DEI Sales Polk Audio PKOMNISB1IHTTX User Manual

Important Product Information

Safety Precautions

FCC Statement POLK OMNI SB1 SOUNDBAR

1. This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,

including interference that may cause
undesired operation.

CAUTION: Any changes or modifications not expressly

Federal Communications Commission
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:

5GHz RF Device Statement

5.15~5.25GHz Band

• This device is operation in 5.15 – 5.25GHz frequency
range, then restricted in indoor use only,

• Outdoor operations in the 5150~5250MHz is prohibit.

approved by the grantee of this device
could void the user’s authority to operate
the equipment.

(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment

and receiver.

(3) Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

(4) Consult the dealer or an experienced radio/TV

technician for help.

Slave Equipment:
This device is slave equipment, the device is not radar
detection and not ad-hoc operation in the DFS band.

FCC RF Warning

This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
instructions and transmitter operating conditions for
satisfying RF exposure compliance.

Canada, Industry Canada (IC) Notices

This device complies with Industry Canada
licence-exempt RSS-210 standard(s).
Operation is subject to the following two conditions:

(1)This device may not cause interference, and

(2)This device must accept any interference, including
interference that may cause undesired operation
of the device.

Caution :

(i) the device for operation in the band 5150-5250 MHz is only
for indoor use to reduce the potential for harmful interference
to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the
bands 5250-5350 MHz and 5470-5725 MHz shall comply with
the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the band
5725-5825 MHz shall comply with the e.i.r.p. limits specified for
point-to-point and non point-to-point operation as appropriate.
(iv) Users should also be advised that high-power radars are
allocated as primary users (i.e. priority users) of the bands 5250

-5350 MHz and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.

Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm
between the radiator & your body.