Deco Lighting DWH-LED Installation Instructions Manual
INSTALLATION INSTRUCTIONS
DWH-LED
Industrial/Vapor Tight LED
IMPORTANT SAFETY INSTRUCTIONS
1. Read carefully before installing fixture. Retain for future reference.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
2. Failure to follow instructions may result in serious injury or death.
3. Upon receipt the fixture, thoroughly inspect for any freight damage which should be brought to the attention of
the delivery carrier. Compare the catalog description listed on the package slip with the fixture label on the housing to
assure you have received material.
4. This fixture must be wired in accordance with the international electrical code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe the correct grounding procedure
under installation section.
5. DECO luminaires may be damaged if connected to conduit systems containing water - Article 300-5G of National
Electric Code requires that “Conduits or raceways through which moisture may contact energized live parts shall be
sealed or plugged at either or both ends”.
*Deco Lighting assumes no responsibility for claims arising out of improper or careless handling or installation of this product.
General Wiring Diagram
Electrical Connection
1. Connect BLACK (line) driver lead to voltage supply Line position
(HOT).
2. Connect driver WHITE lead to the NEUTRAL supply position.
3. Connect the GREEN ground lead to the supply ground lead.
If using 0-10V dimming:
4. Connect VIOLET lead to supply POSITIVE dimming lead.
5. Connect GREY lead to the supply NEGATIVE dimming lead.
If NOT using 0-10V dimming:
6. Ensure VIOLET and GREY 0-10V dimming leads are properly
capped.
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
2917 Vail Ave.Commerce, CA 90040
•
800-613-3326 • info@getdeco.com • www.getdeco.com
1
INSTALLATION INSTRUCTIONS
Industrial/Vapor Tight LED
Installation:
Exploded View for Reference
DWH-LED
*1 set of (2) mounting brackets are included per 4’ section
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
2
2917 Vail Ave.Commerce, CA 90040
•
800-613-3326 • info@getdeco.com • www.getdeco.com
Loading...