DaytonAudio WAVE-LINK WLS User Manual

WAVE-LINK WLS
2.4 GHZ WIRELESS AUDIO SYSTEM
Model: WAVE-LINK WLS User Manual
Introduction
Installation of a subwoofer or second audio zone can be next to impossible in a finished home. Lack of access from below or above the room limits your ability to run the required cables from the A/V receiver to your subwoofer or speakers.
The Dayton Audio Wave-Link™ Wireless Audio System easily solves your wiring dilemma. Place your subwoofer in the position that provides optimal sound. Or, add a subwoofer to the rear of your listening space to spread out the low frequency effects of your favorite movies.
The stereo capability of the Dayton Audio Wave-Link Wireless Audio System extends the options and uses of your primary audio system. Use the Wave-Link to add speakers to your patio, around your pool, or anywhere you’d like to enjoy music. Connect the Wave-Link to your PC and stream music from an Internet source or your music library to your main audio system.
Connection
The Dayton Audio Wave-Link Wireless Audio System includes all of the accessories you need for monaural or stereo installations. The 3.5 mm to RCA cables are used for mono applications such as connecting a subwoofer. The
3.5 mm to dual RCA cables are used for stereo applications such as adding rear speakers to your system.
System Includes
• 1 x Transmitter
• 1 x Receiver
• 2 x 3.5 mm to single RCA
• 2 x 3.5 mm to dual RCA
• 2 x 3.5 mm to 3.5 mm cables
• 2 x 5 VDC power adapter
Operation
Select the cable needed for your application; single RCA for subwoofer / monaural, dual RCA for rear speakers / stereo, or dual 3.5 mm / stereo.
Connect your cable to the line output from your source device, and the 3.5 mm plug into the transmitter line input.
Connect your second cable to the line input of your subwoofer, powered speakers, or remote amplifier, and the 3.5 mm plug into the receiver line output.
Connect a USB power adapter to both the transmitter and receiver. Plug the USB power adapters into a 120 VAC outlet.
The transmitter and receiver are paired at the factory. If the two become un-paired, press the transmitter and receiver pair button simultaneously.
When both units
have a steady blue light, they are paired.
USB DAC Operation (source select)
The transmitter is equiped with a DAC for transmitting digital media wirelessly to the receiver. Plug transmitter in to your PC/Laptop (Mac or Windows) and press the pair button once to switch from Analog input to the DAC mode. Press the pair button again to switch from DAC to Analog input.
Loading...
+ 2 hidden pages