de Jong Duke Virtu 70 Series, Virtu 90 Series User Manual

Virtu 70 and 90 series

Coffee machine

Users manual

Model: Virtu 70 and 90

Machine type: 9CEC…

Revision B, English

Reference: 5DUCEK20

Your supplier is:

The manufacturer of the machine is:

De Jong Duke
Postbus 190
3360 AD SLIEDRECHT
The Netherlands
Telephone [phone] www.dejongduke.nl
Fax: [phone] [e-mail]

2

Copyright © 2010, J.M. de Jong Duke automatenfabriek b.v.
All rights reserved.

Although this user manual has been put together with the utmost care, J.M. de
Jong Duke automatenfabriek b.v. accepts no liability for inaccuracies or
omissions. No liability is accepted for the consequences arising from operation of
the equipment in accordance with the information contained in these instructions.

J.M. de Jong Duke automatenfabriek b.v. reserves the right to alter specifications

at any time and without prior notification to the purchaser.

Preface

This user’s manual is valid for the machine supplied by the manufacturer,
including the options installed by the manufacturer. The manufacturer accepts no
liability for any damage resulting from incorrect or improper use of the machine,
or resulting from modifications that have not been authorised by the
manufacturer.
This manual gives instructions on the operation and maintenance of the machine.
Moreover, it gives solutions to simple malfunctions that may occur. The
instructions in some paragraphs are meant only for persons who are trained in
the operation and maintenance of the machine.
Besides this manual, a technical manual is also available. This technical manual
gives directions for solving machine malfunctions and repairing the machine. For
instructions on the installation of the machine, a separate installation manual is
available.
Always use original parts from the manufacturer when the machine needs to be
repaired.
Carefully read this instruction manual before you operate the machine.
Keep this manual in a safe place for possible later reference.
Only properly trained personnel may carry out repairs, install the machines or
transport the machines.
The manual cannot be regarded as a replacement for training and instruction, but
must be seen as an addition to the training, and as a reference work.

3

CONTENTS

1 SAFETY ............................................................................................... 4

1.1 SAFETY AND WARNINGS ........................................................................ 4

1.2 STANDARDS AND NORMS ....................................................................... 4

1.3 SAFETY RISKS .................................................................................... 4

2 DESCRIPTION OF THE MACHINE ........................................................ 5

2.1 GENERAL ......................................................................................... 5

2.2 THE FRONT OF THE MACHINE ................................................................... 5

2.3 OVERVIEW OF THE MACHINE INTERIOR ....................................................... 5

2.4 TYPE PLATE ....................................................................................... 6

1.1 TECHNICAL SPECIFICATIONS ................................................................... 6

3 BEFORE USAGE ................................................................................... 7

1.1. INSTALLATION ................................................................................... 7

1.2. OPERATION SITE................................................................................. 7

1.3. PUTTING THE MACHINE OUT OF ORDER ....................................................... 7

4 OPERATION ........................................................................................ 8

4.1 OPERATING THE MACHINE IN FREE VEND MODE .............................................. 8

4.2 OPERATING THE MACHINE IN PAY MODE ...................................................... 8

4.3 JUG DISPENSING ................................................................................ 8

5 MAINTENANCE AND FILLING ............................................................. 9

5.1 DAILY MAINTENANCE ............................................................................ 9

5.2 WEEKLY MAINTENANCE ....................................................................... 10

5.3 MONTHLY MAINTENANCE...................................................................... 11

5.4 PLACE SAFETY KEY............................................................................. 12

5.5 CLEANING CYCLE FOR COEX BREWER ....................................................... 13

5.6 FILL UP CANISTERS ............................................................................ 14

5.7 REMOVAL OF THE BREWER .................................................................... 16

5.8 INSTALL THE BREWER ......................................................................... 17

5.9 ASSEMBLING AND DISASSEMBLING THE MIXER ............................................ 18

5.10 ASSEMBLING AND DISASSEMBLING THE TEA BREWER ..................................... 22

6 FAILURE AND ERROR MESSAGES ...................................................... 23

4

1 Safety

1.1 Safety and warnings

· Keep this manual near the machine so the manual is immediately
available.

· Do not use aggressive cleaning products or abrasives to clean (parts of)
the machine.

· The water connection must conform to local regulations.

· Clean the machine with fresh hygienic water.

· The water system (boiler, pipes, etc.) may contain hot water, be careful!

· Do not shake the machine while in use.

· Do not use water in or near the machine unless the instructions contain

explicit directions to the contrary.

· Do not use a damaged machine. If in doubt, contact your supplier first.

· Damaged water connection tubes may only be repaired by trained

personnel.

· If a fault occurs, disconnect the machine from the electrical and water
supplies.

· Do not lean on the door when open.

· Do not use an extension cord.

· Use the machine only in areas where trained personnel can monitor the

operation.

1.2 Standards and norms

The machine is build according to CE norms
The machine complies with the following standards:

· Machine standard: 89/392/EEG

· EMC standard: 89/336/EEG,

The machine complies with the following norms:

· EN 292: safety of machines.

· UL and cUL 751: norm vending machines (only if sign is on type plate)

1.3 Safety risks

The important safety risks by using this machine:

- Hot drinks are dispensed from the machine; take care to avoid scalding
yourself.

- If cups or jugs are not correctly placed, the machine will spill liquid down
the front.

- The outlet of the machine may occasionally drip hot liquid even when the

machine is not in use.

5

2 Description of the machine

2.1 General

The Machine is a compact semi-automatic machine for the preparation and
vending of hot drinks. Your supplier can adjust the taste and sizes of the drinks.

2.2 The front of the machine

The machine can be operated using the operating panel on the door. By pushing
one of the selection buttons on the screen, a product choice can be made.
Before you make a choice, a cup must first be placed under the tap.

2.3 Overview of the machine interior

1. Coffee beans canister

2. Instant canisters

3. Lid

4. Door Lock

5. Mixing bowl

6. Waste bucket

7. External driptray

8. Drip tray under brewer

9. Dispensing nozzles

10. CoEx brewer system

11. Basecabinet

3 1 2 7 9 4

6

2.4 Type plate

The type plate is mounted on the inside of the machine, at the top left.
The following data are on the type plate:

· Name of manufacturer

· Serial number

· Type/model specification

· Date of construction

· Water connection

1.1 Technical specifications

Dimensions:
height 855 mm
width 465 mm
depth 530 mm

Weight (empty): +/- 55 kg

Electricity:
Mains supply: 230 Volt AC +/- 10%
Frequency: 50 Hz +/- 2%
Max. capacity: 2,4 kW

Water pressure:
Minimum: 90 kPa (0,9 bar)
Maximum: 600 kPa (6,0 bar)

Water connection: ¾ BSP connection

Sound pressure: < 70 dB(A)

Ambient temperature in use: +5°C to +40°C
Ambient temperature in storage: +10°C to +50°C

7

3 Before usage

1.1. Installation

Installation, transportation and adjustment of the machine is specialized work.
Only properly trained service personnel should carry this out.
For instructions about transportation, unpacking and installation of the machine,
see the technical manual.

1.2. Operation site

These machines may only be used indoors, in a hygienic dry room, with a
temperature between 5 and 40 degrees Celsius.
Place the machine on a flat, stable surface.

1.3. Putting the machine out of order

If the machine will not be used for a long period of time (for example during the
weekend,) it is recommended to turn off the water supply and the electricity
(pulling the plug from the socket is sufficient). This will prevent unnecessary use
of energy.

8

4 Operation

4.1 Operating the machine in free vend mode

1. Place a cup under the outlet on the cup stand.

All consumptions are dosed in the center of the cup stand except the hot
chilled water.

2. Select your desired drink.

3. Follow the instructions on the screen.

4. After pressing the start button, the machine prepares your drink and
dispenses it into the cup.

5. Your drink is ready after the beep and the message ‘ready’ is on the
screen.

4.2 Operating the machine in pay mode

In pay mode first insert the required money and continue with step 1 of the free
vend operation.

4.3 Jug dispensing

1. Move the cup stand upwards and place a jug under the outlet.

2. Press the jug button.

3. Select the drink and jug size

4. Press the start button.

5. The machine dispenses the selected drink into the jug.

6. Your drink is ready after the beep and the message ‘ready’ is on the
screen.