DefenderWorx REAR LOUVERS User Manual

H2PPC05020 REAR LOUVERS

INSTALLATION INSTRUCTIONS

Open the tailgate. Remove the torques head screws holding the stock louver in place. Remove the
screws holding the taillight assembly in place (this is to allow space to remove the original vent
clips). Pull the original vents loose from the vehicle; there is a clip at top and bottom. If the clip
stays in the white body receptacle, remove it. You can replace the rear light assemblies and

reinstall the screws. Now carefully put new chrome vent in place, holding it firmly up against the

vehicle, reinstall the two screws and tighten. Repeat for both vents. Close the tailgate.

Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
[phone] Phone
[phone] FAX

www.defenderworx.com