DB Drive EUPHORIA T265, EUPHORIA T490, EUPHORIA T4125, EUPHORIA M350, EUPHORIA T465 User Manual
...
EUPHORIA
2
2
EUPHORIA
EUPHORIA
Two
EUPHORIA
AMPLIFIER MODELS
T265
:
T465
:
T490
:
T4125
:
M350
:
M500
:
M1000
:
M2000
USER MANUAL
Installation Instructions / Owners Manual
Due to continous improvement of the product the
specifications are subject to change without notice.
INTRODUCTION
SAFETY PRECAUTIONS
KEEP YOUR SALES RECEIPT
RECOMMENDATION
Low Impedance Stability
For added low frequency performance the Multi Channel amplifiers are equipped with a
bass boost @ 45Hz
The “EUPHORIA ” amplifiers include built-in variable crossovers. The crossover features
a variable frequency selection for precise low pass filtering for all mono amplifiers. The
Multi-channel feature independent 12dB per octave High Pass and Low Pass X-Over
Network.
T265 - 2 Ohm Stereo (2 Channel)
F465 - 2 Ohm Stereo (4 Channel)
F490 - 2 Ohm Stereo (4 Channel)
F4125 - 2 Ohm Stereo (4 Channel)
M350 - 2 Ohm Mono
M500 - 1 Ohm Mono
M1000 - 1 Ohm Mono
M2000 - 1 Ohm Mono
selectable 6dB-12dB
The Mono amplifiers feature a variable 0 - 18db boost set @ 45Hz
Tri - Plex Status Indicator
A Tri-Plex LED status indicator will indicate the operational status of the amplifier.
A blue power LED indicates the power is on and operating normal. To aid in setting up
the amplifier a CLIP LED , will be off during normal operation. When the amplifier is over
driven into a soft clip it will light up orange , this is the normal safe limit of operation of
signal. When the amplifiers signal goes into a dangerous hard clip the Clip LED will turn
red. A red protection LED indicates that the internal protection circuit has been activated.
The protect LED will remain off at all other times
FEATURES AND BENEFITS
Multi-Link
The Euphoria M500, M1000 and M2000 have an internal linking circuit that allows you
to link two like model amplifiers so that you can double your output power to a single load.
When linking two like amplifiers they are split up into master and slave units. The master
amplifier becomes the main control for all input signals and gain controls.
Ground Remote +12V
Fuse
Speaker Output
Power Output
+ +
-
-
MOUNTING LOCATION POWER CONNECTIONS
Bass Boost
Remote
0dB 18dB 10Hz 40Hz 40Hz
M350
CLASS A/B MONOBLOCK
300Hz Min Max
R R
LL
Subsonic Lowpass
Gain
OUTPUT INPUTX-Over Controls
LP/BP 12dBStereo
Mode
HP 12dB
High Pass
Channel 1 & 2 Over Co ntrols
Min MaxMin Max
HPFull
5KHz
20Hz
Gain
F465
Ch 3 Ch 3 Ch 1
Ch 2
INPUT
X-OVER
INPUT
High
Pass
Channel 3 & 4 X-Over Con trols
Low
Pass
Bass
Boost Gain
OUTPUT
Ch 4Ch 4
20Hz 1KHz 50Hz
5KHz 0dB 12dB
LP/BP Mono 24dB
4 CHANNEL AMPLIFIER
Ground Remote +12V
Fuse
Speaker Output
Power Output
+ +
-
-
M350 - 2 ohm stable
M500 - 1 ohm stable
M1000 - 1 ohm stable
M2000 - 1 ohm stable
M350 - 2 ohm stable
M500 - 1 ohm stable
M1000 - 1 ohm stable
M2000 - 1 ohm stable
Ground Remote +12V
Fuse
Speaker Output
Power Output
+ +
-
-
SIGNAL CONNECTIONS SPEAKER CONNECTIONS
Multi - Channel
SPEAKER CONNECTIONS Multi-Link
REMOTE BASS CONTROL MODULE
Ch 1
Ch 2
Ch 3
Ch 4
Bridged
Bridged
+
+++
-
- -
-
Fuse
Ground R emote +12V
Speaker Output
PowerOutput
Ch 1
Ch 2
Ch 3
Ch 4
Bridged
Bridged
+
+++
-
- -
-
Fuse
Ground R emote +12V
Speaker Output
PowerOutput
REMOTEBRIDGED
SLAVE
Min Max
15Hz
40Hz 50Hz 150Hz
0dB 18dB
180
0
MASTER
DATALINK
GAIN
SUBSONIC
LOWPASS
BASSBOOST
R
R
LL
OUTPUT INPUT
REMOTEBRIDGED
SLAVE
Min Max
15Hz
40Hz 50Hz 150Hz
0dB 18dB
180
0
MASTER
DATALINK
GAIN
SUBSONIC
LOWPASS
BASSBOOST
R
R
LL
OUTPUT INPUT
REMOTEBRIDGED
SLAVE
Min Max
15Hz
40Hz 50Hz 150Hz
0dB 18dB
180
0
MASTER
DATALINK
GAIN
SUBSONIC
LOWPASS
BASSBOOST
R
R
LL
OUTPUT INPUT
M500 M1000 M2000
POWER INPUT
OUTPUTSPEAKER
+
12V
+ +
- -
REM GND
POWER INPUT
OUTPUTSPEAKER
+
12V
+ +
- -
REM GND
2 Ohm Minimum
Master
Slave
Master
Slave
The Euphoria M500, M1000 and M2000 have an internal linking circuit that allows
you to link two like model amplifiers so that you can double your output power to a
single load. When linking two like amplifiers they are split up into master and slave
units. The master amplifier becomes the main control for all input signals and gain
controls.
network that allows you to select the crossover mode (Highpass—Full Range) and desired
crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a
Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /
Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4
out the high frequencies with a 24db slope. You will then need to adjust the Lowpass
control to the desired frequency setting (make sure to have the H ighpass control set to
switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both
any unwanted low frequencies with a 12db slope.
The M350 , M500, M1000 and M2000 are equipped with a variable 24db slope
feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it
may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer
subwoofer enclosure. M500, M1000 and M2000 are equipped with Multi-Linking technology.
When using a single Linkable amp set the Master / Slave switch to the Master position.
the slave setting the front panel controls become inoperative. All adjustments for both
( T265, F465, F490, F4125)
Built-in Crossover
( M350 , M500, M100 M2000 )
T265 , F465, F490 and F4125
LP/BP 12dBStereo
Mode
HP 12dB
High Pass
Channel 1 & 2 Ove r Cont rols
Min MaxMin Max
HPFull
5KHz
20Hz
Gain
F465
Ch 3 Ch 3 Ch 1
Ch 2
INPUT
X-OVER
INPUT
High
Pass
Channel 3 & 4 X-Over Cont rols
Low
Pass
Bass
Boost Gain
OUTPUT
Ch 4Ch 4
20Hz 1KHz 50Hz
5KHz 0dB 12dB
LP/BP Mono 24dB
4 CHANNEL AMPLIFIER
Euphoria
Euphoria
ADJUSTMENTS AND SETTINGS ADJUSTMENTS AND SETTINGS
FINE TUNE THE SYSTEM
Peak @ 14.4V :
2ohm
Frequency Resp.
S/N Ra
o (A-weight)
THD with 80k filter
Low Input Level
Crossover Freq.
Bass EQ
Bass Remote Capability
Input Voltage
M350
1 x 350W
N/A
20Hz - 350Hz
<0.4%
50Hz - 350Hz
0dB - 18dB @ 45Hz
Yes
11.2V - 14.4V
M500
1 x 250W
1 x 500W
20Hz - 150Hz
<0.4%
50Hz - 150Hz
0dB - 18dB @ 45Hz
Yes
11.2V - 14.4V
M1000
1 x 500W
1 x 1000W
20Hz - 150Hz
<0.4%
50Hz - 150Hz
0dB - 18dB @ 45Hz
Yes
11.2V - 14.4V
1ohm
Dimensions Height WidthLength
T265
2.16in/55mm 8.66in/220mm7.87in/200mm
F465
2.16in/55mm 8.66in/220mm12.51in/318mm
F490
2.16in/55mm 8.66in/220mm14.84in/368mm
F4125
2.16in/55mmm 8.66in/220mm16.49in/368mm
M350
2.16in/55mm 8.66in/220mm12.51in/318mm
M500
2.16in/55mm 8.66in/220mm10.53in/255mm
Peak @ 14.4V :
4 ohms
4 ohms bridged
Frequency Re
sp.
S/N Ra
o (A-weight)
THD with 80k filter
Low Input Level
High Pass Filter
Bass EQ
Bass Remote Capability
Input Voltage
Low Pass Filter
T265
2 x 65W
1 x 250W
18Hz - 22KHz
>10 dB
<0.4%
250mV - 6 V
20Hz - 5KHz
50Hz - 5KHz
6dB - 12dB @ 45Hz
11.2V - 14.4V
2 x 85W
F465
4 x 85W
2 x 250 W
<0.5%
20Hz - 5KHz
50Hz - 5KHz
6dB - 12dB @ 45Hz
11.2V - 14.4V
4 x 65W
F490
4 x 125W
2 x 350W
<0.5%
20Hz - 5KHz
6dB - 12dB @ 45Hz
11.2V - 14.4V
4 x 90W
2 ohms
0 >10 dB0 >10 dB0
.5
250mV - 6 V
.5
250mV - 6 V
.5
50Hz - 5KHz
18Hz - 22KHz 18Hz - 22KHz
F4125
4 x 195W
2 x 400W
<0.5%
20Hz - 5KHz
6dB - 12dB @ 45Hz
11.2V - 14.4V
4 x 125W
>10 dB0
250mV - 6 V
.5
50Hz - 5KHz
18Hz - 22KHz
M2000
1 x 1000W
1 x 2000W
20Hz - 150Hz
<0.4%
50Hz - 150Hz
0dB - 18dB @ 45Hz
Yes
11.2V - 14.4V
>10 dB0 >10 dB0 >10 dB0 >10 dB0
250mV - 6 V
.5
250mV - 6 V
.5
250mV - 6 V
.5
250mV - 6 V
.5
Crossover Slope
12dB 24dB 24dB 24dB
Subsonic Filter Range
10Hz - 40Hz
15Hz - 40Hz
15Hz - 40Hz 15Hz - 40Hz
M1000
2.16in/55mm 8.66in/220mm11.25in/286mm
M2000
2.16in/55mm 8.66in/220mm17.36in/441mm
TROUBLE SHOOTING THE SYSTEM SPECIFICATIONS
Loading...