Defy DGS 123, DGS 122 User Manual
PAGE
2
2
2
2
3
3
4
5
5
6
6
6
7
8
8
8
9
10
10
11
12
INDEX
Introduction.
Unpacking.
Positioning.
Electrical Installation.
Gas installation.
Gas conversion
Safety Compliance.
The control panel.
LPG gas hob
Maintenance and servicing
Fitting the burner caps.
Important safety advice.
Operating the oven.
Trays, shelf and heat shield.
Cooking guide.
Operating the grill.
Cleaning
Important Do’s and Don’ts
Problem check.
Service Centres.
Warranty
YOU CAN RELY ON DEFY
Owner’s
Manual
DGS 122
Stainless steel, Electric oven
with 4 burner gas hob.
DGS 123
www. Defy.co.za
Part Number 065 614
Page 1
White, Electric oven,
with 4 burner gas hob
Introduction.
• Congratulations on the purchase of this quality product.
• We trust that you will enjoy many years of trouble free use.
• Please read these instructions carefully before use as they will pro-
vide you with information on how to operate and care for your
stove in order that you gain the maximum benefit from it.
Unpacking.
• Please ensure that packaging material is disposed of in a responsible manner.
• Plastic bags should be cut up to prevent children playing with them and accidentally
suffocating.
• If the appliance is damaged in any way, do not use it. Report the damage to your
dealer, who will take the necessary corrective action.
• A heat shield ( used when grilling with the oven door open) is taped to the rear of
the product. This must be removed and stored for later use.
Positioning.
• Room ventilation is vital for the efficient performance of the appliance and for the
safety of the occupants in the room in which the appliance is installed.
• Cooking appliances generate considerable heat. The layout and materials of the sur-
rounding cabinets should take account of these characteristics. Surfaces of cabinets immediately adjacent to the stove should be able to withstand temperatures of up to 100
°
C without delaminating or discolouring.
• Allow an unrestricted air space of at least 150mm at the sides and 750mm above the
stove.
• The stove should be positioned on a stable and level surface.
• The two front feet may be adjusted by turning them clockwise or counter-clockwise
until the product is level and in firm contact with the floor.
Electrical installation.
This appliance must be earthed. The manufacturer and the seller do not accept
responsibility for any damage due to incorrect installation or electrical connection.
• This product has an electrically operated oven and an electrical connection for the
flame ignition system. These require a 220V-250V. 50 Hz power supply.
• The product is fitted with a 15 Amp 3 pin plug.
• Insert the plug into an earthed 15 Amp wall socket.
• The wall socket should be located where it is easily accessible but not above the stove.
• If the mains power cord is damaged, it must be replaced by a qualified electrician.
Page 2
Gas installation.
This appliance uses LPG ( Liquid Petroleum Gas) The gas bottle must be fitted
with an approved regulator. The manufacturer and the seller do not accept responsibility for any damage due to incorrect installation or gas connection.
2
REGULATOR
1
3
1. Soak the end of the plastic hose in hot water to soften it and then push the hose end
fully over the hose nozzle.
2. Secure the hose by tightening the hose clamp.
3.
In a similar fashion, secure the other end of the hose to the regulator on the gas bottle.
Caution: Never use a naked flame to check for gas leaks.
• Check for gas leaks after installation and whenever a new or re-filled gas bottle is
used for the first time.
• Ensure that the control knobs on the hob are in the OFF position.
• Open the valve on the gas bottle.
• Using a small paint brush, apply some soapy water to all the connections.
• If there is a leak, bubbles will appear.
• If this happens, close the valve on the gas bottle.
• Check and tighten the connections immediately.
• Repeat the procedure to ensure that there are no further leaks.
Gas conversion.
The hob can operate on both LPG (liquid petroleum gas) and Natural Gas ( Town gas).
Should you require that the system be converted to operate using Natural gas, please
contact the nearest Defy Service Centre.
Page 3
Safety compliance with local requirements.
Flexible hose - Not supplied.
Any hose that is used to connect the stove to the gas system shall comply with SANS
1156-2 or BS 3212.
Temporary installation.
Flexible hose connection from the gas appliance to the cylinder can be made by the user.
Ensure that pipe clamps are tightened correctly and are of good quality.
Gas cylinder - Not supplied.
For best results we recommend that gas cylinders with a minimum capacity of 19kg be
used.
Regulator - Not supplied.
A 2,8 kPa LPG gas regulator which complies with SANS 1237 must be used.
Permanent installation.
The appliance may only be installed by a Qualified Gas Fitter who is registered with the
LPGSASA. (Liquid Petroleum Gas Association of Southern Africa) All registered Gas
Fitters are issued with an identity card which carries their registration number. Make a
note of this on the back page of this book
The Gas Fitter should also provide you with a written certificate after completion of the
work. Failure to comply with the above will render the warranty invalid.
Before the installer hands over the installed appliance be sure that you fully understand:
a) The position of the isolation or shut-off valve in the gas supply line to the appliance.
b) The requirements for safe operation of the appliance
Note.This appliance is supplied ex-factory with jets and air settings for use with
LPG gas only.
Installers details to be filled in below
INSTALLERS NAME. INSTALLERS REGISTRATION
NUMBER.
HAVE YOU RECEIVED A
WRITTEN CERTIFICATE?
Page 4
Loading...