DEI Headquarters DEI1510 User Manual

O N E - W A Y F M A U T O M A T IC/ M A N U A L
T R A N S M I SSI O N R E M O T E S T A R T E R

Model: ASRF-1510

User Guide

Designed & Engineered in Canada

Doc#: 120709 Rev:1.4 © © 2012 Directed. All Rights Reserved

WARNING!

It is the responsibility of the vehicle operator to
ensure that their vehicle is parked in a safe and
responsible manner.

1. a) Manual Transmission: When leaving the

vehicle, it is the user’s responsibility to ensure

that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in
order to avoid accidents upon remote starting.

b) Automatic Transmission: When leaving the
vehicle, it is the user’s responsibility to ensure

that the gearshift lever is in “Park” in order to

avoid accidents upon remote starting.

(Note: Make sure that the automatic vehicle
cannot start in "Drive".)

2. It is the user's responsibility to ensure that the

remote starter is disabled or put into valet mode
before servicing.

INDUSTRY CANADA USER NOTICE

Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment.

P. 2 User Guide

Table of Contents

Government regulations .................................................................................... 4

Introduction with SmartStart™ ........................................................................ 5

Using the Remote Control ................................ ................................................. 6

Vehicle Presets ................................................................................................... 7

Heater .............................................................................................................. 7

Windshield Wipers & Radio & Headlights ........................................................ 7

Arming and disarming the starter kill (if installed) .......................................... 7

Remote-Starting Your Vehicle ........................................................................... 9

Setting Your Vehicle in to Ready Mode ........................................................... 9

Remote-starting ............................................................................................. 10

Driving Off ...................................................................................................... 10

Remote Starter Features .................................................................................. 11

Remote Door Locks ....................................................................................... 11

Remote Trunk Release .................................................................................. 11

Idle Mode ....................................................................................................... 12

Valet Mode .................................................................................................... 13

Panic Mode .................................................................................................... 14

Quick LockoutTM ............................................................................................ 15

Cold Weather Mode ....................................................................................... 15

Extended Run Time ....................................................................................... 16

Disable/Enable LED flashing ......................................................................... 16

Constant output ............................................................................................. 16

Advanced Features: Installation-programmable Options ............................. 17

Ignition-controlled Door Locks ....................................................................... 17

Secure Lock ................................................................................................... 17

Safe Start ....................................................................................................... 17

Engine Run Time ........................................................................................... 18

Turbo Mode ................................................................................................... 18

“Home Valet

AUX 1 ............................................................................................................ 20

Horn Chirp Timing ......................................................................................... 20

Multi-car Operation ........................................................................................ 20

AUX 2 ............................................................................................................ 21

OEM-Style Alarm ........................................................................................... 21

Intrusion Codes via horn ................................................................................ 21

Troubleshooting Poor Transmitting Range ................................................... 22

Diagnostics – Parking Light Flash Table........................................................ 23

Battery Replacement ........................................................................................ 24

TM

” Mode .................................................................................... 19

User Guide P.3

Government regulations

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

This device complies with the Industry Canada Radio Standards Specification
RSS 210. Its use is authorized only on a no-interference, no-protection basis; in
other words, this device must not be used if it is determined that it causes
harmful interferences to services authorized by IC. In addition, the user of this
device must accept any radio interface that may be received, even if this
interference could affect the operation of the device.

Warning! Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this device.

P.4 User Guide

1

Introduction with SmartStart™

This is a state-of-the-art remote car starter system. The system is packed with

advanced features such as priority access to the driver’s door (commodity

features), the Safe Start children safety feature and SmartStart™.
SmartStart™ is a ground-breaking technology that enables your remote starter

features to be accessed by your smartphone. Features include keyless entry,
trunk release, panic, remote start/stop toggle and alarm notifications1. Note:

SmartStart™ must be professionally installed. For more information, see your

nearest authorised Directed Canada dealer.
With many advanced functions, this product will satisfy any one of your

expectations from high-end commodity and security systems, without neglecting
any standard feature commonly offered by entry-level starters.

Certain conditions apply. See your authorised Directed Canada dealer.

User Guide P.5

Using the Remote Control

LOCK:

UNLOCK: Unlocks the DOORS

TRUNK: Opens the TRUNK or

START/STOP: Remote starts or

AUX

AUX: This button serves as a

Your Remote Car Starter is equipped with a 5-button multi-channel remote

control. It can operate two independent vehicles equipped with a Remote Car

Starter (see Multi-Car Operation page 20, later in this Guide, for second-car

transmitter functions).

The functions of the transmitter are as follows:

Locks the DOORS and

arms the STARTER KILL (if

installed)..

and disarms the STARTER KILL

(if installed).

Activates the AUX 1 output if

Priority Door Access is

configured.

activates the AUX 3 output.

Note: Trunk option must be

installed.

stops the engine. Gets the system

into Cold Weather mode by

pressing the AUX button and then

pressing and holding the

START/STOP button for

3 seconds. Note: Icon may vary.

second function button.

This button allows assigning

different functions to any of the

other four buttons.

P.6 User Guide

Vehicle Presets

Heater

When leaving the vehicle it is recommended to preset the accessory controls in
preparation for the next remote start. Settings for the blower motor (fan), front
and rear, should not be left on HIGH. It is recommended to leave the settings on
LOW or MEDIUM instead.

Windshield Wipers & Radio & Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight
circuits to become energized while running under remote start. When leaving the
vehicle you must ensure that the windshield wiper and headlight switches are
OFF. Leaving the headlight switch ON on certain types of vehicles could cause
them to remain ON even after remote starter shut down, resulting in a dead
battery.

Arming and disarming the starter kill (if installed)

This added security feature will prevent the vehicle from starting with the Ignition
key when the starter kill is armed. If the system was installed with the starter kill
option, the vehicle will not be able to start with the key unless the system has
been unlocked first or put into Valet Mode (page 13).

Note: If the Starter Kill is installed, the vehicle will benefit from a protection
against starter motor damage that could occur after remote-starting the engine
should the user, by force of habit, turn the ignition key to the CRANK position.

The Starter Kill (if installed) can be configured by the installer either to Passive
Mode (so as to arm automatically) or Active Mode (so as to require the user’s
intervention for arming). By default, the Remote Car Starter is configured to
Passive Mode.

User Guide P.7

Passive mode:
To arm the Starter Kill:

 Press the button on the transmitter.

OR

 Let the Starter Kill arm automatically 1 minute (by default) or 3 minutes

(if configured this way) after the ignition is turned OFF or once the last
door is closed (if the doors are monitored).

 The LED on the antenna will flash quickly during the countdown

preceding the activation of the Starter Kill.

 Once the activation countdown expires, the LED will send a series of

quick double flashes to indicate that the Starter Kill is now armed.

To disarm the Starter Kill:

 Press the button on the transmitter.
 The Starter Kill will automatically rearm itself after 1 minute (by default)

or 3 minutes (if configured this way) if no door is left opened (if the
doors are monitored) and the ignition is not turned ON.

Active Mode:

To arm the Starter Kill:

 Press the button on the transmitter.
 The parking lights will flash once.
 The LED on the antenna will flash slowly.
 If remote door locks are installed, this will also lock the doors and arm

the OEM-style alarm (if configured).

To disarm the Starter Kill:

 Press the button on the transmitter.
 The parking lights will flash twice.
 The LED on the antenna will remain OFF.
 If remote door locks are installed, this will also unlock the doors and

disarm the OEM-style alarm (if configured).

P.8 User Guide