position and low tide corresponds to the
opposite position, hence "6 o'clock".
DEL
MAR
Emtech La Costa Co.
www.delmarwatches.com
Tide Watch User Manual
Tide amplitude and Moon phase counter
calibre: ISA 8272
Small second hand
Pushbutton
Tide amplitude and Moon phase setting
DEL
MAR
Hour hand
Tide cycle counter
Emtech La Costa Co.
Tide cycle hand
1 2 3
Pushbutton
Tide cycle setting
Date window
www.delmarwatches.com
Tide Watch User Manual
Tide amplitude and Moon phase counter
calibre: ISA 8272
SETTING THE TIME AND THE DATE
CAUTION: NEVER CORRECT DATE BETWEEN 9:00 PM AND 12:30 AM.
Hour hand
Tide cycle counter
DEL
MAR
Emtech La Costa Co.
www.delmarwatches.com
** After setting time, alway screw
back the crown by hand tightly
to keep the watch water resistant.
Tide Watch User Manual
Tide amplitude and Moon phase counter
calibre: ISA 8272
1 2 3
Tide cycle hand
SETTING THE TIME AND THE DATE
CAUTION: NEVER CORRECT DATE BETWEEN 9:00 PM AND 12:30 AM.
Hour hand
push button
SETTING THE TIDE AMPLITUDE (MOON PHASES) - COUNTER AT 10 O’CLOCK
Tide cycle counter
DEL
MAR
Emtech La Costa Co.
www.delmarwatches.com
** After setting time, alway screw
back the crown by hand tightly
to keep the watch water resistant.
Tide Watch User Manual
Tide amplitude and Moon phase counter
calibre: ISA 8272
SETTING THE TIME AND THE DATE
CAUTION: NEVER CORRECT DATE BETWEEN 9:00 PM AND 12:30 AM.
Hour hand
1 2 3
push button
A
Comment :
The moon phases hand will start with its setting time,
jumps step forward every 24 hours.
Tide cycle hand
Small second hand
Pushbutton
Tide amplitude and Moon phase setting
Time setting
1 ) Unscrew and pull crown out to Position 3.
2 ) Turn the crown to set the correct time.
*if hour hand passed 12:00 and date change
it is midnight 12:00 am, otherwise it is noon
1 2 3
Pushbutton
Tide cycle setting
12:00 pm.
3 ) Push crown back to Position 1 and screw in.
Date window
Date setting
1 ) Unscrew and pull the crown out
to position 2.
Small second hand
2 ) Turn the crown clockwise to set the date .
3 ) Push crown back to Position 1 and screw in.
Pushbutton
Tide amplitude and Moon phase setting
Time setting
1 ) Unscrew and pull crown out to Position 3.
2 ) Turn the crown to set the correct time.
*if hour hand passed 12:00 and date change
it is midnight 12:00 am, otherwise it is noon
The tide amplitude counter performs one revolution
12:00 pm.
in 29 days 12 hours and 44 minutes.
3 ) Push crown back to Position 1 and screw in.
1 ) Press button A for 3 seconds , release when `beep` ,
Date setting
now you are enter the MOON PHASES setting mode
1 ) Unscrew and pull the crown out
2 ) Press A again to set the tide amplitude corresponding
to position 2.
to the moon phase.
Small second hand
2 ) Turn the crown clockwise to set the date .
* Continuous pressing on A enables rapid setting to be
performed.
3 ) Push crown back to Position 1 and screw in.
* After 3 seconds without pressing on A, a beep indicates
exit from setting mode.
1 2 3
Pushbutton
Tide cycle setting
Date window
Pushbutton
Tide amplitude and Moon phase setting
Time setting
1 ) Unscrew and pull crown out to Position 3.
1 2 3
Minute hand
A :
Battery Life
Notication
B :
Minute hand
A :
Battery Life
Notication
B :
Minute hand
A :
Battery Life
Notication
B :
Minute hand
A :
Battery Life
Notication
Crown
Crown
Crown
Crown
P. 1
P. 2
P. 3
P. 4
SETTING THE TIDE FUNCTION - central hand
1 ) Press button B for 3 seconds , release when `beep` ,
now you enter the tide setting mode
2 ) Press B again to set the state of the local tide.
* Continuous pressing on B enables rapid setting to be
Note for Del Mar Tide Watch
The Del Mar Tide Watch approximates the tides based
push button B
Local tides can vary from the levels indicated on the
display especially in certain portions of the West Coast
performed.
* After 3 seconds without pressing on B, a beep indicates
exit from setting mode.
The tide cycle takes place over one revolution of the dial in
on average intervals and lunar cycles.
12 hours 25 minutes and 14 seconds. High tide corresponds
to the "12 o'clock" position and low tide corresponds to the
opposite position, hence "6 o'clock".
of Florida that don't have two tides per day.
For customer guidance in Tide predictions,
SETTING THE TIDE FUNCTION - central hand
http://www.tidesandcurrents.noaa.gov/curr_pred.html
• When the watch is under water or wet, never use the pushers/bezels, or set
the time. Watch case and metal bracelet should be rinsed thoroughly in fresh
water after being in salt water.
• No backward hand, or date, adjustments should not be made when the hands
read between 9:00pm and 12:30am. At these times, the gears are too close
together and such a change could cause damage.
• No hot tub/sauna. Please do not take your Del Mar watch into the Hot Tub or
SETTING THE TIDE FUNCTION - central hand
Sauna. The combination of extreme heat and water may cause your watch to
http://www.tidesandcurrents.noaa.gov/curr_pred.html
lose some of its water resistance.
• When the watch is under water or wet, never use the pushers/bezels, or set
the time. Watch case and metal bracelet should be rinsed thoroughly in fresh
water after being in salt water.
• No backward hand, or date, adjustments should not be made when the hands
read between 9:00pm and 12:30am. At these times, the gears are too close
together and such a change could cause damage.
Characteristics :
• No hot tub/sauna. Please do not take your Del Mar watch into the Hot Tub or
Tide analogical / electronic movement. Rotating stepping motors.
SETTING THE TIDE FUNCTION - central hand
Date, quick date correction.
Sauna. The combination of extreme heat and water may cause your watch to
http://www.tidesandcurrents.noaa.gov/curr_pred.html
Small second, 1 step per second.
lose some of its water resistance.
Notication end of battery life (EOL): indication by small second hand at 2:00
jumping 4 successive steps every 4 seconds.
Indication of the tide state, semi-diurnal.
Tide : The center sweep hand makes 1 revolution in 12 hours 25 minutes 14 seconds.
Tide amplitude: The small counter hand makes 1 revolution in 29 days 12 hours 44
minutes.
Movement : SWISS MADE ISA 8272
Operating temperature : 0 °C --- 50 °C
Accuracy : ± 0.5 sec/day/25 °C
Battery : SR927SW / 395
• When the watch is under water or wet, never use the pushers/bezels, or set
Battery life : approx. 39 months
the time. Watch case and metal bracelet should be rinsed thoroughly in fresh
water after being in salt water.
• No backward hand, or date, adjustments should not be made when the hands
read between 9:00pm and 12:30am. At these times, the gears are too close
we recommend using this updated web site:
The Del Mar Tide watch should never be used for navigation.
Note for Del Mar Tide Watch
The Del Mar Tide Watch approximates the tides based
push button B
Local tides can vary from the levels indicated on the
display especially in certain portions of the West Coast
1 ) Press button B for 3 seconds , release when `beep` ,
now you enter the tide setting mode
2 ) Press B again to set the state of the local tide.
* Continuous pressing on B enables rapid setting to be
performed.
* After 3 seconds without pressing on B, a beep indicates
exit from setting mode.
The tide cycle takes place over one revolution of the dial in
on average intervals and lunar cycles.
12 hours 25 minutes and 14 seconds. High tide corresponds
to the "12 o'clock" position and low tide corresponds to the
opposite position, hence "6 o'clock".
of Florida that don't have two tides per day.
For customer guidance in Tide predictions,
we recommend using this updated web site:
The Del Mar Tide watch should never be used for navigation.
Indication
Depth
200 meters/650 feet
500 meters/1650 feet
Note for Del Mar Tide Watch
1000 meters/3300 feet
The Del Mar Tide Watch approximates the tides based
push button B
Local tides can vary from the levels indicated on the
display especially in certain portions of the West Coast
1 ) Press button B for 3 seconds , release when `beep` ,
now you enter the tide setting mode
Caseback
2 ) Press B again to set the state of the local tide.
marking
200m
* Continuous pressing on B enables rapid setting to be
500m
performed.
* After 3 seconds without pressing on B, a beep indicates
exit from setting mode.
The tide cycle takes place over one revolution of the dial in
on average intervals and lunar cycles.
12 hours 25 minutes and 14 seconds. High tide corresponds
to the "12 o'clock" position and low tide corresponds to the
opposite position, hence "6 o'clock".
of Florida that don't have two tides per day.
Scuba
Diving
YES
YES
YES1000m
Water related use
Suitable for Deep Diving
Suitable for Deep Diving
Water resistant
characteristics
Suitable for normal
Scuba Diving
For customer guidance in Tide predictions,
we recommend using this updated web site:
The Del Mar Tide watch should never be used for navigation.
Indication
Depth
200 meters/650 feet
500 meters/1650 feet
Note for Del Mar Tide Watch
1000 meters/3300 feet
The Del Mar Tide Watch approximates the tides based
push button B
Local tides can vary from the levels indicated on the
display especially in certain portions of the West Coast
1 ) Press button B for 3 seconds , release when `beep` ,
now you enter the tide setting mode
Caseback
2 ) Press B again to set the state of the local tide.
marking
200m
* Continuous pressing on B enables rapid setting to be
500m
performed.
* After 3 seconds without pressing on B, a beep indicates
exit from setting mode.
The tide cycle takes place over one revolution of the dial in
on average intervals and lunar cycles.
12 hours 25 minutes and 14 seconds. High tide corresponds
to the "12 o'clock" position and low tide corresponds to the
opposite position, hence "6 o'clock".
of Florida that don't have two tides per day.
Scuba
Diving
YES
YES
YES1000m
Water related use
Suitable for Deep Diving
Suitable for Deep Diving
Water resistant
characteristics
Suitable for normal
Scuba Diving
Emtech La Costa Co.
Del Mar service dept.
1320 State Rt 9 #26
Champlain, NY 12919
SERVICE
P. 5
P. 6
P. 7
P. 8
Loading...