DEI Headquarters DEIINKEY User Manual
The Science of Security
™
CClliiffffoorrdd
PN 904120
Compatible with the
following systems:
GGPP11000000TT ((GG55))
AArrrrooww 55 ((GG55))
PPoollaarriiss 44 ((GG44))
CCyybbeerr 22 ((GG44))
AAccee 220000 ((GG44))
AArrrrooww 33 ((GG44))
MMaattrriixx 11
MADE IN CHINA
©2005 Directed Electronics, Inc. Vista CA 92081
All rights reserved.
P/N 904120 04-05
1. IGNITION ON: Place the key into the ignition and
turn to the ON position or start the engine.
2. ENTER PIN NUMBER: Enter your PIN number
using the Plainview 2 valet switch.
Note: The Factory default PIN number is written on
the back of the system owner’s guide.
3. PRESS/HOLD/RELEASE: Immediately PRESS
and HOLD the
*
button until you hear one chirp
and the Status LED turns on, then RELEASE the
*
button.
4. PRESS/RELEASE: PRESS and RELEASE the
"blank" button once. Pause until you hear one
chirp.
5. PRESS/RELEASE: PRESS and RELEASE the
*
button once. The siren will chirp once as you push
the button.
6. TRANSMIT: Press the button on you new
transmitter. The siren will chirp once to confirm it
has received the transmission.
7. TRANSMIT AGAIN: Press the button a
second time. The siren will chirp twice to confirm it
has learned your new transmitter.
8. IGNITION OFF: Turn the ignition off and remove
the key: The alarm will chirp three times to
indicate exiting transmitter learn routine.
9. TEST TRANSMITTER: Press the button
to verify that the transmitter is operating the alarm
system.
Note: This transmitter auto-learn routine is applicable
to specific system/transmitter combinations, use the
following reference guide or consult your local Clifford
dealer for your particular application
904120 transmitter: GP1000T/Arrow 5/Arrow 3/Cyber 2
904065 transmitter: Arrow 5 /Arrow 3 / Cyber 2
904100 transmitter: Concept 100 / Concept 450/
Intelliguard 6000 / Cyber 4
904075 transmitter: All other systems
This device complies with Part 15 of FCC rules.
Operation is subject to the following conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference
received, including interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this device.
22 BBuuttttoonn,, IInn--KKeeyy RReeppllaacceemmeenntt TTrraannssmmiitttteerr
PN 904120
To program your new transmitter:
Loading...