Dayton TT25-16 User Manual

Using TT25-16 (16 ohm PUCK™)

m

Typical wiring configuration:

16 ohm

• Use standard wire nuts to join wires.

• If possible, always pre-wire prior to permanent mounting.

• Verify and match the impedan

in the diagram above.

• Should you have any questions regarding wiring or installation,

contact your place of purchase.

ce of any receiver/amplifier shown

TT25-16

Overview: The Dayton Audio PUCK™ is a small tactile transducer intended

to be used in Home Theater, Gaming, and Auto Sound applications. It's
unique ability to transfer low frequency sound waves directly to the listener is
achieved by mounting the PUCK™ to surface areas that a listener's body will
come into contact with. Because the listener "feels" the low frequency, the
volume of the overall sound can be kept to a minimum without sacrificing the
audio quality.

Mounting: The PUCK™ is designed to nest into a 70mm hole (with notch
area for wiring). Please use the template below for a suggested hole cut.

NOTE: Wiring information is found on the back of this sheet.

Hole Template

Notch

Area

25 mm

12 mm

70 m

WARRANTY

The Dayton Audio TT25-16 is warranted free from defects in material and
workmanship for one year from date of purchase. Warranty does not apply
to misuse, neglect, accident, or improper use.

© Dayton Audio daytonaudio.com TT25-16

Use 6 #6 Wood or Sheet Metal Screws to mount on surface