Define Instruments TEX-CTR10 Specifications

Page 1
This simple and a ordable counter/ rate indicator is ideal for indicating totalisation and monitoring rates.
Compatible with a wide range of sensors
NPN, PNP, T
Rate or totaliser display
Easy to use
Intuitiv
Signal averaging on the rate
educes noise and optimises stable
R measurement
Programmable front panel shortcut button
High speed mode available
or when input signal exceeds 10kHz
F
TL, namur, tacho or closed contact
e interface with scrolling text prompts
TEX-CTR10
Counter/Rate Indicator
Simple to calibrate using Pulses/Unit of measurement
Optional 4–20mA or 0–10V analog output
Optional RS232/RS485 serial port
Speci cations
Sensor types NPN (default), PNP, TTL, namur, tacho or closed contact
Input 0–24V DC, 0–30V AC
Input frequency Counter: 100kHz max; Rate:
10kHz max (100kHz max in high speed mode)
Display 1 x 6 digit (13mm), 14 segment alphanu­meric LED. 5 buttons
Panel mount case 48H x 96W x 120D (mm)
Analog output (Optional) 1 x isolated 16 bit
4–20mA/0–10V. Window programmable over any range within the full scale range of the controller
Serial port (Optional) Isolated RS232 (RJ11) or RS485 (screw terminal). Custom ASCII / Modbus RTU slave / Ranger A
Excitation 24V DC (50mA max)
Sampling rate Counter: 10msec; Rate: 100msec
Rate resolution 0.01Hz (1Hz in high speed mode)
Rate accuracy 0.005% of reading
Rate temperature dri 2ppm/°C typical
Security Input setup is PIN protected
Order code: TEX-CTR10
-HV 85–265V AC / 95–370V DC
-LV 15–48V AC / 10–72V DC
Options
-A 1 x mA/V analog output
-S2R 1 x RS232 serial (RJ11)
-S4S 1 x RS485 serial (screw terminal)
E.g. Order TEX-CTR10 -LV, TEX-CTR10 -A-S2R-HV
Noise  ltering 0.2kHz, 2kHz, 20kHz or o
Minimum pulse width Must be greater than 5μs
Copyright © 2013 De ne Instruments Ltd PM-DS-13V01/11 (1112)
TEX-CTR10
10B Vega Pl, Mairangi Bay, Auckland 0632, NZ Ph +64 (9) 835-1550 PO Box 245 Westpark Village, Auckland 0661, NZ Fax +64 (9) 835-1250
www.de neinstruments.com Email sales@de neinstruments.com
Loading...