Deister Electronic AMANTAGDA User Manual

deActivator Manual
V15/10/04
r
© Copyright 2004 by deister electronic GmbH
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of deister electronic GmbH.
deister electronic GmbH reserves the right to make changes to any and all parts of this documentation without obligation to notify any person or entity of such changes.
October 2004 LW
deister electronic GmbH Hermann-Bahlsen-Str. 11 30890 Barsinghausen Germany Telefon: +49 (0) 51 05 - 51 61 11 Telefax: +49 (0) 51 05 - 51 62 17 E-Mail: info@deister-gmbh.de Web: www.deister.com
2 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
deActivator
1. General .....................................................................4
2. Operation..................................................................4
3. Technical Data........................................................... 4
4. Mechanical Dimensions ............................................5
5. LEDs...........................................................................5
6. Battery changing....................................................... 5
3 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
r
1. General
The Amantag deActivator serve to switch off the alarm of the Prisontags. And it displays the battery condition of the transponders.
2. Operation
Put the beeping transponder on the middle of the front side of the device. After pushing the button, the yellow LED is on and the Amantag deActivator (ADA) is in operation. Now it switches off the alarm of the transponder. Besides, the LEDs display the battery condition of the transponder. If the red LED is blinking, the battery will be empty soon. If the green LED is blinking, the battery is ok. The ADA is switched off, if you release the button.
3. Technical Data
Dimensions (mm): 83 x 152 x 33 Weight: 190g Protection Type: IP65 Operating temperature: -10C°...+50C° Supply Voltage: 9V (block battery) Current consumption: ca. 120mA at 9V Operating frequency: 125kHz Reading range: up to 2cm Transponder: TPU4030
4 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
deActivator
4. Mechanical Dimensions
5. LEDs
Yellow LED: device is in operation Green LED: battery of the transponder is ok Red LED: battery of the transponder is nearly empty
6. Battery changing
For change the battery of the ADA, the small cover of the rear side has to be opened. Therefore, the two Phillips screws has to screwed off. After that, you can remove the cover and change the battery.
5 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
r
Regulatory Notices
Europe
Hereby, deister electronic GmbH declares that this equipment - if used according to the instructions - is in compliance with the essential requirements and other relevant provisions of the RTTE Directive 1999/5/EC.
A full declaration of conformity can be requested at:
info@deister-gmbh.de
Approved for use in all European countries.
User Notification
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate this equipment.
Industry Canada
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
6 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
deActivator
Notes :
7 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
r
Germany:
deister electronic GmbH Hermann-Bahlsen-Str. 11 30890 Barsinghausen Tel.: +49 (0) 51 05 - 51 61 11 Fax: +49 (0) 51 05 - 51 62 17 info@deister-gmbh.de
www.deister.com
France:
deister electronic france 101 rue Pierre Semard 92320 Chatillon Tel.: +33 (0) 1 47 - 35 78 78 Fax: +33 (0) 1 47 - 35 92 59 info.fr@deister.com
Great Britain:
deister electronic (UK) Ltd. Stapleton Way, Enterprise Park Spalding, Lincolnshire PE11 3YQ Tel.: +44 (0) 1775 - 717100 Fax: +44 (0) 1775 - 717101 info.uk@deister.com
Japan:
deister electronic Japan, LTD. Toshiba Hoshikawa Bldg. 4F 2-4 Kawabe-chô Hodogaya-ku, Yokohama-shi Kanagawa, 240-0001 Tel.: +81 (0) 45 340 1831 Fax: +81 (0) 45 340 1801
info.jp@deister.com
Americas and Caribbean:
Deister Electronics USA, Inc. 9303 Grant Avenue Manassas, VA 20110 Tel.: +1 703 - 368 2739 Fax: +1 703 - 368 9791 info.us@deister.com
8 deister electronic GmbH 30890 Barsinghausen Germany V15/10/04
Loading...