to prevent injury as a result of a traffic accident.
injury as a result of a traffic accident.
MADE IN USA
MADE IN USA
▼ READ BEFORE YOU INSTALL DECKED ▼
DON’T use power tools to assemble or install the DECKED system. Impact wrenches and other power tools
can over tighten and damage components (aside from drilling drain holes in ammo cans).
DON’T over tighten J-hooks during installation. J-hooks need to be snug to keep system from moving
around, but should NOT be cranked down.
DON’T over torque any bolts, particularly the bolts attaching the center vert to the deck halves.
REAR ammo cans have flat bottoms; FRONT ammo cans are narrow at the bottom.
NOTE: You will need a buddy with exactly two steps.
Need Help? Watch our detailed installation video or give us a call. We’re happy to help!
1) If your cargo van has the wood laminate floor in the cargo area, you do not need to install the
shims. If you do not have the wood flooring in your van, you will need to install the shims to
provide adequate support for the front and rear ammo cans and vert.
3) Using the information in the respective circular detail views on the next page:
a) Clean the surfaces where the shims will be located.
b) Remove the layer of tape on the bottom of the shim to expose the adhesive surface.
c) Place the shim and apply with pressure.
NOTE: Step B is to be repeated on the passenger side.
REAR
FRONT
B
C
17” GAP
A
PREPARE VAN: INSTALL SHIMS DETAILED
VIEW
DETAIL A
Place shim in center depressed floor bead. Make sure Shim is
9 7/8" from rear edge of depressed floor bead. Place the next
shim 17” directly in front of this shim.
FRONT
OF VAN
9 7/8” GAP
➡
DETAIL B
Center shim between the 2 floor beads. Front of shim
extended 1 7/8” from floor beads. Repeat on
passenger side.
FRONT
OF VAN
➡
1 7/8”
FRONT
OF VAN
➡
2 1/2”
DETAIL C
Place shim in center of depressed floor bead. Front of
shim extends 2 1/2”from floor beads.
2 1/2”
Loading...
+ 10 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.