Dayton SAT3W User Manual

SAT3

Cube Speaker Pair

Models: SAT3B / SAT3W

User Manual

www.daytonaudio.com

Designed and Engineered in USA

Thank you for purchasing the Dayton Audio® SAT3 satellite speakers. Available in two colors,
the SAT3 speakers can be installed anywhere to provide discreet, detailed sound reproduc­tion as part of a compact home theater or multi-room audio system that virtually disappears.

Package Contents

● (2) Dayton Audio SAT3B (black) or SAT3W (white) cube speakers

● (2) Adjustable surface mounting brackets

Installation

To begin, select two locations about 8 feet apart (for stereo installation), or two locations
that will provide diffuse surround audio (for use in a home theater). If wall-mounting is
desired, first install the back plate of the mounting bracket to the wall using wood screws
or drywall anchors as needed to support the weight of the speaker. Assemble the wall
mounting bracket by sliding the round threaded collar over the ball, threaded stud, and
safety wire, then screw the threaded stud into the threaded insert in the rear of the cube
speaker enclosure. Screw the threaded collar onto the socket on the back plate of the
mounting bracket, and tighten the collar using the included torque bar as necessary for
the speaker to maintain its adjusted angle.

Note: When the speaker will be mounted overhead, the safety wire should be used. Se-
cure the free end of the safety wire to one of the mounting points for the surface mounting
bracket, or use a separate screw and washer to provide an additional mounting point.

Once the speakers are installed or placed in their final locations, connect the speaker
wire to the terminals. Connect the red or striped wire to the red terminal, and the black or
unmarked wire to the black terminal, and be careful to observe the same polarity at the
receiver or amplifier.

Enjoyment

To make the best use of your speakers, point them directly at your listening position, and
adjust the volume setting of your receiver or amplifier to the desired output level. If the
output is distorted, reduce the volume. If a subwoofer is used, adjust its built-in crossover
setting for the best possible sonic blend.

Dayton Audio® products are constructed by industry experts, and are thoroughly tested before shipment. Dayton Audio
products are warranted for the period of one year. This warranty is limited to manufacturer defects, either in materials
or workmanship. Dayton Audio is not responsible for any consequential on inconsequential damage to any other unit
or component or the cost for installation or extraction of any component of the audio system. In the rare case of a
product failure, please contact your place of purchase or call our Customer Support Department at [phone].

There are no other warranties, either express or implied, which extend the foregoing, and there are no warranties of
merchantability or fitness for any particular purpose. The warranty will not cover incidental or consequential damage
due to defective or improper use of products.

This warranty gives you specific legal rights and you may also have other rights which vary from state to state.

Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company for repair/replacement,
transportation prepaid, by calling [phone] for details, complete instructions, and service fee charges.

Warranty Information

Warranty Limitations

Designed and Engineered in USA

• PO Box 636 • Springboro, OH • 45066 • daytonaudio.com

SAT3 Last Revised: 10/28/2013

© Dayton Audio

®