Page 1
3" CUBE SPEAKER PAIR
Models: SAT3B / SAT3W
Thank you for purchasing the Dayton Audio®
SAT3 satellite speakers. Available in two
colors, the SAT3 speakers can be installed
anywhere to provide discreet, detailed sound
reproduction as part of a compact home
theater or multi-room audio system that
virtually disappears.
Package Contents
(2) Dayton Audio SAT3B (black) or SAT3W
•
(white) cube speakers
(2) Adjustable surface mounting brackets
•
Installation
To begin, select two locations about 8 feet
apart (for stereo installation), or two locations
that will provide diffuse surround audio (for
use in a home theater). If wall-mounting is
desired, first install the back plate of the
mounting bracket to the wall using wood
screws or drywall anchors as needed to
support the weight of the speaker. Assemble
the wall mounting bracket by sliding the round
threaded collar over the ball, threaded stud,
and safety wire, then screw the threaded
stud into the threaded insert in the rear of the
cube speaker enclosure. Screw the threaded
collar onto the socket on the back plate of the
mounting bracket, and tighten the collar using
the included torque bar as necessary
for the speaker to maintain its adjusted angle.
Note: When the speaker will be mounted
overhead, the safety wire should be used.
Secure the free end of the safety wire to one
of the mounting points for the surface mounting
bracket, or use a separate screw and washer
to provide an additional mounting point.
Once the speakers are installed or placed in
their final locations, connect the speaker wire
to the terminals. Connect the red or striped
wire to the red terminal, and the black or
unmarked wire to the black terminal, and be
careful to observe the same polarity at the
receiver or amplifier.
Enjoyment
To make the best use of your speakers, point
them directly at your listening position, and
adjust the volume setting of your receiver or
amplifier to the desired output level. If the
output is distorted, reduce the volume. If a
subwoofer is used, adjust its built-in crossover
setting for the best possible sonic blend.
Specifications
Model Number SAT3B (Black), SAT3W (White)
Driver 2-3/4" Extended Range
Power Handling RMS/Peak (W) 10/20
Frequency Response (Hz) 130-20,000
Impedance (ohms) 8
SPL 1W/1m (dB) 83
Dimensions H x W x D (in) 3-2/5" x 3-2/5" x 4-2/5"
Dimensions with Mounting Bracket H x W x D (in) 3-2/5" x 3-2/5" x 6-1/4"
Weight (lb) 2.0
5-Year Warranty
See daytonaudio.com for details
daytonaudio.com
tel + 937.743.8248
info@daytonaudio.com
705 Pleasant Valley Dr.
Springboro, OH 45066
USA
© Dayton Audio
Last Revised: 4/18/2017
®
Loading...