FCC Radiation Exposure Statement
WARNING: The radiated output power of the Dell Wireless WLAN Card devices
is far below the FCC radio frequency exposure limits. Nevertheless, the Dell
Wireless WLAN Card devices should be used in such a manner that the potential
for human contact during normal operation is minimized. To avoid the possibility
of exceeding the FCC radio frequency exposure limits, you should keep a distance
of at least 20 cm between you (or any other person in the vicinity) and the antenna
that is built into the printer. To determine the location of the antenna within your
printer, check the information posted on the general Dell support site at
http://support.dell.com.
This device has also been evaluated for and shown compliant with the FCC RF
exposure limits under portable exposure conditions (antennas are within 20 cm of a
person's body) when installed in certain specific OEM configurations. Details of the
authorized configurations can be found at http://www.fcc.gov/oet/fccid/help.html
by entering the FCC ID number on the device.
Interference Statement
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the manufacturer's instruction manual, may cause
interference with radio and television reception. This equipment has been tested and
found to comply with the limits for a Class B digital device pursuant to Part 15 of the
FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference
that may cause undesired operation.
Notice: The FCC regulations provide that changes or modifications not expressly
approved by Dell Inc. could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference with radio or
television reception, which can be determined by turning the equipment off and on, you
are encouraged to try to correct the interference by one or more of the following
measures:
• Reorient the receiving antenna.
• Relocate the system with respect to the receiver.
• Move the system away from the receiver.
• Plug the system into a different outlet so that the system and the receiver are
on different branch circuits.
If necessary, consult a representative of Dell Inc. or an experienced radio/television
technician for additional suggestions.
NOTE: This Dell Wireless WLAN Card must be installed and used in strict
accordance with the manufacturer's instructions as described in the user
documentation that comes with the product. Any other installation or use will violate
FCC Part 15 regulations. Modifications not expressly approved by Dell could void
your authority to operate the equipment.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.