DefenderWorx INTERIOR TRIM RINGS User Manual

H2PDC05103 / H2PPC05103 INTERIOR TRIM RINGS

INSTALLATION INSTRUCTIONS

There are three different sizes of rings in the kit. The three large thick rings go in the following
positions: driver left vent, two center vents. The one large thin ring goes on the passenger side
vent. The two small rings go on the back side of the center console.
Rings are supplied with double backed automotive adhesive strips. The correct side of the tape is

important. The white side goes against the rings and the brownish side goes toward the vehicle’s

surface. Lay out the rings and determine the placement of the adhesive and be sure that they will
fit the rings. There can be 3-5 pieces for each ring. The adhesive will straddle the inside radius and
should be placed so that the adhesive is not visible when in place. Once you have determined
where you are going to put them it is time to peel and stick. Peel off the white side and place the
adhesive on the parts, firmly pressing it to conform to the inside shape of the rings.
If your rings have decorative dimples it is important to place them on each vent with the correct
orientation so that they all match. Once that decision is made, then peel off the brownish adhesive
cover and place the vent in position, be sure it is centered directly on the vent before pressing into
place. Apply firm even pressure around the ring to set it into place.

Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
[phone] Phone
[phone] FAX

www.defenderworx.com