Summer 2008 33
Dual Side Burner/Griddle Dimensions
(with optional grill cart)
Dual Side Burner/Griddle Model: BFG-30BGD
Cart Model: CAD-30 (shown with optional side shelves)
Dual Side Burner/Griddle
Island Preparation
D
ual Side Burner/Griddle Model: BFG-30BGD
W
e encourage you to find out mor
e about these featur
es and lear
n how they
can make your cooking experience more enjoyable by visiting our learning
page at: www
.dcsappliances.com.
Because of continuing product improvement these specifications are subject
to change without notice.
MODEL NUMBER
BFG-30BGD
GRIDDLE 12,000 BTU/HR
SIDE BURNERS 2 @ 17,000 BTU/HR
SHIPPING WEIGHT
(SIDE BURNER/GRIDDLE HEAD) 120 LBS.
SHIPPING WEIGHT
(OPTIONAL CART) 120 LBS.
SHIPPING DIMENSIONS
Ordering Data:
Please specify gas type (natural or propane) when ordering
Gas Requirements:
Natural
• 1/2" NPT male with a 3/8" flare adapter
• Operational Pressure: 4” W.C.
• Supply Pressure: 6" to 9” W.C.
Propane
• 1/2" NPT male with a 3/8" flar
e adapter
• LP hose with a quick disconnect & fitting are shipped
connected
• Operational Pressure: 11” W.C.
• Supply Pressure: 11" to 14” W.C.
Power Requirements:
• 9V battery
Island Ventilation Requirements:
It is recommended that adequate ventilation holes must be
provided in the base of an enclosure in the event of a gas leak.
Side burner/Griddle Placement:
DO NOT build side burner/griddle under overhead unprotected
combustible constr
uction. Use only in well-ventilated ar
eas.
These units are for outdoor use only. If located in a consistently
windy area (oceanfront, mountaintop, etc.) a wind break will be
r
equir
ed.
Conversion Kits:
NG to LP and LP to NG conversion kits ar
e available from your
dealer
.
Accessories
• Stainless Steel Grill Car
t (CAD-30)
• Single or double side bur
ners for built-in application
• Stainless Steel Access Doors for built-in application
• Stainless Steel Access Drawers for built-in application
• Insulated Jacket for built-in application
• Brazilian Cherry Chopping Board that fits in cart optional
side-shelf
• V
inyl Grill Cover
• Wok and Wok Ring for use on side burners
access doors
(
ADN20x30)
access drawer
(
ADR30)
V
ent
#
4
” x 4” opening for
g
as supply line
3” to non-combustible
construction and
12” min. combustible
construction
* Standard cut-out dimensions for non-combustible enclosure
** Insulated jacket cut-out dimensions for combustible enclosure
# Island installation to use minimum of 3 vents providing
10 square inches per vent (typical)
Vent
#
V
ent
#
32” X 32” X 16”
(SIDE BURNER/GRIDDLE HEAD) (HEIGHT X WIDTH X DEPTH)