easy-to-assemble FOUNDATION
Easy Adjust Instructions
Twin and Twin XL
Step 1.
and lay them out on the oor.
Step 2.
six support braces with preinstalled wing nuts.
Enjoy your new adjustable frame!
FOUNDATION ASSEMBLY INSTRUCTIONS for Twin & Twin XL
Take components out of the box
Unfold the frame, lay on side and attach
Step 4. Flip the base over to stand upright.
Step 5. Install the metal guard to prevent the mattress
from slipping o the edge of the frame.
Step 3. Tighten the wing nut until secure. Repeat the same
process for all six legs, making sure all wing
nuts are tightly secured.
easy-to-assemble FOUNDATION
Easy Adjust Instructions
Full, Full XL, Queen, King
FOUNDATION ASSEMBLY INSTRUCTIONS
Step 1. Take all components out of the box
and lay them out on the oor.
Step 2. Unfold each frame piece, lay on side and attach
six support braces with preinstalled wing nuts.
for Full, Queen, King and Cal King
Step 5. Install the two screws with spacers on the LOWER frame
so both sides are connected and tight.
Step 6. Install one screw with spacers on the UPPER frame
so both sides raise together.
Note. If you want to use the frame as two separate TXL's,
do not install this screw.
Step 3. Tighten the wing nut until secure. Repeat the same
process for all six legs, making sure all wing
nuts are tightly secured.
Step 4. Flip the base over to stand upright.
Place both frame halves side by side.
Position frames so inside holes line up.
Step 6. Install the two metal guards to prevent the mattress
from slipping o the edge of the frame.
Loading...