DefenderWorx BUMPER LETTERS User Manual

BUMPER LETTER INSERT

INSTALLATION INSTRUCTIONS

Use an alcohol pad to clean the surface of the letters and plastic bumper where the tape will be
applied. Make sure all surfaces are smooth and dry before applying letters. Apply 3M Adhesion
promoter to the surface of the bumper where the letters will be applied. Allow surface to dry for 5
minutes. Remove the plastic film from the back of the letter you will be applying and then apply

letter to bumper and press firmly. Do not wash or allow the bumper to get wet for at least 48

hours.

NOTE; Do not allow the 3M Adhesion Promoter to get on any surface other than where the
letters will be placed.

Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
[phone] Phone
[phone] FAX

www.defenderworx.com