Deep Sea Electronics Plc DSE890, DSE891 Installation Instructions Manual

D E E P S E A E LE CTRO N I CS
D S E 8 90 / D S E 8 9 1 GA T E W AY
®
I N S T A L L A T IO N I N S TR U C T I O N S
ISSUE
3.1
The DSEGateway® communicates to the connected controller(s) monitoring the instrumentation and operating state. If the data changes, the new data is logged in the Gateway’s memory. At regular intervals the logged data is transmitted to the DSEWebNet host server via ethernet (DSE890 / DSE891) or GPRS 2G/3G (DSE890 only, SIM card not supplied by DSE). Additionally, DSE890 contains a GPS location receiver. For more detailed information please refer to the Operating manual and Software manuals listed below.
SETUP
You may wish to consult your company IT department before making changes to your PC network settings.
Connect the DSEGateway
®
ethernet port directly to your PC Ethernet port. You can use either a ‘straight through’ or ‘crossover’ network cable.
Set the PC IP address as shown.
Using Google Chrome, Microsoft Internet Explorer or Mozilla Firefox, enter the IP address of the gateway.
Enter the username and password of the Gateway.
NOTE:- Username and Password are
both CASE SENSITIVE.
For further details refer to the following DSE publications available from our website : www.deepseaplc.com
057-165 DSE890/DSE891 WebNet Gateway Manual 057-168 DSEWebNet Software Manual
Factory Settings
IP Address Username Password
192.168.1.100 Admin Password1234
Deep Sea Electronics Plc.
Tel:+44 (0)1723 890099
Fax: +44 (0)1723 893303
Email: support@deepseaplc.com
Web: www.deepseaplc.com
Deep Sea Electronics Inc.
Tel: +1 (815) 316-8706
Fax: +1 (815) 316- 8708
TOLL FREE (USA only) :
Telephone: +1 866 636 9703
Email: support@deepseausa.com
Web: www.deepseausa.com
LED STATUS
DIMENSIONS
Overall size 85 mm x 149 mm x 51 mm
(3.35” x 5.85” x 2.01”)
Mounting type DIN rail or chassis mounting
Indoor Use Only Din rail type EN 50022 35mm type only Mounting holes M4 clearance Mounting hole centres
73 mm x 137 mm
(2.89” x 5.39”) Maximum Ambient Operating Temperature
50ºC
(122ºF)
TYPICAL WIRING DIAGRAM
0.51 Nm (4.5 lb in)
TO MEET UL APPROVALS,
PLEASE USE A
UL LISTED LIMITED POWER SUPPLY (8V DC -36V DC)
Loading...