DEFY C410 PREMIUM Owner's Manual
Owner's Manual
For C410 Premium Frost
Free
Refrigerator Freezer
INDEX.
2 Introduction.
2 Unpacking.
2 Installation.
2 Electrical installation.
3 Reversing the doors.
4 About this refrigerator.
5 Feature diagram
6 Using the refrigerator
6 Control panel
7 Food storage tips.
7 Caution.
8 Care and cleaning.
8 Replacing a faulty lamp bulb.
8 Owner’s responsibility.
9 Service
9 Service Centres.
10 Warranty
You can re ly on Defy
Page 1
www.defy.co.za
Introduction.
Congratulations on the purchase of this quality product.
Please read these instructions carefully before use. They will provide you with information on how to operate and care for your refrigerator in order that you gain the maximum benefit from it and enjoy many years of trouble free use.
Unpacking.
• Please ensure that packaging material is disposed of in a responsible manner.
• Cardboard and foam packaging may be re cycled
• Plastic bags should be cut up to prevent children playing with them and accidentally
suffocating.
• If the appliance is damaged in any way, do not use it. Report the damage to your
dealer, who will take the necessary corrective action.
Installation.
1. The refrigerator should be positioned in a dry, well aired place.
2. Position the refrigerator away from heat sources such as stoves and direct sunlight.
3. Allow an air-space of at least 50mm above the refrigerator for ventilation purposes.
4. If the floor beneath the refrigerator is uneven, the refrigerator must be levelled by turning the two adjustable levelling feet at the front of the unit either in or out.
5. The refrigerator should lean slightly backwards as this will ensure that the doors close
properly.
1 2 3 4 5
Electrical installation.
This appliance must be earthed and the manufacturer and the seller do not accept
responsibility for any damage due to incorrect electrical connection.
This product may not be used with a battery inverter power supply.
• Wait at least two hours after delivery before connecting the refrigerator
to the mains power supply. This will allow the compressor and system
fluids to settle .
• The refrigerator is fitted with a 15 A moulded plug and uses a 220-
250V/50 Hz power supply.
• Insert the plug into an earthed 15A wall socket and switch on the
power.
Page 2
Reversing the doors ……..if required.
• Should the refrigerator be located
where door opening from the left is
difficult or inconvenient, access may
be improved by reversing the doors
so that they open from the opposite
end.
• This operation is best performed by
two persons.
• Follow the steps sequentially 1 to 17
as shown in the three illustrations.
1. Remove the hinge cover and hinge.
Unplug the control panel wiring harness
2. Remove upper door.
3. Remove hinge
4. Remove lower door.
5. Remove kick panel.
6. Remove hinge
7. Reverse the position of the upper
hinge bush.
8. Move the upper left door handle to
the lower right handle position and
reverse the plastic plugs
9. Reverse the position of the lower
hinge bush.
10. Move the lower left door handle to
the upper right handle position and
reverse the plastic plugs.
11. Attach the lower hinge at the left.
12. Position the lower door on the hinge.
13. Reverse the position of the middle
hinge and cap the screw holes.
14. Position the upper door.
15. Fit the upper hinge pin into the upper
door bush, reconnect the control
panel wiring harness and attach the
hinge to the top left of the cabinet.
16. Reverse the position of the hinge
cover
17. Replace the kick panel.
Page 3
Loading...