DCS WDS-27, WDS-30, WDI User Manual
The Professional Warming Drawer
Use and Care Guide
MODELS:
WDS-27
WDS-30
WDI
1
A MESSAGE TO OUR CUSTOMERS
Thank you for selecting this DCS Warming Drawer. Because of its unique features, we have
developed this Use and Care Guide. It contains valuable information on how to properly operate
and maintain your new Warming Drawer for years of safe and enjoyable use.
To help serve you better, please fill out and submit your Ownership Registration Card by visiting our
website at www.dcsappliances.com and selecting “Customer Service” on the home page and then select
“Ownership Registration”. You may also submit the enclosed Ownership Registration Card by mail to the
address below. In addition, keep this guide handy,as it will help answer questions that may arise as you
use your new DCS Warming Drawer.
For your convenience, product questions can be answered by a DCS Customer Service Representative by
phone: 1-888-281-5698,email: support@dcsappliances.com, or by mail:
WAR NI NG
The warming drawer is not intended to be used in conjunction with
water. DO NOT fill the drawer or warming cavity with water. Doing so
could create a shock hazard resulting in a possible injury.
WAR NI NG
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
WAR MI NG DRAWER GREASE FIRE,OBSERVE THE FOLLOWING: SMOTHER
FLAMES with a close-fitting lid, cookie sheet,or metal tray,then turn off
the Warming Drawer. BE CAREFUL TO PREVENT BURNS. If the flames do
not go out immediately EVACUATE AND CALL THE FIRE DEPARTMENT.
NEVER PICK UP A FLAMING PAN - You may be burned. DO NOT USE WATER,
including wet dishcloths or towels - a violent steam explosion will result. U
se an extinguisher ONLY if:
1.You know you have a Class ABC extinguisher, and you already know
how to operate it.
2.The fire is small and contained in the area where it started.
3.The fire department is being called.
4.You can fight the fire with your back to an exit.
WAR NI NG
DO NOT use water on grease fires. Turn OFF the warming drawer, then
smother the fire with baking soda or use a dry chemical or foam-type fire
extinguisher.
PLEASE RETAIN THIS MANUAL
FOR FUTURE REFERENCE.
DCS
Attention: Customer Service
5800 Skylab Road
Huntington Beach, CA 92647
TABLE OF CONTENTS
2
SAFETY PRACTICES & PRECAUTIONS...........................................................................................................3-4
USE AND CARE INFORMATION ..........................................................................................................................5-8
Operational Guide...................................................................................................................................................5
Cleaning the Warming Drawer...........................................................................................................................6
Removing the Drawer............................................................................................................................................7
Replacing the Drawer............................................................................................................................................8
SUGGESTED TEMPERATURE SETTINGS TO KEEP FOODS HOT......................................................9
SERVICE ..................................................................................................................................................................................10
WAR RANT Y..........................................................................................................................................................................11
SAFETY PRACTICES & PRECAUTIONS
3
READ AND UNDERSTAND THESE PRECAUTIONS
Read this Use and Care Manual thoroughly before using your new appliance. This will help to
reduce the risk of fire,electric shock, or injury to persons.
Remove all packaging materials from your appliance. If the installer has not set up your
appliance, do it now.
Install according to instructions. To insure proper installation and servicing, follow the instal-
lation guide which came with this appliance.
Be sure to have a qualified service technician install and ground this appliance.
Plug into rated outlet: 120 Volts AC, 5 amp minimum circuit requirement.
PREHEATING INSTRUCTIONS
The Warming Drawer is designed to keep cooked foods warm for extended periods of time. The
drawer must be pre-heated before use (see chart on Operational Guide, page 5). If the warming
drawer isn’t pre-heated, the internal temperature of the food being warmed could fall below the
minimum safe level and bacteria could develop. Always preheat the drawer according to the
instructions described in the warming drawer use section of this manual.
Children should not be left alone or unattended in an area where appliances are in use. They
should never be allowed to turn knobs,push buttons, sit or stand on any part of an appliance.
Children in walkers,or children crawling can be attracted to the round door handle and may
grab and open the warming drawer. This can result in injury from the door being pulled open
on a child, or severe burns if it is in use and hot.
WAR NING
Do not store items of interest to children in,above or around any
appliance. Children could be seriously injured if they should climb onto
the appliance to reach these items.
Be certain to use only dry pot holders: Moist or damp pot holders on hot surfaces may cause
burns from steam. Do not use a towel or other bulky cloth in place of pot holders.
Never store anything in the warming drawer. Flammable materials can catch fire, plastic
items may melt or ignite and other types of items could be ruined.
Do not hang articles from any part of the appliance or place anything against the drawer.
Some fabrics are quite flammable and could catch on fire.
For safety reasons and to avoid damage to the appliance, never sit, stand, or lean on the
warming drawer door.
For personal safety,wear proper apparel. Loose fitting garments or hanging sleeves should
never be worn while using this appliance. Some synthetic fabrics are highly flammable and
should not be worn while using this appliance.
Do not use aluminum foil to line any part of the warming drawer. Using a foil liner could
result in a fire hazard, or the obstruction of the flow of heat and ventilation air. Foil is an
excellent heat insulator and heat will be trapped underneath it. This trapped heat can upset
the performance of the warming drawer parts.
WAR NI NG
This appliance is designed for warming food. Based on safety
consider ations,never use the warming drawer to warm or heat a room.
SAFETY PRACTICES & PRECAUTIONS
4
As with any cooking or heating appliance,never leave the warming drawer unattended when
warming food,this could be a fire hazard.
Only certain types of glass, heat proof glass-ceramic, ceramic, earthenware or glazes are
suitable for use in this warming drawer. Utensils that are not thermally heat safe may break
with sudden temperature changes.
Never heat unopened containers,a build up of pressure may cause the container to burst.
120 volt AC,5 amp minimum circuit required.
Grease is flammable, avoid letting grease deposits collect in the warming drawer, clean up
spillage.
DO NOT use water on grease fires. Turn OFF the warming drawer, then smother the fire with
baking soda or use a dry chemical or foam-type fire extinguisher.
When opening the drawer while keeping sauces warm, tomato sauce, etc., the drawer must
be opened slowly to avoid spillage.
Use care when opening a hot warming drawer; to avoid severe burns,open slowly, allow the
hot air or steam to escape before reaching in to remove or replace any foods.
Do not repair or replace any part of this appliance unless it is specifically recommended in
this manual. All other servicing should be referred to a qualified Service Technician. Service
Technicians must disconnect the power supply before servicing this appliance.
When using the warming drawer: DO NOT TOUCH THE INTERIOR SURFACES or the exterior
area immediately surrounding the door until it has had sufficient time to cool to avoid burn
injuries.
Clean the warming drawer with caution. Avoid steam burns;do not use a wet sponge or cloth
to clean the appliance while it is hot. Some cleaners produce noxious fumes if applied to a
hot surface. Follow directions provided by the cleaner manufacturer.
Be sure all the controls are turned off and the appliance is cool before using any type of
aerosol cleaner on or around the appliance. The chemical that produces the spraying action
could, in the presence of heat, ignite or cause metal parts to corrode.
Do not touch the heating element or interior surfaces of the warming drawer, even if they
appear dark in color. They may still be hot enough to cause burn injury, allow sufficient time
to cool.
Do not allow flammable materials which may ignite to come in contact with the hot heating
element or the interior surface of the warming drawer until the unit has had a sufficient time
to cool.
WAR MING DRAWER FEATURES
Moist/
Crisp
Knob
Power
Indicator
Lens
Thermostat
Control
Knob
Stainless
Steel
Tray
Power
Indicator
Light
Stainless
Steel
Drawer
*
* Moist/crisp feature not
available on fully integrated
model (WDI).
5
USE & CARE INFORMATION
OPERATIONAL GUIDE
The Warming Drawer is designed to keep previously
cooked foods at a safe, warm temperature, for
extended periods of time, when operated correctly.
It is not designed to cook or reheat food. The
Warming Drawer should be pre-heated according to
the chart below prior to inserting the food to be
warmed. Food may be kept up to two hours in the
warming drawer. Failure to pre-heat could result in
unsafe food temperatures,which could accelerate
the formation of bacteria in the food being kept
warm. The dial on the top right corner of the unit is
the on/off and temperature control adjustment.
When the dial is turned clockwise from the off position to the proof position, the unit will maintain a
temperature of approximately 100°F. By rotating the
dial clockwise to the high position, the drawer will reach a temperature of approximately 230°F.
To Use: Tu rn the thermostat dial to a temperature setting;
High Medium Low Proofing
If you will be using the tray, preheat it while preheating the warming drawer.
Preheat any empty serving dishes to be used, while preheating the drawer.
Add cooked, hot food in its cooking container or heat-safe container.
Aluminum foil may be used to cover food containers.
CAUTION
Do not use plastic containers or plastic wrap. They can melt if in direct
contact with the drawer or a hot utensil and if these items melt, they may
adhere to the drawer and may be unremovable. Use only heat-safe dishes.
PREHEAT TIME AND TEMPERATURE SELECTOR:
Proofing.....Do not preheat 90°-110°
Low..............Preheat 10 min. 140°-170°
Medium ....Preheat 15 min. 170°-200°
High............Preheat 20 min. 200°-230°
Always preheat on high,then turn the knob to the desired setting.
To k eep several different foods hot together, set the temperature to the food needing the
highest setting. Place items needing highest setting on the bottom of the drawer and food
needing less heat on the tray.
PROOFING YEAST DOUGH
Place dough in a greased jelly roll or half sheet pan or oiled bowl, no taller than five inches in
height. Turn dough over to grease all areas of the dough, cover with a damp clean cloth. Place in
the center of warming drawer and turn the control knob to LOW and immediately back to PROOF.
Check at 45 minutes to one hour. Dough should double in size. Shape dough,place in baking
pan, and put in warming drawer for second rising,about 30 to 45 minutes; add extra time if
needed.
Fig. 07
6
USE & CARE INFORMATION
CLEANING THE WARMING DRAWER
Be careful cleaning any part of this appliance, particularly the drawer box and back of the
drawer face. All parts of the drawer can be cleaned with a hot soapy damp cloth, rinsed,dried
and buffed with a heavy pile cloth. Always try this first, as it is the mildest cleaning procedure.
Be sure the Warming Drawer is turned off and the appliance is cool before using any type of
aerosol cleaner on or around the appliance. The chemical that produces the spraying action
could, in the presence of heat, ignite or cause metal parts to corrode.
Use the mildest cleaning procedure first. Some brands of cleaners are harsher than others,
read their directions. Try on a small area first.
To avoid marring the surface always rub the metal finishes in the direction of the polish grain
lines. The cleaner will be more effective when used in the direction of the polish lines.
Use only clean sponges,soft cloths, paper towels, plastic or non-metal soap pads for cleaning
or scouring, as recommended in this section. (Caution: some soap pads can scratch).
Be sure to rinse all parts thoroughly and to wipe dry to avoid water marks.
Remove food particles after every used.
1) Drawer:Clean the drawer with warm soapy damp sponge or cloth.
2) Drawer Front: Shine with stainless steel cleaner in direction of grain.
3) Gasket: Clean with warm soapy damp sponge (care should be taken when cleaning the gasket
because silicon is tough until it is cut, at which time it will tear very easily).
4) Knobs: The on/off temperature knob may be removed to be cleaned (See Fig. 07).The moist/crisp
knob, however, should never be removed. Be aware that the pull off force will decrease and a
loose knob could become a choking hazard for small children. Should the knob come off, use
DCS cement (part number 14178) to re-attach the knob.
5) Light: Clean with damp cloth or sponge.
6) Drawer cavity: Same as Drawer above.
7) Element: Care should be taken when cleaning the heating element. Only clean the element
when the unit is cool. Use warm soapy water on damp cloth.
8) Stainless Steel tray: Can be removed and cleaned with hot soapy water at sink.
7
USE & CARE INFORMATION
REMOVING THE DRAWER
Be sure the drawer is cool and no food items or trays are in the drawer. Never attempt to remove
the drawer while the unit is on or warm.
1) To r emove the drawer,first remove plates, trays, etc., from the drawer.
2) Pull the drawer open towards you all the way until it reaches the stop position (Fig. 8).
3) Lift up on the handle while pressing the plastic locking tip on both sides and pulling the drawer
towards you.The drawer will ride on the side holders and can be lifted up to be fully removed
(see Fig.9 and 10).
4) A strike is located at the center back of the drawer (fig. 11).The catch, which is in the inside of the
warming drawer, grabs and holds the strike to keep the door shut tightly.
Fig. 08
Fig. 09
Fig. 10
Fig. 11
Loading...