Deister Electronic TPU4030 User Manual

TPU 4030 PCB

User Manual

Art. #TBA m_en_tpu-4030-pcb_pro_v111115_de_bf

Content

1. Technical Data............................................................5

2. Mechanical Dimensions..............................................6

3. General Information...................................................6

4. Activating the Transponder........................................7

5. Acoustic Signal............................................................7

6. Battery Monitoring......................................................7

2 m_en_tpu-4030-pcb_pro_v111115_de_bf

Regulatory Notices

Europe

Hereby, deister electronic GmbH declares that this equipment - if used according to the
instructions - is in compliance with the essential requirements and other relevant provisions
of the RTTE Directive 1999/5/EC.

A full declaration of conformity can be requested at:

[e-mail]

Approved for use in all European countries.

FCC Warning

This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

CAUTION: Changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate this equipment.

Industry Canada

This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. Le présent appareil est
conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.

Note:

When installing the board into other devices, under no circumstances
should an electrical connection be established.

m_en_tpu-4030-pcb_pro_v111115_de_bf

3