Defy OCEAN DRYER Owner's Manual

Owner’s
Manual

OCEAN DRYER

CONTENTS

2 Installation
3 Features
4 Loading
4 Operating Procedure
4 Drying Time
5 Drying Guide
5 Fabric Hints
6 Unsuitable Materials
7 Maintenance
7 Specifications
8 Service

www.defy.co.za

CONGRATULATIONS

You are now the proud owner of one of the finest and most modern tumble dryers that
today’s technology can produce. You and your machine are going to make a great team
together. But first it will pay if you really get to know each other. This book will tell you
all you need to know about your tumble dryer, what it will do and how to do it. Please
read all the instructions carefully before operating the machine.

INSTALLATION

Floor Standing

• Remove all packaging, plastic bag, and transit tape.

• The tumble dryer should be placed in a well ventilated area. If the Dryer is operated in a

confined space, moisture extracted from the clothing during the drying process will
condense on the walls.

• The rear of the Dryer must be free of any restrictions, especially round the fresh air grille.

Do not position the Dryer near any long curtains or drapes as these could be drawn against
the air intake grille. This would result in a much longer drying time

• Allow a 100mm. Air-gap at the rear of the Dryer for ventillation purposes.

Wall Mounted

• A wall mounting kit, Part number 061406 comprising a mounting bracket and two

cabinet spacers, is available from the nearest Defy Service Centre.

•

Electrical

• The dryer is designed to operate on a 230 volt, 50 Hz, 15 Amp, AC power supply.

• The machine should be connected to an earthed 3 pin wall socket.

• If the power-cord should ever need replacing, use only a genuine cord available from

the nearest Defy Service Centre.

The appliance must be earthed and the manufacturer and seller do not
accept responsibility for any damage due to incorrect electrical connection.

FEATURES

Indicators lights

The control panel

Timer knob

The Timer Knob

The Door

Timer knob

• Turn the knob in a clockwise direction only. If the required setting is accidentally

bypassed, do not turn the knob back but continue turning clockwise to the desired

setting.
The timer knob allows the selection of High (HOT) or Low (WARM) heat and the
duration of the drying cycle in minutes. There is an automatic 12 minute cooling down
period at the end of each drying cycle.

The Door

• To open the door, pull on the handle.

• The grill in the door can be rotated if condensation occurs on the floor in front of the

machine.

• Opening the door, during the drying cycle, will stop the machine. Closing the door will

allow the machine to complete the drying cycle.

Indicator lights

• When illuminated, these indicate the heat level selected.